Audio Technology Of New York UO-BTSPTT Bluetooth Speaker User Manual
- June 5, 2024
- Audio Technology Of New York
Table of Contents
Audio Technology Of New York UO-BTSPTT Bluetooth Speaker
OPERATING INSTRUCTIONS
- Turntable Arm use this to turn the unit on/off.
- When turned on, the platter will rotate.
- Turn the top control knob to switch between Bluetooth TM, audio output and SD card. A “Bluetooth TM mode”‘ voice prompt will be heard when in Bluetooth TM mode. Turn on the compatible device you want to connect and search “BT SPEAKER” for pairing. A “Ta-Da” sound will be heard when paired successfully.
- Adjust the volume knob on the front of the unit to turn the volume up or down.
- Press the front knob once to skip to the next song, twice to play the previous song. Press and hold for a few seconds to pause.
- To play from the SD card slot, insert an SD card into the slot on the rear with MP3 files on it.
- The power indicator light on the back of the unit will show if the unit is on or off.
- To charge the item, plug the included USB cable into the charging port on the back of the unit and connect to a compatible USB outlet.
SPECIFICATIONS
- Product Model: UO-BTSPTT
- Product Size: 112.4 x 105 x 57mm
- Product Weight: 250Og
- Battery Capacity: 3.7V, 1000mAh
- Charging Time: 2-3 hours
- Speaker: 10mm, 4 Ohms, 5W
- Input: DC 5V1A
- Range: 10M
SAFETY GUIDELINES
Please read the instructions carefully before using the unit for the first time and keep them for reference.
- Keep the unit away from heat and open flames.
- Do not insert sharp objects or metal into the unit.
- This product cannot by repaired and should not be opened by the end user.
- If the product overheats stop use immediately.
- Do not use the product if it has fallen into water.
- If you need to purchase a replacement USB charging cable please be certain that it is CCC certified and meets the units requirements.
CARING FOR THE INTERNAL BATTERY
- Charge the product fully before using it for the first time.
- Do not insert sharp objects or metal into the unit.
- Do not overcharge the unit. Charging for more than 2-3 hours at a time will shorten the battery life.
- If the product is not used for prolonged periods of time, the battery may lose its charge.
- Use a standard 5V DC adapter or compatible USB cable to charge the item. Using anything else can damage the item.
- When the speaker is fully charged, the indicator light will switch from red to blue.
ACCESSORIES
- 1 Speaker
- 1 USB Charging Cable
- 1 Audio Cable
- 1 Instruction Manual
FCC
FCC Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help.
RF Exposure Compliance
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.