BluMill KMS005M Circulation Leg Exerciser User Manual

June 5, 2024
bluMill

BluMill KMS005M Circulation Leg Exerciser

SAFETY NOTICES

Before using the product, carefully read the recommendations for safety and correct use of the device. The user manual contains important information to use the device safety and prevent damage or injury to the user or third parties. Make sure you fully understand the information presented below and follow the instructions presented in this manual.

Do not stand on the product. The device is only meant to be used while sitting.

SAFETY INFORMATION

  • Older or vulnerable people should consult their doctor before using the product, even if there is no specific precondition for their health.
  • Friction can hurt the skin, do not use it directly
  • If you experience pain or any abnormal sensation when using the product, discontinue use immediately and consult your doctor.
  • To avoid short circuit, connect properly and avoid interference from metals [needles], trash or water.
  • Use the device on a flat surface because if it is not stable, the device could tip over and cause an accident. Do not activate the device if you are not going to use it.
  • If the operation begins to feel abnormal, stop the device as soon as possible.
  • If the device does not work or works abnormally, stop it immediately to avoid an accident. Electric teak or short circuit can cause fires.
  • Store it in a cool, moisture-free space otter use. Do not stock other objects on top of the massager.
  • Before checking or repairing, make sure that the device is disconnected from the power source.
  • The silicon pads can be removed for cleaning. Before placing and reusing them, they must be completely dry.

FORBIDDEN

  • Do not connect the device to an adaptor or current converter, to prevent short circuit or any other incident. Do not use a damaged cable, this could cause a short circuit with the risk of fire.
  • Do not use cables or accessories external to the massager, this could cause incidents.
  • Do not entangle the cable on wooden surfaces. Do not use a damaged cable, do not pull it, bend it and do not entangle it, these actions could cause damage and there are short circuit risks.
  • Do not splash the device with any type of liquid, this could cause a short circuit with the risk of fire.
  • Do not use the massager on wet surfaces and do not operate it with wet hands, this could cause injury, short circuit with the risk of fire.
  • This appliance may be used by children aged 8 years and over and by persons with reduced physical, sensory or mental abilities or lack of experience and / or knowledge, provided that this is done under supervision and they have been instructed about the safe use of the device and they have understood the associated risks.
  • It should not be used by more than two people at the same time. To prevent accidents or injuries, it should not be used while holding an infant.
  • Do not stand on top of the device, do not hit it or drop it, this could cause accidents, injuries to users as well as causing device failures.
  • If you hear a rumble or abnormal noise, stop the massage immediately and disconnect the device from the power source.
  • If a blackout occurs white you are using the massager, immediately suspend its use and disconnect from the power source, as an accident may occur at the time the power is restored.
  • Do not use the product if you see damaged parts, disconnect from the power source.
  • If the machine does not work, do not try to repair it to avoid accidents or short circuit. Consult your dealer or consult the Guarantee Section of this Manual.
  • Do not try to repair the device on your own, avoid accidents or short circuit.
  • When you no longer use the massager, do not discard it or leave it. Consult the correct measures of evacuation of electronic waste in your city.
  • This device is designed to be used in the arch of the feet. Do not use it on the waist, neck or other parts other than those indicated in this manual .
  • Do not use it for purposes other than those expressed in this manual.

SYMBOLS

  • Danger symbols: These symbols indicate possible dangers.
  • Read the associated safety notices carefully and follow them.
  • Supplementary information
  • Read operating instructions before use!
  • Symbol for direct current
  • Protection class II
  • Switching power supply
  • Only use indoors.
  • Energy efficiency class VI
  • Safe electrical isolation

SIGNAL WORDS
Signal words indicate hazards if the associated notices are not followed.

  • DANGER – high risk, results in serious injury or death
  • WARNING – medium risk, may result in serious injury or death
  • CAUTION – low risk, may result in minor or moderate injury
  • NOTICE – may result in risk of damage to material

INTENDED USE

  • The device is intended for gently exercising your feet and leg muscles.
  • The device is not designed for medical or therapeutic purposes.
  • People
    • with physical illnesses,
    • with medical implants,
    • with health problems or who are unsure should discuss the use with their responsible doc-tor BEFORE using the device.

ITEMS SUPPLIED

  • Exercise trainer
  • Remote control
  • Mains adapter
  • Operating instructions

Check the items supplied for completeness and the components for transport damage. If you fi nd any damage, do not use the device but contact our customer service department. Remove any possible fi lms, stickers or transport protection from the device. Never remove the rating plate and any possible warnings! To use the remote control, you require two 1.5 V batteries, AAA. These are not supplied with the device.

