MEE audio X6 Wireless In-Ear Stereo Headset User Manual

June 5, 2024
mee audio

MEE audio X6 Wireless In-Ear Stereo Headset User Manual
MEE audio X6 Wireless In-Ear Stereo

PRODUCT OVERVIEW

Product overview

CHARGING

Connect the Micro-USB charging cable to any powered USB port and to the charging port of the X6.

The status indicator light will turn blue once the X6 is charged and ready for use.

Close the USB port cover completely after charging for maximum sweat resistance.

Charging

PAIRING

Press and hold the Multifunction button for about 4 seconds until you hear the headset say “Pairing” and the light flashes red and blue.

Open the Bluetooth menu on the device you wish to pair (usually located in
Settings > Bluetooth). If needed, select “search for devices”, “add new device”, or “refresh”.

Select “MEE audio BT” and allow pairing to complete. Use “0000” if a pin is required.

Visit the Bluetooth Support Page at MEEaudio.com/Bluetooth for additional Bluetooth pairing and setup information.

SELECTING EARTIPS

Eartips

Select the eartips with the best sound and comfort for your ears.

Eartips

WEARING THE X6

Wearing

Identify the right and left earpieces. Place the cable behind your neck and route the earhooks over your ears.

Earpieces

Place the earpieces in your ears. Adjust each earpiece until it fits flush in your ear and the eartip seals the ear canal

Place the earpieces

Tighten the sliding cable cinch for the most secure fit.

Tighten the sliding cable

BASIC FUNCTIONALITY AND CONTROLS

HOLD BOTH 2 sec

You may need to bring your music player application up on the screen for media playback to start
** Not all devices support this functionality

DYNAMIC AUDIO ENHANCEMENT

The X6 features on-the-fly audio adjustment with three audio modes:

Audio enhancement

FACTORY RESET

To perform a full reset, first put the X6 in standby mode (headset is powered on but not connected to any devices). Make sure to turn off Bluetooth or delete the “MEE audio X6” pairing from any nearby devices that have previously been paired with the X6. Once in standby mode, press and hold the Multifunction and volume up buttons simultaneously until you hear the headset say “Factory Reset Complete”. All previously paired devices will be cleared from memory and a new pairing will need to be created before the X6 can be used.

WARNING

Using headphones at high to moderate volumes for extended periods of time will result in permanent hearing damage. It is advised you keep volume levels moderate to low at all times for your safety. Do not use while driving a car, cycling, operating machinery, or performing other activities that require hearing surrounding sounds.

Keep the device and packaging out of reach of children

ADDITIONAL INFORMATION

FOR ADDITIONAL SUPPORT

WARRANTY

MEE audio products purchased from authorized resellers are covered by a 1 year manufacturer warranty. For more information, visit MEEaudio.com/Support

Have a question?

Email support@MEEaudio.com

MEE audio and its logo are registered trademarks of S2E, Inc. All rights reserved.

Siri® is a registered trademark of Apple Inc.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MEE audio is under license. Other trademarks and trade names are those of their respective owners.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

mee audio User Manuals

Related Manuals