SuperFish 30000 UVC Pond Clear User Manual

SuperFish Pond Clear UVC 30000

General instructions

Read this manual carefully before using this device. Keep this manual for future reference.
Meaning of symbols
The following warning symbols and/or signal words are used in this manual:
DANGER!
This means an imminent danger due to electric current. Failure to follow the safety instructions can result in  serious or fatal injury and/or serious damage to the product or environment.
WARNING!
This means a dangerous situation due to UV-C radiation. Failure to follow the safety instructions can result in serious eye damage and damage to the skin.
WARNING!
This means a dangerous situation. Failure to follow the safety instructions can result in moderate or minor personal injury and/or damage to the product or environment.
NOTICE!
This means caution, useful information or advice.
Fig. … This refers to the relevant drawing … on pages 2 and 3 of this manual.
Meaning of the symbols on the device itself:
This UVC device produces harmful radiation, direct contact can be dangerous for the eyes and skin. Always turn offthe UV lamp before opening.
This device complies with all applicable EU standards. This device may not be disposed of with normal household waste but must be collected separately for recycling.

Use

Suitable for outdoor use, for pond purposes.

•  The UVC device may only be connected if there is a sufficient flow of water.
•  This UVC should be only used for cleaning pond water and the water temperature should not exceed 35°C. It
  should never be used for other liquids or chemicals.Model| Pond Clear UVC 30000
  ---|---
  UV-lamp| 36 Watt
  Max. pump capacity| 20,000 L/h
  Pond content| 30,000 L
  Hose connectors| ø 25/32/40 mm
  Cable length| 5 metres

Safety

Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may endanger persons or the environment.
WARNING! This UVC device emits UV-C radiation, which can cause serious eye damage and/or damage to the skin. The UV lamp must therefore always be installed completely shielded from the eyes.

•  Never look at a burning UV lamp. Do not switch on the lamp until it is fully shielded installed and fully submerged.
•  This device must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
•  Ensure the voltage shown on the label matches the mains supply voltage.
•  This device must be connected to a socket which is earthed.
•  Protect the socket and plug against moisture. Use a drip loop to ensure that water cannot reach the socket via the cord (see Fig. A).
•  Don’t use the product if the device, quartz glass, cord or plug is damaged. Replace the quartz glass or return the device to your dealer for repair or recycling.
•  If the power cord or plug of the UVC is damaged, the unit head should be replaced.
•  Be careful with the combination of water and electricity. Do not operate with wet hands. Dry hands before carrying out maintenance.
•  Always switch off all devices in the aquarium before maintenance. Disconnect the plug(s) from the socket.
•  NOTICE! The UV lamp becomes warm. Allow the lamp to cool for at least 10 minutes before carrying out maintenance.
•  In the event of frost or the risk of frost, appropriate precautions must be taken to prevent it from freezing.
•  This device can be used by children aged from 8 years and above, persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or instructions concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and maintenance of the device shall not be done by children without supervision.
•  Modifications to the device may affect the safety. The warranty will also expire.
•  Aquadistri is not liable for any problems, damage or accidents due to incorrect use of this device.
  Function
  The UVC device ensures a clear pond within 14 days. The UV lamp produces ultraviolet light is set to maximise effectiveness, with a wavelength of exactly 254 nm. The UV radiation combats floating algae without the use of chemicals and reduces harmful bacteria and germs. The UV-C radiation does not affect the pH value of the pond water and is safe for fish and plants.

SuperFish Pond Clear UVC 30000

General instructions

Read this manual carefully before using this device. Keep this manual for future reference.
Meaning of symbols
The following warning symbols and/or signal words are used in this manual:
DANGER!
This means an imminent danger due to electric current. Failure to follow the safety instructions can result in serious or fatal injury and/or serious damage to the product or environment.
WARNING!
This means a dangerous situation due to UV-C radiation. Failure to follow the safety instructions can result in serious eye damage and damage to the skin.
WARNING!
This means a dangerous situation. Failure to follow the safety instructions can result in moderate or minor personal injury and/or damage to the product or environment.
NOTICE!
This means caution, useful information or advice.
Fig. … This refers to the relevant drawing … on pages 2 and 3 of this manual.
Meaning of the symbols on the device itself:
This UVC device produces harmful radiation, direct contact can be dangerous for the eyes and skin. Always turn off the UV lamp before opening.
This device complies with all applicable EU standards.
This device may not be disposed of with normal household waste but must be collected separately for recycling.
Use
Suitable for outdoor use, for pond purposes.
• The UVC device may only be connected if there is a sufficient flow of water.
• This UVC should be only used for cleaning pond water and the water temperature should not exceed 35°C. It should never be used for other liquids or chemicals

Installation

Always install the UVC device outside the pond, securely so it cannot fall into the pond. A pump transports the water from the pond through the UVC device and then through the filter back into the pond. See technical data for the correct pump capacity. Purification bacteria in the filter do not come into contact with the UV light, therefore the biological filtration is not adversely affected. pond hoses. Secure the hoses with hose clamps.

