MARSON MT8495 2D Mini Barcode Scanner User Guide

MARSON MT8495 2D Mini Barcode Scanner

WARNING AND CAUTION

1. Take any metals into contact with the terminals in connectors.

2. Use the scanner where any inflammable gases.

If following condition occur, immediately power off the host computer, disconnect the interface cable, and contact your nearest dealer.

1. Smoke, abnormal odors or noises come from the scanner.

2. Drop the scanner so as to affect the operation or damage its housing.

Do not do behavior below.

1. Put the scanner in places excessively high temperatures such as expose under direct sunlight.

2.  Use the scanner in extremely humid area or drastic temperature changes.

3.  Place the scanner in oily smoke or steam environment such as cooking range.

4.  Be covered or wrapped up the scanner in bad-ventilated area such as under cloth or blanket.

5. Insert or drop foreign materials or water into scanning window or vents.

6. Using the scanner while hand is wet or damp.

Do Not 7. Use the scanner with anti-slip gloves containing plasticizer and chemicals or organic solvents such as benzene, thinner, insecticide etc

to clean the housing. Otherwise, it could not result fire and electrical shock but housing may be broken and injured.

8. Scratch or modify the scanner and bend, twist, pull or heat its interface cable.

9. Put heavy objects on interface cable.

Do not stare the light source from the scanning window or do not point the scanning window at other people’s eyes or eyesight may be damaged by direct exposure under the light.

Do not put the scanner on an unstable or inclined plane. The scanner may drop, creating injuries.
Once the interface cable is damaged such as exposed or broken copper wires, stop using immediately and contact your dealer. Otherwise, it could result fire or electrical shock.

OUT OF THE BOX

INTRODUCTION

SPECIFICATIONS

• Light source White LED, Visible red LED
• Scan rate 30 Frames/sec
• Sensor 640 x 480
• Resolution 5mil (1D) / 10mil (2D)
• PCS 25%
• Housing PC
• Interface USB HID, USB VCP
• Voltage 5 VDC ± 5%
• Current < 220 mA(Working); < 95 mA(Standby)
• Operating Temp 0 to 60°C (32 to 140°F)
• Storage Temp -40 to 70°C (-40 to 158°F)
• Symbologies All major 1D & 2D barcodes

GETTING STARTED

To scan a barcode, make sure the aiming beam fully covers the barcode.

BEEPER INDICATION

• Single beep Good read
• Two beeps The scanner successfully reads a configuration barcode
• Four beeps Power up

GENERAL SETTINGS

INTERFACE

TERMINATOR

READING MODE

KEYBOARD LAYOUT

SYMBOLOGIES

INVERSE BARCODE

BEEPER

CAPSLOCK

TEST BARCODES

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>