KMC CONTROLS STE-9000 Series NetSensors Installation Guide
- June 5, 2024
- KMC CONTROLS
Table of Contents
KMC CONTROLS STE-9000 Series NetSensors
INTRODUCTION
Complete the following steps to mount a KMC Conquest STE-9000 Series Digital NetSensor and connect it to a Conquest BAC-59xx/9xxx Controller.
NOTE:
See the Conquest NetSensors STE-9000 Series Digital Room Sensors data sheet
and the Conquest Selection Guide at kmccontrols.com for specifications and
other information. OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE
DEVICES.
SELECT MOUNTING LOCATION
See the Room Sensor and Thermostat Mounting Location and Maintenance Application Guide for cautions, troubleshooting, and best practices.
NOTE:
Complete rough-in-wiring at each location before installing a sensor.
REMOVE BACKPLATE
-
Turn the hex screw 1 clockwise into the sensor until the screw clears the cover.
NOTE : The hex screw 2 should remain in the backplate. -
Pull the cover off the backplate.
CONNECT ETHERNET CABLE -
Feed the Ethernet patch cable 3 from the Conquest controller through the center of the backplate 4 .
NOTE: The Ethernet patch cable should be a maximum of 150 feet (45 meters). -
Mount the backplate on an electrical box using the provided screws.
NOTE: If additional thermal insulation is needed, install the optional HPO-9002 gasket between the backplate and the electrical box. For more information, see the Room Sensor and Thermostat Mounting Location and Maintenance Application Guide. -
Plug the Ethernet cable 5 into the modular jack 6 of the sensor.
INSTALL SENSOR COVER -
Place the cover 7 over the top of the backplate 8 and swing it down.
NOTE: Be careful not to pinch the Ethernet cable. -
Turn the hex screw 9 counterclockwise until it engages the cover.
OPERATE
The STE-9000 Series NetSensor becomes operational after it is connected to a powered Conquest controller.
NOTE:
To change setpoints or configuration, see the KMC Conquest Controller
Application Guide. For continued maximum NetSensor efficiency, see the
maintenance section in the Room Sensor and Thermostat Mounting Location and
Maintenance Application Guide.
IMPORTANT NOTICES
The material in this document is for information purposes only. The contents and the product it describes are subject to change without notice. KMC Controls, Inc. makes no representations or warranties with respect to this document. In no event shall KMC Controls, Inc. be liable for any damages, direct, or incidental, arising out of or related to the use of this document. The KMC logo is a registered trademark of KMC Controls, Inc. All rights reserved.
- TEL: 574.831.5250
- FAX: 574.831.5252
- e-mail: info@kmccontrols.com
References
- KMC Controls | Building Automation and Control Solutions
- KMC Controls | Building Automation and Control Solutions
- KMC Controls | Building Automation and Control Solutions
- NetSensor: Temperature, Almond | KMC Controls
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>