ELINZ 4G Solar Security Camera User Guide
- June 6, 2024
- ELInZ
Table of Contents
ELINZ 4G Solar Security Camera
Easy steps in adding Elinz 4G Solar Security Camera to UBox App
- Make sure to test your Sim card if it’s working on your mobile phone and has data credit before inserting it in the camera.
- If you have only just activated your Sim card it may take up to 24 hours to work depending on your carrier.
- Make sure there is a signal/reception in the area where the camera is located.
- Insert Sim card correctly.
Steps
-
Go to Device tab from the bottom left hand corner.
-
Click “Setup 4G Device”.
-
Wait for the blue light then click “Next”.
Note: If you do not have a blue light showing on the camera and the light is red do not hit next, the camera will not set up correctly. So you must wait for the blue light to turn on. In some cases it can take up to 90 seconds. -
Scan the QR Code on the camera.
-
Wait for few seconds to connect.
-
Name the device, then click “Next”
-
. You will get a prompt that camera has been installed successfully.
www.elinz.com.au / sales@elinz.com.au / 1300 881 773
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>