AT A GLANCE

BluMill-KMS005M-Circulation-Leg-Exerciser-1

  1. Foot plates
  2. Main device
  3. Mains adapter
  4. Feet (on the bottom)
  5. Remote control
  6. Control panel
  7. Connecting socket
  8.  On/Off
  9. Level control lamps
  10.  Decrease speed
  11. + Increase speed
  12. Remote control receiver
  13.  Transmitter
  14. + Increase speed
  15. – Decrease speed
  16. On/Off

Information About the Operating Instructions

Before using the device for the fi rst time, please read through these operating instructions carefully and keep them for future reference and other users. They form an integral part of the device. The manufacturer and importer do not accept any liability if the information in these operating instructi- ons is not complied with.

INSERTING / CHANGING THE BATTERY

Before inserting the batteries, check whether the contacts in the remote control (5) and on the batteries are clean, and clean them if necessary.

  1.  Open the battery compartment on the back of the remote control: Push the battery compartment cover slightly and slide it downwards.
  2. Remove used batteries if necessary and insert a new battery (1.5 V, AAA) into the battery com partment. Pay attention to the correct polarity.
  3. Place on the battery compartment cover and slide it upwards. You must feel it engage. Replace the batteries if the power of the remote control starts to wane.

SET-UP AND CONNECTION

Please Note!

  • Only connect the device to a plug socket that is properly installed and matches the technical data of the device. The plug socket must also be readily accessible after connection so that the connection to the mains can quickly be isolated.
  • Lay the connecting cable in such a way that it does not become squashed or bent and does not come into contact with hot surfaces.\
  • Place the device on a dry, flat and solid surface. If the device is used on a carpet, make sure that the ventilation openings on the bottom of the device remain clear. Protect sensitive floor coverings on which the device is placed with a mat if necessary.
  • Connect the cable of the mains adapter (3) first to the connecting socket (7) of the device and then connect it to an easily accessible plug socket. The control panel (6) lights up once. The device is ready.

USE

Please Note!

  • Never place your hands and feet between the frame and foot plates while the device is in operation. There is a danger of crushing!
  • Do not stand, kneel, stamp or jump on the foot plates to prevent injuries and damage to the device.
  • Do not use the device for longer than 20 minutes without a break.

Start with the slowest level and gradually increase the level of intensity. The device can be controlled both with and without the remote control. To make it easier to opera-te, we recommend using the remote control. Switch on the device using the button (8 or 16) on the contro an trol (5).

  1. Sit down on a chair, armchair or similar place in front of the device. Place your feet on the foot plates (1).
  2. To start the device, press the button (8 or 16). The device then starts.
  3. If you wish, increase/reduce the level by pressing the button + (11 or 14) or the button – (10 or 15) several times.
  4. Use the button to stop the device after the time you want.
  5. Pull the mains adapter (3) out of the plug socket and the barrel connector out of the device.

CLEANING AND STORAGE

Please Note!

  • Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the device. These may damage the surfaces.
  • Wipe down the device with a damp, soft cloth and a little mild cleaning agent if required. Then dry it thoroughly.
  • Store the device in a dry, frost-free place that is protected from direct sunlight and cannot be accessed by children or animals.

TROUBLESHOOTING

If the device does not work properly, check whether you are able to rectify the problem yourself. If the problem cannot be solved with the steps below, contact the customer service department.

The device does not work.
  • The cable of the mains adapter (3) is not connected to the device or the plug socket correctly.
    Correct the fit of the two plugs.

  • The plug socket is defective.
    Try another plug socket

  • There is no mains voltage.
    Check the fuse of the mains connection.

  • The device switches itself off automatically.
    The device has been overloaded.

  • Reduce the load and restart the device.
    Replace the batteries of the remote control.

  • There are obstructions between the device and remote control (5) (no visual contact).
    Point the remote control directly at the device.

DISPOSAL

Dispose of the packaging material in an environmentally friendly manner so that it can be recycled. The batteries should be removed before disposing of the remote control and dispo-sed of separately from the device at suitable collection points.
This device is governed by the European Directive 2012/19/EU on waste electrical and electronic equipment (WEEE). Do not dispose of this device as normal domestic waste, but rather in an environmentally friendly manner via an officially approved waste disposal company.

TECHNICAL DATA

  • Article number: V08142
  • Model number: KMS005M
  • Power supply: 24 V, 1 A
  • Power: 20 W
  • Input: 100 – 240 V ~ 50 / 60 Hz 0.8 A
  • Output: 24 V DC 1 A
  • Protection class: III
  • Speed levels: 5
  • Remote control Power supply: 3 V (2 x 1.5 V battery, AAA)
  • Power consumption on no-load: ≥ 0.1 W

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

bluMill User Manuals

Related Manuals