SNEP Mode P Linear High Quality Light Installation Guide

Mode P Linear High Quality Light
Installation Guide

Mode P Linear High Quality Light

Keep the instructions andhand them over to the user of the property.
Safety Instructions
Check the products for transpoint contents and damage. If you notice any defects or shortcomings in the delivery or in a products please contact the seller immediately.
The luminaire must be disconnected from the mains before installation or maintenance work to-avoid the risk of electric shock.

• The luminaire does not come with a terminal block. The installation or maintenance of the luminaire should only be carries out by an authorizen person in accordance  with these instructions
• The light source of the luminaire may only be replaced by manufacturer, a person authorized by him or an equivalent qualified person.

Instruction

• No changes may be made to the product
• The manufacturer is not reponsible for misure of the product
• The installed product must not be subjected to external mechanical stress
• The installed product must not be exposed to strong chemicals
• Do not look directly at the lumaire that is on

Service instructions

• If necessary, use neutral soap solutions and non-abrasive cleaners to clean the luminaire Storage
• The product is stored in a dry and clean environment
• Do not strain the product mechanically or chemically during storage

Brackets:
Use the brackets that came with the shipment only if they are suitable for the intended purpose. If the fasteners are included in the order, they are packaged separately. Please  note that for partial shipments, mounts may only be included wits thefirst delivery batch.
The number of fasteners must be used according to the instructions.
Note! When installing sports facilities, one piece/luminaire should be added to the number of brackets used.

Brackets| Surface or suspension rail installation| Ramp installation
---|---|---
Mode P02| 2| 2
Mode P04| 2| 2

Surface mount

Suspension rail installation

Ramp installation

Coupling

Coupling

The connection must be made according to the room protection rating and, if necessary, using a distribution box that provides the required protection rating. When the  luminaire is equipped with preassembled connection cable, one cannot open the luminaire nor change the cable.

| | | Yellow-green
N| N| N| Blue
3| L3| DA+ / 1| Gray

NOTE!
Basic insulation must be maintained between the mains voltage omponents and the DALI control circuit. (IEC60598-1: 3.3.22)

Connection and cable types

Step DIM motion sensor

Switch 4 must be in the off position

Luminaire and packing materials have to be disposed of according to local requirements.
Specifications subject to change without notice.
+358 (0)3 3404 111
snep@purso.fi
purso.fi

References

• Purso | Alumiinista valmistetut ratkaisut kotimaisella ammattitaidolla

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>