EDIFIER W200BT Plus Wireless Sports Headphones User Manual

: June 6, 2024
: Edifier

Table of Contents

Functional operation instructions
FCC Regulatory Compliance
Documents / Resources

EDIFIER W200BT Plus Wireless Sports Headphones

Functional operation instructions

Power on/off / music playback

Call

Bluetooth pairing

When the headphones are powered off, press and hold the multifunctional button for around 5 seconds, the red and blue lights flash rapidly.
Search for and connect to “EDIFIER W200BT Plus”, after pairing is successful, the blue light will flash slowly.

Note: When the headphones are powered on and not connected, press and hold the multifunctional button for around 2 seconds to enter Bluetooth pairing.

Clear pairing records

When the earphones are powered on and not connected, press and hold the “+” and “-” buttons simultaneously for around 5 seconds, wait until the blue light flashes rapidly, then the pairing records have been cleared.

Note: Images are for illustrative purposes only and may differ from the actual product.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by EDIFIER is under license. Other trademarks and trade names are those of their respective owners.

Declaration for EU
Frequency Band: 2.402GHz ~ 2.480GHz
RF Power Output: ≤20 dBm (EIRP)
There is no restriction of use.

nput: 5V 500mA

Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries.
aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other countries.

FCC Regulatory Compliance

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

ISED Regulatory compliance
This device contains licence-exempt transmitters that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:

This device may not cause interference
This device must accept any interference, including interference that may cause undesired operation of the device
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.

Edifier International Limited
P.O. Box 6264
General Post Office
Hong Kong

www.edifier.com
© 2021 Edifier International Limited. All rights reserved.

NOTICE:
For the need of technical improvement and system upgrade, information contained herein may be subject to change from time to time without prior notice

Products of EDIFIER will be customized for different applications. Pictures and illustrations shown on this manual may be slightly different from actual product. If any difference is found, the actual product prevails.

Model: EDF200027