Fig. B Cut the hose connectors (a) at the same diameter as the diameter of the hose. Unscrew the hose connectors from the UVC device before making cuts to avoid damaging the UVC device.

•  Screw the hose connectors with the rubber gaskets (b) back onto the UVC device. The Double Head outlet allows
  you to choose which side to screw a hose connector to, make sure the remaining outlet is blanked off using the
  end cap (e).Fig. C Connect the pump and filter to the hose connectors of the UVC device using pond hoses. Secure the hoses with
  hose clamps.

•  Switch on the pump and check for any leaks.

•  Then turn on the UVC device by plugging in the power cord. To ensure the UV lamp is active use the control glass in the end cap to view (e).

•  To avoid UVC overheating, switch off the UVC device when no water is flowing past it.

Maintenance

• Check monthly if UV lamp is burning via the control glass in the end cap (e) of the outlet.

•  Remove the plug from the socket before carrying out maintenance!

•  The UVC device should be cleaned twice a year. As soon as algae growth increases, check the UVC device and UVlamp
  and clean the whole or exchange the UV lamp as needed.

•  The lamp is hot, wait 10 minutes after switch off before opening the UVC device.

•  Ensure that the water is drained out of the UVC device first, before opening the device.
  Fig. E Slide the red switch lock (o) to unlock the electrical part/unit head and housing.

•  Turn the unit head (p) counter-clockwise against the stop and carefully pull it out of the housing.

  •  Clean the inside of the housing (d) with a clean brush or cloth and rinse with clean tap water.Fig. F Loosen the locking screw (i) from the unit head, screw off the locknut (j). Pull off the quartz glass (g) including the
    gasket (l) by a slight rotary movement.

•  Carefully clean the quartz glass outer face with a soft cloth and SuperFish Pump & UVC Clean. After cleaning,
  thoroughly rinse the quartz glass with clean tap water and check for damage. Replace the quartz glass if it shows
  any damage (to prevent glass breakage). Quartz glass replacement kit for the Pond Clear UVC 30000 (Art. 06010375).

•  The UV-lamp should be replaced annually, as the lamp may still show active but no longer emits enough UV
  radiation (maximum 8000 operating hours). Replacement lamp for Pond Clear UVC 30000: SF UV PL-lamp 36 W
  2G11-415 mm (Art. 06011035).
  Fig. G Remove the old lamp (k) together with clip (h) and tube protection ring (m) and remove the O-ring.
  Fig. H Slide the tube protection ring (m) over a new UV-lamp, and put the clip (h) on the end of the UV-tube.
  Fig. I Insert the new UV-lamp (k) in the fitting of the unit head.
  Fig. J Slide the quartz glass (g) gently over the UV-lamp and insert the quartz glass with the gasket (l) in the unit head.
  Fig. K Slide the locknut (j) over the quartz glass and tighten it onto the unit head.

•  Place back the locking screw (i) to lock the locknut.
  Fig. L Place the unit head (p) with fitted UV-lamp and quartz glass back into the housing (d) correctly and lock the red
  switch (o).

•  Check the whole assembly for possible leaks and check if the UV lamp is working.

•  Hose connector

•  Rubber gasket

•  Clip

•  UVC housing

• Recycling

•  End cap/control glass

•  Fixing foot

•  Quartz glass

•  UV tube clip

•  Locking screw

•  Quarts locknut

•  UV tube

•  Gasket

•  Tube protection ring n O-ring

•  Switch lock (red)

•  Electrical part/unit head

This symbol indicates that this product (if it is discarded) may not be disposed of with normal household waste. Instead it must be handed in at an official collection centre (e.g. HWRC). Or can be returned to the dealer when purchasing a similar new product. Follow the applicable rules in your country for the separate collection of electrical and electronic products. Separate collection and recycling are better for the environment, public health and reduces waste.

Warranty

2 years manufacturer’s warranty on materials and construction defects. Devices must be returned complete with all components, accompanied with an official proof of purchase confirming a purchase date for any warranty claims. Incomplete devices of which parts are missing, and devices without  proof of purchase are not eligible for warranty. After receiving and checking, we will determine whether the device will be repaired or replaced. For a device repaired or replaced under warranty,  the remaining time of the original warranty period applies. Carefully read the instructions on installation, use and maintenance. Damage due to incorrect use, damage due to contamination or not cleaning the device, glass breakage and damage to the cord are not covered by the warranty. Alway keep the proof of purchase, without proof of purchase the warranty will be void!

References

• Aquadistri | For A Successful Aquarium, Pond & Terrarium

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>