Alecto DVM-140C Expansion Camera Instruction Manual
- June 6, 2024
- Alecto
Table of Contents
Alecto DVM-140C Expansion Camera Instruction Manual
REGISTERING CAMERA:
- Connect the power adaptor of the new camera (baby unit) and insert the adapter into a 230V wall outlet; turn the camera on by sliding Switch to position 1 (to below).
- Open the menu on the parent unit, select the
Settings’ option, press the OK button and then selectCamera’. Press the OK button. - Use the or navigation button to add a new camera (`Add Camera’ column) and press the OK button.
- The parent unit now starts a countdown from 30 to 0, within these 30 seconds briefly press the PAIR- button at the rear of the new baby unit. After several seconds the parent unit and the new baby unit will detect each other and the view of the new baby unit is immediately shown on the screen of the parent unit. The camera is now registered and ready for use.
“Information Power Adapter:
Manufacturers name and address : Shenzhen Guanjin Technology Co., LTD,
Building 8, Qiaoxin garden,
No.33, Hexin South Road, Guangming street, Guangming District, Shenzhen, China
Model Identifier : CYHA050100VWEU
Input voltage : 100-240VAC
Input AC frequency : 50/60 Hz
Output voltage : 5.0V DC
Output current : 1.5 A
Output Power : 7.5 W
Average active efficiency : 77.0 %
Efficiency at low 10% load : –
No load Power consumption : 0.076 W
DECLARATION OF CONFORMITY
Hereby, Hesdo declares that the radio equipment type Alecto DVM-140 is in
compliance with directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
http://DOC.hesdo.com/ DVM-140-DOC.pdf Use of this equipment is allowed in all
countries of the EU. In France, Italy, Russia and Ukraine, only indoor use is
allowed.
WWW.ALECTO.NL
SERVICE@ALECTO.NL
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>