HZPOWEN Q25B TWS Bluetooth Earbuds Instruction Manual
- June 5, 2024
- HZPOWEN
Table of Contents
Instruction Manual
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC Statement : This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Please read the instructions before use
Hello:
If the product has any problems, please contact us on Amazon in time. We
promise to give you the best service
Active 2-Year Warranty
Scan the code and enter the website (xtikland.com) to activate the warranty.
Before Use
-
Remove the protective film before charging.
-
Fully charge the earbuds and charging case.
-
Choose the right angle and ear tips.
Connect
- After opening the phone Bluetooth, Click the
to Pairing - Take out the earbuds (Earbuds auto power on)
Reset
If the earbuds have any connection or function problems, please reset the earbuds
- Delete the BT pairing information on the phone.
- Take the earbuds into the charging case to charge.
- Take out the earbuds and wait for seconds.
(If the above operation does not work, please try again)
Operation
X1 : Click Once
X2 : Click times
2S ： Press and hold for seconds
Battery Indicator
| Pairing | Connected | Charging |
|---|---|---|
| Flashing | No Light | Red |
Wipe and dry charging contacts if earbuds can’t be charged.