LAUREL CANYON HD-S0808 Gray Peak Style Portable Storage Shed Garage without Floor with Easy-Slide Rail System Instruction Manual
- June 4, 2024
- LAUREL CANYON
Table of Contents
INSTRUCTION MANUAL
We recommend you take down this shed during extreme weather.
HD-S0808 Gray Peak Style Portable Storage Shed Garage without Floor with
Easy-Slide Rail System
PART LIST
PART CODE| Description| Qty ( PC)
1| Roof tube| | 6
2| T-tube| | 6
3| Leg tube| | 2
4| Leg tube| | 4
5| Base tube| | 4
6| Base tube| | 4
A| Four-way connector| | 3
B| Three-way connector| | 6
C| Base| | 2
D| Brace part 1| | 8
E| Brace part 2| | 4
F| Pegs| | 8
I| Plastic marbles| | 28
G| Tool| | 2
H| Bolt M6x45mm| | 10
12| Rear cover| | 1
14| Door cover| | 1
J| Roof cover| | 1
K| Roof Fastener (winch system)| | 4
Assembly
- Remove all parts from the box and dispose of all packaging correctly.
- Check that you have all the parts listed before starting. Assemble the shed on a flat-level surface.
- We recommend that 2 people assemble this shed.
- Assemble it where you intend to place it.
Step 1
Step 2
Step 3
Attach the roof cover J onto the frame as shown, then insert tube (5) through
the sleeve at the base of the cover. Connect both ends to parts 3, with brace
part E and bolt H, see Figure A. 
Step 4
At the other end of part 5 tubes, secure to leg tubes, part 4, using brace
parts D and bolt H, see Figure B.
Step 5 Fit rear cover 12 and door cover 14 using plastic marbles. Connect
and fit parts C bases to each leg tube part 3. Secure with bolts H and pegs F,
see Figure C 
Figure D suggestion: put the four corners’ bottom fabric of the door cover and rear cover under the base tube 6 same as the last image is shown in step 6 to prevent it from moving, then secure the frame and bottom fabric by inserting the pegs to the inside hole on base tube 6.
Step 6
Assemble the fastener, put the rope head of the roof through the central hole
(A) of the reef shaft in the middle of the fastener, and then press the double
antennae of the fastener back and forth. When the length is moderate, hang the
hook at the hole at the end of the curved pipe, and then press the double
antennae B back and forth to achieve the compact effect of the roof.
Note:
- At the beginning of the assembly, do not pull the rope at one end to avoid the rope being pulled out or pulled into the cloth bag;
- When tightening, pay attention to the appropriate tightness to avoid breaking the clot or breaking the rope;
- When fastening, pay attention to the consistency of the width and size of the eaves at both ends;
- When fastening the rope on the same side, pay attention to the same tightness at both ends of the same rope
Step 7
To loosen the fastener. First press and hold position C with one hand, then
unfold the double antennae of the fastener into a straight line and pull the
end of the rope connected with the shed roof with the other hand. In this way,
remove the hook and operate it on several other accessories. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>