ELINZ TPMS4TYRE Car Auto Wireless Digital TPMS Tire Tyre Pressure Monitoring System User Manual

ELINZ TPMS4TYRE Car Auto Wireless Digital TPMS Tire Tyre Pressure

Monitoring System

Product introduction

FUNCTION

High-pressure alarm
When the pressure of the front left tire reach 3.1 BAR which is higher than the preset value, the high-pressure icon and the value is flashing with the audible alarm together

High-temperature alarm
When the temperature of the front right tire reach 66″C which is higher than the preset value, the high-temperature icon and the value is flashing with the audible alarm together .

Sensor low battery alarm
When the sensor detects itself low battery level, it will send an alert to the monitor immediately. The sensor low battery icon will show on the LCD and the corresponding tire icon will flash with an audible alarm together.

Low-pressure alarm
When the pressure of the front left tire is below 2.0 BAR which is lower than the preset value, the low-pressure icon and the value is flashing with the audible alarm together.

Air leakage alarm
When the sensor detects air leakage of the front left outside tire, the quick air leakage icon and the value is flashing with the audible alarm together.

Vehicle battery alarm
When the vehicle low battery level, the vehicle battery icon, and the value is flashing will the audible alarm together.

Parameter setting

High-pressure setting

1. .Long press the SET key to enter into parameter setting mode
2. Press /\ orV to select to set interface [HJ
3. Press then press /\ orV to select the high-pressure alarm value.
4. Hold on press SETto save and exit.

High-temperature setting

1. Long press SET key enter into parameter setting mode
2. Press/\orVto select to setting interface f
3. Press then press /\ orV to select the temperature alarm value.
4. Hold on press SET to save and exit.

Low-pressure setting

1. Long press the SET key to enter into parameter setting mode
2. Press /\ orV to select to set interface
3. Press then press /\ orV to select low-pressure alarm value
4. Hold on press SET to save and exit.

Matching tire

1. Long press SET key to enter into parameter setting mode
2. Press /\ orV to select toe} interface,
3. Press then press /\ orV to select the matching tire
4. Display “–” and then inflate the matching tire,it will display “ON” if the match successfully
5. Hold on press SET to save and exit.

Tire exchange setting

1. Long press the SET key to enter into parameter setting mode
2. Press /\ orV to select to tire exchange II interface,
3. Press SET to enter the setting.
4. Press SET to select the exchange tire and then press/\ or V to another exchange tire position. (e.g:01 tireand 02 tire need to be exchanged,change number “01” to be “02” like the interface)
5. Press SET to confirm
6. Hold on press SET tp save and exit 01:Leftfront tire 02:Right front tire 03:Rear left tire 04:Rear right tire

Pressure unit setting

1. Long press the SET key to enter into unit setting mode,
2. Press /\ orV to select to “BAR PSI” interface.
3. Press then press/\ or V to select the pressure unit you want.
4. Hold on press SET to save and exit.

Temperature unit setting

1. Long press the SET key to enter into unit setting mode,
2. Press/\orVto select to “‘CF” interface.
3. Press SET then press/\ or V to select the temperature unit you want.
4. Hold on press SET to save and exit.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>