Rayotec PERGARP0DCN6YB3I Wi-Fi Thermostat Instruction Manual
- July 10, 2024
- Rayotec
Table of Contents
Rayotec PERGARP0DCN6YB3I Wi-Fi Thermostat
Specifications
- Wi-Fi enabled thermostat
- Color display screen
- Temperature control for heating systems
- Floor probe for accurate temperature readings
- Scratch-resistant screen protector
Product Usage Instructions
Heating Icon Flashing
If the heating icon is flashing, it indicates that the floor probe has
reached its high-temperature limit. Follow these steps:
- Check if the floor probe is too close to any heating elements.
- If the floor is not hot, reposition the floor probe away from heating elements.
- Ensure there are no obstructions around the floor probe that could trap heat.
No Display on Screen If there is no display on the screen, follow these steps:
- Check if the screen protector has been removed.
- If the screen looks scratched, make sure to remove the screen protector by pulling it off using the tab in the corner.
| Number | Issue |
|---|---|
| 1 | Heating icon flashing |
| 2 | No display on screen |
| 3 | Unable to separate the front from the backplate |
| 4 | The display looks like it has scratches straight out of the box |
No display on the screen
Firstly check that the unit has power to it. If there is power, make sure the wiring is in the unit correctly, the incoming power needs to be in terminals 3 and 4 and the heating mat goes into 5 and 6. If everything is wired in correctly then check that the faceplate is plugged in correctly and has not been damaged. On the faceplate of the unit there is a block where the pins from the backplate need to connect to, ensure this is lined up properly and the faceplate is securely clipped to the backplate.
Unable to separate the front from the backplate
The backplate unclips from the faceplate so it can be disconnected. To do this
you need to insert a flathead screwdriver into the slot on the bottom of the
unit and apply a little bit of pressure, you will hear a click when the unit
has separated.
Ensure that you are careful when putting the screwdriver in as you only need a
small amount of pressure to unclip the unit. When you need to reconnect the
unit you will need to make sure that the section with the clips lines up with
the port on the back otherwise the unit will not clip together.
The display looks like it has scratches straight out of the box
If this if the case you will need to check and make sure that you have removed
the screen protector. The screen protector comes with a small tab in the
corner to help pull it off.
Frequently Asked Questions
-
Q: How do I separate the front from the backplate?
- A: To separate the front from the backplate, gently pull them apart ensuring not to force it. There may be clips or tabs holding them together that need to be released carefully.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>