ACURITE 00990 Wireless Thermometer Combo Pack with 2 Main Units Instruction Manual
- June 6, 2024
- Acurite
Table of Contents
00990 Wireless Thermometer Combo Pack with 2 Main Units
Instruction Manual
Thank You! We appreciate you for purchasing this wireless thermometer.
We hope you enjoy using this versatile wireless thermometer!
Features:
-
Dual main units with synchronized outdoor LCD temperature displays.
-
Wireless Sensor – the range is 100’ (33m).
-
Temperature measurement ranges:
Indoor main unit: 32º F to 122º F
Outdoor remote sensor: 0º F to 130º F -
Battery operated. (batteries not included)
CHECK PACKAGE CONTENTS
- Main units – dimensions each: 1.5” x 4.75” x 1.5”*
- Wireless Sensor – dimensions: 2” x 2.5” x 1.3”*
- Instructions
*Dimensions are approximate.
NOTE: Carefully remove the units from their packaging. Discard the packaging and save the instructions.
READ
Please read these instructions carefully before you set up the thermometer. In this way, you can become familiar with all of the thermometer’s features and get the most benefit from them.
INSTALLATION
Operating Range of Batteries
Severe cold (below -4º F/-20º C) can cause alkaline batteries to freeze and function improperly. Use lithium batteries in extremely low-temperature conditions to ensure continued operation.
Main Units
The Main units are intended for indoor use only. When deciding where to put
the main units, choose a dry location away from dust, dirt, mold, and smoke,
and avoid temperature extremes. Do not drop the main units. They are sensitive
electronic devices and are not designed to withstand high-impact blows.
NOTE: Install batteries in both of the MAIN UNITS before installing
batteries in the wireless sensor.
Main Unit Batteries: On the back of each main unit, remove the battery
compartment covers. Insert 2 AAA alkaline (or lithium) batteries in each main
unit making sure they are installed according to the correct polarity (+/-).
Replace the covers on each main unit.
Wireless Sensor
This water-resistant wireless sensor is intended for outdoor use. When
deciding where to place the sensor, make sure it will be protected from direct
sunlight and precipitation. Do not drop the remote sensor. It is sensitive,
and not designed to withstand high-impact blows.
Wireless Sensor Batteries: On the back of the wireless sensor unit, remove the battery compartment cover. Insert 2 AAA alkaline (or lithium) batteries making sure they are installed according to the correct polarity (+/-). Replace the cover.
You may need to wait a few minutes after batteries are installed for the units to communicate with each other. When they do, both the indoor and outdoor temperatures will be shown on the main unit LCD display. If nothing is displayed after a few minutes, refer to section 4 of this manual for troubleshooting.
NOTE: The wireless sensor’s LED flashes momentarily whenever it sends
information -about once each minute.
Placement & Mounting
Choose a location for each unit that is at least 10 feet away from other
electronic devices that may interfere with the wireless signal. When you
decide on a good location, (A steady signal from the sensor is being received
by the main unit LCD display), hang the main unit and wireless sensor using
the triangular indents found on the backs of the units.
You may choose to place the main units on a table-top or desktop surface.
Pictured above is a common placement scenario. The main units can be placed anywhere within 100 feet of the wireless sensor. Placement is not limited to one unit being placed on a first and second level of a building or house as pictured here.
TROUBLESHOOTING
| PROBLEM | SOLUTION |
|---|---|
| Main Unit LCD display shows – – – continuously for the OUT display. |
a.Wireless sensor is located too far from the main unit, move the sensor
closer to the main unit.
b.Sensor batteries may need replacing, replace batteries according to
instructions in this manual.
NOTE: After replacing remote sensor batteries, you must press the RESET button
on the main unit.
Main Unit LCD display is blank. The main unit does not display any readings|
Follow section 3 of this instruction booklet and replace the batteries in the
main unit.
Main Unit LCD display is operating erratically| The main unit may be affected
by electrical interference. Press the RESET button on the main unit. This
should give you the indoor temperature immediately and the outdoor temperature
within one minute.
Wireless Sensor Unit is operating erratically| The sensor may be affected by
electrical interference. Press the RESET button on the remote sensor. (located
inside the battery compartment between the batteries.) If the RESET button is
pressed, you then also must press the RESET button on the main units. You may
also need to relocate all units away from any electronic interference to
restore normal operation.
ADDITIONAL INFORMATION
Batteries: 6 x AAA alkaline cell batteries total (not included).
Do not return the product to a retail store. For Technical Assistance and
product return information, please call Customer Care:
877-221-1252
HOURS: Monday through Friday from 8:00 a.m. to 4:45 pm CST.
| If at any time in the future you need to dispose of this product please note
that:
Waste electrical products should not be disposed of together with household
waste.
Please recycle where facilities exist. Check with your local Authority or
retailer for recycling advice
---|---
| PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY
IN ACCORDANCE WITH YOUR LOCAL REGULATIONS
| Tested to comply with FCC standards
FOR HOME OR OFFICE USE
LIMITED WARRANTY — INTERNATIONAL
The consumer may have more remedies at law than follows. Chaney Instrument Company warrants to the owner, this product are free from defects in material and workmanship for one year from the date of purchase. CHANEY INSTRUMENT SHALL NOT BE LIABLE FOR ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, WHETHER ARISING IN CONTRACT OR TORT. Chaney Instrument’s obligation (at its option) is limited to repairing or replacing this product. For in-warranty repair, send the product, accompanied by Guarantee, bearing Dealer’s name and date of purchase, with $5.00 to cover handling and postage, to:
www.chaneyinstrument.com
Tel: 877-221-1252 Made in China|
Chaney Instrument Company
965 Wells Street
Lake Geneva, Wisconsin 53147
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>