KOHLER K-28238-GKA Moxie Alexa Enabled Showerhead Bluetooth Shower Speaker User Guide
- June 5, 2024
- Kohler
Table of Contents
KOHLER K-28238-GKA Moxie Alexa Enabled Showerhead Bluetooth Shower
Speaker
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Kohler Co. is under license. Other trademarks and trade names are those of their respective owners.
Warranty
The showerhead is covered under the KOHLER® Faucet Lifetime Limited Warranty. The wireless speaker is covered under the KOHLER® One-Year Limited Warranty. To obtain warranty terms, contact the Customer Care Center or visit kohler.com/warranty.
IMPORTANT INSTRUCTIONS
WARNING:
Risk of scalding. High water temperature can cause severe burns. Set the water
temperature at or below 120°F (49°C) following the adjustment procedure in the
valve Installation and Care Guide. Risk of property damage. Do not crush, cut,
or expose batteries to sunlight, fire, or other forms of excessive heat. Risk
of property damage. Do not expose batteries to extremely low air pressure.
CAUTION:
Risk of product damage. The wireless speaker and battery are rated to operate
in temperatures up to 113°F (45°C). Do not expose to heat sources where the
temperature may exceed 113°F (45°C). Risk of product damage. The speaker is
rated to IPX7 for temporary immersion, and should not be submerged for more
than 30 minutes. Risk of product damage. To prevent accidental release from
the showerhead, remove the speaker before adjusting the showerhead position.
Risk of personal injury. This product contains magnets. Users with a pacemaker
or ICD should follow normal safety precautions and should consult their
physician before use.
NOTE: An Amazon account is required to enable your product with Amazon Alexa voice control. To prolong the battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions.
Specifications
- Output Power: 10 W
- Frequency Response: 100 Hz – 20 kHz
- Transducer: 2-1/4″ (57 mm) 4 Ohm
- Battery Type: Lithium-ion, 3800 mAh/3.7 V Boost to 11.7 V
- Speaker Dimensions (H x W x D): 4″ (102 mm) x 3-7/8″ (98 mm) x 3- 7/8″ (98 mm)
- Weight: 630 g (Speaker: 400 g / Dock: 230 g)
- Power Supply: Battery
- Wireless Network: 802.11a/b/g/n/ac (2.4 GHz/5 GHz)
- 2.4 GHz Wi-Fi Transmitter Power: <18.5 dBm
- 5 GHz Wi-Fi Transmitter Power: <20 dBm
- Bluetooth Version: 5.0
- Bluetooth Profile: A2DP, AVRCP 1.6
- Bluetooth Transmitter Power: <10 dBm
- Bluetooth Transmitter Frequency Range: 2.40 – 2.48 GHz
- Bluetooth Transmitter Modulation: FHSS, GFSK, DPSK, DQPSK
Compliance
FCC ID: N82-KOHLER044
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC: 4554A-KOHLER044
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
FCC and ISED RF Exposure Statement:
This device complies with FCC and ISED radiation exposure limits set forth for
an uncontrolled environment. The end-user must follow the specific operating
instructions for satisfying radiofrequency exposure compliance. This
transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter. This portable device is designed to meet the
requirements for exposure to radio waves established by the FCC and ISED.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of
tissue. The highest SAR value is reported under this standard during product
certification for use when properly worn on the body. The device for operation
in the band 5150–5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>