Rubicson 24136 Karaoke Microphone User Manual
- June 6, 2024
- rubicson
Table of Contents
24136 Karaoke Microphone
User Manual
Overview
Specifications
| Bluetooth: | 5.0, 10 m |
|---|---|
| Input: | DC 5 V, 1 A |
| Battery time: | Up to 2 hrs |
| Output power: | 5 W |
| Micro-SD card: | Max. 64 GB |
| Dimensions: | 265×80 mm |
| Frequency Range: | 2402- 2480MHz |
| Effective Radiated Power: | 20mW(Max) |
Charge
Charge the microphone fully before first use.
Connect the Micro-USB cable to the charging port and a USB charger. The
microphone turns red during charging and turns off when fully charged.
Power on/off
Press and hold the Power button until the LED lights light up to turn it on.
Press and hold the Power button until the LED lights turn off to turn off the
microphone.
The microphone turns off automatically after 20 minutes of inactivity to save
battery time.
Bluetooth pairing
Turn on the microphone. The microphone enters Bluetooth mode automatically.
Open the Bluetooth settings on your phone and pair with “Rubicon M10”. You can
now play music on your Bluetooth device and sing along.
Micro-SD card
Turn on the microphone and insert a Micro-SD card preloaded with songs into
the Micro-SD port. The music starts to play automatically. Note! The Micro-SD
card needs to support MP3 format.
Control music
Play/pause: Press the play/pause button once.
Next song: Press the Next song button once.
Previous song: Press the Previous song button once.
Volume+: Press and hold the Next song button to increase the volume of the
speaker.
Volume -: Press and hold the Previous song button to decrease the volume.
Tune the microphone Microphone volume:
Turn the Microphone volume knob to adjust the volume of your voice.
Echo: Turn the Echo knob to adjust the echo of your voice.
Pairing microphones
It is possible to pair two Karaoke microphones. Turn on both microphones and make sure they are in Bluetooth mode. Double press the Power button on both microphones. When the pairing is successful, the microphones emit a signal. Pair the microphones with your phone after pairing the microphones together. Disconnect the microphones by double-press the Power button on one of the units or inserting a Micro-SD card. The microphones emit four signals to confirm disconnection.
Troubleshooting
The sound is breaking or has a lot of noise Make sure that the Bluetooth
source is within 10 meters of the microphone. If there is a lot of noise, try
to use the microphone in another room or environment.
Safety information
The microphone contains a rechargeable Li-ion battery that cannot be
replaced. Do not disassemble the microphone.
Simplified EU Declaration of Conformity
The company hereby declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at
www.kjell.com/24136
www.rubicson.com
****Box 50435 Malmö
Sweden
2021-11-25
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>