THINKCAR OBD 100 Diagnostic Scanner User Guide

: June 5, 2024
: THINKCAR

Table of Contents

Start Diagnostics
Vehicle Connection
Warranty Card
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

www.mythinkcar.com
Quick Start Guide THINKCAR OBD 100 Diagnostic Scanner

Start Diagnostics

Preparation

Turn the vehicle ignition on.
Vehicle battery voltage range should be 9-18Volts.
Throttle should be in a closed position.

Vehicle Connection

Locate vehicle’s DLC socket: The DLC (Diagnostic Link Connector) is usually located 12 inches from the center of steering wheel, under or around the drivers side for most vehicles. If the DLC cannot be found, refer to the vehicle’s service manual for the location.
Connect the diagnostic cable to the vehicle’s DLC, the tool will be automatically powered up.
The tool is now ready to work.

Warranty Card

For non-human quality problems,we accept a return in one month without any reason. Within one year, free warranty.
Before replacement, please ensure complete packaging; Before replacement/repair, please call the service number to get the shipping address.
Product warranty starting date is based on the payment date.

FCC Requirement
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B dital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & yur body. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter.

Service Line: 1-833-692-2766

Customer Service
Email:support@thinkcarus.com
Products tutorial, videos, FAQ and coverage list are available on Think car official website.
Follow us
think car.official
ObdThinkcar
Note: This Quick Start Guide is subject to change without written notice.