JULA 605010 Car Seat Covers Instructions

: June 5, 2024
: JULA

Table of Contents

JULA 605010 Car Seat Covers
SAFETY INSTRUCTIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JULA 605010 Car Seat Covers

SAFETY INSTRUCTIONS

Read these instructions carefully before use!
Warning! Not permitted for use in cars with seat airbags.

DESCRIPTION

The rear seat cover consists of a backrest part and a seat part.
Both parts consist of a base and two side parts. All base and side parts are marked as follows on the back to simplify fitting.

1.1 – 1.4 Backrest, top
1.5 – 1.6 Side parts
2.1 – 2.4 Backrest, bottom
2.5 – 2.6 Side parts
3.1 – 3.4 Seat, back
3.5 – 3.6 Side parts
4.1 – 4.4 Seat, front
4.5 – 4.6 Side parts
5 – Headrest
6 – Base part, backrest
7 – Base part, seat

ASSEMBLY

Step
Removing the headrest. (You will find information on how to do this in the service handbook for your vehicle, or contact your dealer.)
Step
Start by pulling the cover over the backrest.
Step
Pull the loop on the cover through the gap between the seat and the backrest.
Step
Fasten the loop on the backrest part on the Velcro seal on the back of the cover.
Step
Pull the seat part on the cover over the seat.
Step
Pull the stretch surface on the seat cover through the gap between the seat and the backrest.
Step
Fasten the hook under the seat.
Step
Mark the openings for the headrest holders on the top of the cover. Cut small holes in the cover with a sharp knife and fit the headrest.
Step – Divided seats
Check if the rear seat can be divided. It can be divided in different ways:
NOTE:
If the rear seat cannot be divided you will not need the side parts. We recommend, however, that you save them and any other parts for future use.
Step – Headrest
Remove the headrest.
(You will find technical information on how to do this in the service handbook for your vehicle, or contact your dealer.)
Step – Fitting the rear seat covers
Start with the seat part. Establish the width of the rear seat cover by spreading the whole base part on the seat in the car. This will easily allow you to see which middle strips must be removed to adjust the cover to the rear seat. Remove the middle strips not needed by opening the zips. The rear seat cover is already prepared for the maximum width of a car.
Combinations
By removing the middle strip or and for smaller cars + , the rear seat cover can be adjusted to the width of the seat.
Step – Fitting the side parts
Divide the supplied side parts by fully opening the zips and connecting a side part to the base part (see diagram).
Step – Finishing off
Pull the finished parts over the car seat and fasten the parts under the seat by pulling the supplied strap fastener through the rubber loops. Stretch the strap and tie up.
Step – Fitting the headrest cover
Mark the openings for the headrest holders on the top of the cover. Cut small holes in the cover with a sharp knife and fit the headrest (see also item 8 in these instructions).