CANYON LRG-CMT313 Microphone Instruction Manual
- June 5, 2024
- CANYON
Table of Contents
CANYON LRG-CMT313 Microphone
FEATURES:
- Frequency Response: 80 Hz—17 kHz
- Sensitivity: -40 dB ± 3 dB
- S/N Ratio: > 70 dB A+
- Recording format: 16bit
- Electrical Current: 35 mA ± 5 mA
- Nickel-plated diaphragm
- Plug and Play system
- Cardioid polar pattern
- Volume knob
- Echo knob
- Dimensions: 47.4 x 158.2 x 48.1 mm.
- Compatible with Mac, Windows, Android and PlayStation
- Supports Discord, OBS, FL Studio etc
PACKAGE CONTENT
INTRODUCTION
This device is operating on the principle “Plug and Play”. Please connect or
insert necessary device with correct port.
Please turn the volume down when plugging the microphone into the USB port,
and gradually increase the volume to an ideal level.
-
Volume up:
Clockwise (Turn right) -
Volume down:
Counter-clockwise (Turn left) -
Mute:
Counter-clockwise (Turn left to the maximum turning point)
Make sure the front of the microphone points towards your mouth.
- Unscrew the threaded metal ring from the microphone, install the pivot mount, and screw the threaded metal ring.
- Screw the pivot mount on to the top of the metal desk stand.
- If necessary, adjust the microphone angle with the pivot mount thumbscrew. (turn left for loosening, turn right for tightening)
- Please swing the microphone clockwise, swing the microphone counterclockwise will damage the pivot mount.
- Screw the threaded metal ring to adjust microphone angle 360° horizontally.
PLUG & PLAY
Plug the USB cable into the USB port of your computer. Your computer will automatically recognize the USB device and install a driver. The driver will be installed automatically. If the microphone is not picking up sound, please follow the instuctions below:
| Problem | Solution |
|---|---|
| A computer couldn`t identify the USB devices | Please restart a computer and |
connect the microphone to another USB port.
The microphone is detected but no output of the sound| Make sure that System
Sound isnt mute and you havent set a microphone volume to minimum.
The microphone is detected but no output of the sound after updating Windows
10| To let apps access the microphone, please select
Settings>Privacy>Microphone,
then turn on Allow apps to access your microphone.
SAFETY INSTRUCTIONS
Read carefully and follow all instructions before using this product.
- Do not expose the device to excessive moisture, water or dust. Do not install in rooms with high humidity and dust level.
- Do not expose the device to heat: do not place it close to heating appliances, and do not expose it to direct sun rays.
- Clean the device with dry cloth only.
WARNING
It is forbidden to dismantle the device. Attempt to repair this device is not
recommended and leads to warranty waste.
WARRANTY
The warranty period starts from the day of the product purchase from Lorgar
authorized Seller. The date of purchase is the date specified on your sales
receipt or on the waybill. During the warranty period, repair, replacement or
refund for the purchase shall be performed at the discretion of Lorgar. In
order to obtain warranty service, the goods must be returned to the Seller at
the place of purchase together with proof of purchase (receipt or bill of
lading). 2 years warranty from the date of purchase by the consumer. The
service life is 2 years. Additional information about the use and warranty is
available at https://lorgar.eu/warranty-terms/
Manufacturer: Asbisc Enterprises PLC, 43, Kolonakiou Street, Diamond Court
4103 Ayios Athanasios