anko 1506-05 Travel Portacot Instruction Manual

Anko 1506-05 Travel Portacot Instruction

IMPORTANT

BEFORE ASSEMBLING THIS COT READ AND UNDERSTAND THE INSTRUCTIONS. Do not use mattress other than the one supplied by the manufacturer. Incorrect mattress can cause death.
Use only accessories as recommended by the manufacturer.
Ensure the top rails and base are fully locked.
Stop using this cot if any part of the cot is broken, torn or missing.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.

WARNING:
RETAIN FOR FUTURE REFERENCE.
READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE OF THIS COT ALWAYS FOLLOW THE INSTRUCTIONS.
THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS ESSENTIAL.
WARNING

• USE ONLY THE MATTRESS SUPPLIED BY THE MANUFACTURER, INCORRECT MATTRESSES CAN CAUSE DEATH.
• Use only accessories as recommended by the supplier.
• Ensure the top rails and base are fully locked.
• Do not use this cot if any part of the cot is broken. torn or missing.
• Keep children away while assembling/disassembling the cot.
• Do not leave anything on the foldlng cot (such as toys) that provide a foothold.
• Do not use the folding cot near-naked heat sources, bar heaters, open fires or exposed flames.
• Do not place more than one child in the cot at the same time.
• Do not use this cot wlth a child who can climb out, weighs more than 15kg, or is taller than 890mm.
• Keep the folding cot clear of traillng cables and hanging cords.
• Keep medication and small items that a child could choke on, away from the cot.
• Check that the assembly!d of the cot is correct and safe.
• Check that all locking devices are full!:J engaged.
• Folding cots with padded rlms should not be used lf the covering material has been bitten through.
• There is potential for fingers or parts of the bod!d to be injured when the product is being folded or unfolded, and due care should be exercised.
• Take care when unpacking and during assembly!:J.
• Dispose of all packing materials carefully!:J after assemble!:J.
• Regular!:J checks that all fittings remain tight. Tighten lf required.
• Inspect the product before assemble!:J and periodicals!:J during use. Never use this product if there ls an!:J loose or missing fasteners, joints or broken parts.
• Be aware of the risk of open fires and other sources of strong heat. such as electric bar fires, gas fires, etc. in the near vicinity!d of the cot.
• An!:J additional or replacement parts should onl!:J be obtained from the manufacturer or distributor.
• Never substitute parts.

PARTS LIST

1. Carry Bag
2. 1-Cot
3. 1-Mattress

TO OPEN THE COT

WARNING
THESE STEPS WILL ENSURE lHAT lHE COT IS CORRECTLY OPENED AND READY TO USE.

1. Unzip and remove the carr!d bag.
2. Remove mattress b!J unfastening the hook & loop straps, and take out the portacot.

Separate the legs of cot.

TO OPEN THE COT – CONTINUED

CAUTION: TAl<E CARE,
AS FINGER PINCHING CAN OCCUR IN THE CORNER WHEN LOCKING THE RAILS IN PLACE.

Starting with long rails pull them up with both hands quicklbl until thebJ are locked into place.
Repeat above step for the short rails.
NOTE: All the top rails should be locl<ed in place. If they are not, release them and try again. The centre of the cot base must be in a raised position to allow the roils to lock. Check for the secure engagement of the rails by pushing down on them.
Push the centre folding lever downwards until it  locks into place.
Place the mattress into the cot with its padded side facing up. 

Secure the mattress to the cot by fixing the hook & loop fasteners under the mattress onto the cot base.
NOTE: Always secure the mattress before using the cot.

TO FOLD THE COT

THESE STEPS MUST BE FOLLOWED IN THIS ORDER TO EASILY FOLD THE COT.

Remove the mattress by unfastening the hook & loop straps from the cot.
Pull the centre folding lever upwards.
Release each top rail bbl lifting the rail slightly and pressing the buttons located on the centre joint of rail  IF THE TOP RAILS DO NOT FOLD, DO NOT FORCE THEM – LIFT THE BASE HIGHER AND PRESS THE BUTTONS TO FULLY RELEASE THEM.

TO FOLD THE COT – CONTINUED

Ensure each rail is full: released, then pull the centre folding lever up until it is full!d folded.
Place the cot in the mattress with padded side facing inwards.
Cover the folded cot with mattress b!d fastening the hook & loop straps.
Place the folded cot with mattress ln carr!: bag and zip it up. 

Care and maintenance

• All assembly fittings are to be tightened properlbJ. Inspect regularlbJ and re-tighten as necessary.
• Wipe clean with a damp cloth.
• Do not bleach.
• Do not iron.
• Do not dry clean &.
• Do not use abrasive pads, bleach or strong household cleaners.

IMAGES/ DRAWINGS IN THE MANUAL ARE FOR VISUAL PURPOSES ONLY ACTUAL PRODUCT MAY VARY SLIGHTLY. THE MANUFACTURER RESERVES THE RIGHT TO CHANGE ANY SPECIFICATION OR FEATURE WITHOUT PRIOR NOTICE.
KEYCODE: 43-139-774
MADE IN CHINA
©l<MART AUSTRALIA LIMITED
FOR AU / NZ: IMPORTED FOR KMART STORES IN AUSTRALIA AND NEW ZEALAND.
KMART AUSTRALIA- 69D SPRINGVALE ROAD, MULGRAVE, VIC 3170 AUSTRALIA.
KMART NEW ZEALAND – REGIONAL OFFICE C/O KMART PAPATOETOE STORE, HUNTERS PLAZA. GREAT SOUTH ROAD, PAPATOETOE, AUCKLAND, NEW ZEALAND.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>