Toolland WR25205 Heavy-Duty Worksite Radio User Guide
- June 5, 2024
- Toolland
Table of Contents
Toolland WR25205 Heavy-Duty Worksite Radio
OverView
Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, do not install or use it and contact your dealer.
Safety Instructions
-
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children shall be supervised to ensure that they do not play with the appliance. -
Warning! Do not leave the device unattended when switched on.
-
This device is capable of producing sound levels that could cause permanent hearing loss. Do not operate for a long period of time at high volumes or at a level that is uncomfortable.
-
Familiarise yourself with the functions of the device before actually using it.
-
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to the device is not covered by the warranty.
-
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.
Description
1 | volume button |
---|---|
2 | FM antenna |
3 | tuning button |
4 | power indicator |
5 | speaker |
6 | AUX IN jack |
7 | DC inlet |
8 | battery compartment |
9 | FM/power button |
10 | carrying handle |
Use
Installing the Batteries
- Locate the battery compartment at the back of the set.
- Unscrew the battery compartment cover using an appropriate screwdriver.
- Insert four R14/C-size batteries into the battery compartment in accordance with the polarity.
- Close the battery cover and retighten the screws.
Powering the Unit with an AC Adaptor
- Connect the included power adaptor to the DC inlet of the set.
- Plug the power adaptor into the mains.
Operating your Radio Set
- Switch on your radio by rotating the FM/power button to the FM position.
- Rotate the tuning button and select the desired station frequency.
- Adjust the volume level using the volume button.
- Rotate the FM/power button to the OFF position to switch off the radio.
Cleaning and Maintenance
- Reduced power, distortion, shuttering sound and a lighted low-battery LED may indicate the batteries are exhausted. Replace all exhausted batteries with new ones.
- Remove the batteries when you will not use the set for a long period.
- Unplug the power adaptor from the mains and from the set when you will not use the set for a long period.
- Always unplug the set from the mains before cleaning.
- Wipe the exterior with a soft, if necessary damp, cloth. Do not use any scouring cleaning agents.
- Never immerge the unit into water or any other liquid.
Technical Specifications
speaker output | 7 W |
---|---|
AC adaptor (indoor use only) | 6 V |
battery type | 4 x R14/C (not included) |
dimensions | 190 x 185 x 250 mm |
radio | IP44 |
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device.
Disposal
To all residents of the European Union – Important environmental information
about this product This symbol on the device or the package indicates that
disposal of the device after its lifecycle could harm the environment. Do not
dispose of the unit (or batteries) as unsorted municipal waste; it should be
taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local
environmental rules. If in doubt, contact your local waste disposal
authorities.
For more info concerning this product and the latest version of this manual,
please visit our website www.toolland.eu
The information in this manual is subject to change without prior notice.
© Copyright Notice
The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written
consent of the copyright holder.
Velleman® Service and Quality Warranty
Since its foundation in 1972, Velleman® acquired extensive experience in the
electronics world and currently distributes its products in over 85 countries.
All our products fulfil strict quality requirements and legal stipulations in
the EU. In order to ensure the quality, our products regularly go through an
extra quality check, both by an internal quality department and by specialized
external organisations. If, all precautionary measures notwithstanding,
problems should occur, please make appeal to our warranty (see guarantee
conditions).
General Warranty Conditions Concerning Consumer Products (for EU):
- All consumer products are subject to a 24-month warranty on production flaws and defective material as from the original date of purchase.
- Velleman® can decide to replace an article with an equivalent article, or to refund the retail value totally or partially when the complaint is valid and a free repair or replacement of the article is impossible, or if the expenses are out of proportion.
You will be delivered a replacing article or a refund at the value of 100% of the purchase price in case of a flaw occurred in the first year after the date of purchase and delivery, or a replacing article at 50% of the purchase price or a refund at the value of 50% of the retail value in case of a flaw occurred in the second year after the date of purchase and delivery.
Not covered by warranty:
- all direct or indirect damage caused after delivery to the article (e.g. by oxidation, shocks, falls, dust, dirt, humidity…), and by the article, as well as its contents (e.g. data loss), compensation for loss of profits;
- Consumable goods, parts or accessories that are subject to an aging process during normal use, such as batteries (rechargeable, non-rechargeable, built-in or replaceable), lamps, rubber parts, drive belts… (unlimited list);
- flaws resulting from fire, water damage, lightning, accident, natural disaster, etc.…;
- flaws caused deliberately, negligently or resulting from improper handling, negligent maintenance, abusive use or use contrary to the manufacturer’s instructions;
- damage caused by a commercial, professional or collective use of the article (the warranty validity will be reduced to six (6) months when the article is used professionally);
- damage resulting from an inappropriate packing and shipping of the article;
- all damage caused by modification, repair or alteration performed by a third party without written permission by Velleman®.
Articles to be repaired must be delivered to your Velleman® dealer, solidly
packed (preferably in the original packaging), and be completed with the
original receipt of purchase and a clear flaw description.
Hint: In order to save on cost and time, please reread the manual and
check if the flaw is caused by obvious causes prior to presenting the article
for repair. Note that returning a non-defective article can also involve
handling costs.
- Repairs occurring after warranty expiration are subject to shipping costs.
- The above conditions are without prejudice to all commercial warranties.
The above enumeration is subject to modification according to the article (see article’s manual).
References
- Details – Own brands – Velleman – Wholesaler and developer of electronics
- Velleman – Wholesaler and developer of electronics
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>