bioBidet DIB Special Edition Advanced Bidet Toilet Seat Owner’s Manual
- June 5, 2024
- Biobidet
Table of Contents
bioBidet DIB Special Edition Advanced Bidet Toilet Seat Owner's Manual
PRODUCT INFORMATION
SAFETY PRECAUTIONS
THIS UNIT WAS MANUFACTURED FOR HOUSEHOLD USE ONLY.
READ ALL OPERATING INSTRUCTIONS BEFORE INSTALLATION.
- This product should be installed according to this manual.
- Please read this manual carefully and install properly.
- Please save this manual and place in easily accessible location.
- Do not attempt to service this appliance yourself.
Doing so will void warranty.
IMPORTANT SAFETY GUARDS
- In the case 120V 60 Hz: Power supply must be a 15 Amp GFCI outlet.
- The electrical cord must be connected to a GFCI outlet.
- The GFCL outlet should be 1ft. above the floor.
- Install only in well-ventilated areas to avoid excess humidity.
- Do not install in narrow toilet stalls or in shower stalls.
- Install only where direct contact with water is minimized.
- Do not install near any heat source.
- Avoid using extension cords if possible. Consult with a certified electrician where extension cords are necessary.
DANGER – TO REDUCE THE RISK OF ELECTROCUTION
- Do not use while bathing.
- Do not place or store product where it can fall or be pulled into a tub or sink
- Do not place in or drop into water or other liquid.
- Do not reach for a product that has fallen into water. Unplug immediately
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS
-
Close supervision is necessary when this product is used by, on, or near children or invalids.
-
Use this product only for its intended use as described in this manual.
Do not use attachments not recommended by the manufacturer. -
Never operate this product if it has a damaged cord or plug, if it is not working properly, has been dropped or damaged, or dipped into water.
Return the product to a service center for examination and repair. -
Keep the cord away from heated surfaces.
-
Never drop or insert any objects into any opening or hose.
-
Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
-
Connect this product to a properly grounded outlet only. See grounding instructions.
-
Unplug this product before filling. Fill (reservoir) with water only
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
DANGER – IMPROPER USE OF THE GROUNDING PLUG CAN RESULT IN A RISK OR ELECTRIC SHOCK
This product has a three-prong grounding plug, which must be plugged into an outlet that is properly installed and rounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade terminal. The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire. Check with a qualified electrician or service person if the grounding instructions are not completely understood, or if in doubt as to whether the product is properly grounded.
This product is for use on a nominal 120V circuit, and has a grounding plug that looks like the plug illustrated in sketch A in Figure 1. A temporary adapter, which looks like he adapter illustrated in sketches Band C, may be used to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded outlet is not available.
The temporary adapter should be used only until a properly grounded outlet (sketch A) can be installed by a qualified electrician. The green colored rigid ear, lug, or the like extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held place by the screw.
Figure 1
OPTIONAL GROUNDING INSTRUCTIONS
PRODUCT FEATURES
UNIT & PARTS
DIMENSIONS
REMOTE CONTROL
PRODUCT INSTALLATION
INSTALLATION
REMOTE CONTROL INSTALLATION
TRIAL OPERATION
PRODUCT DISASSEMBLY
OPERATION
TROUBLESHOOTING
SETTINGS
Using Inline Carbon Filter
Use of external water filter is only recommended in areas with known hard water issues. If a filter is used, it must be replaced every 3 months. This product is designed and intended for use exclusively with Bio Bidet DIB water filters. The purchase or use of any other water filter is not the responsibility of BBC Innovation LLC. As such, any use of non DIB water filters is prohibited and will void the warranty for those Bio Bidet products. Bio Bidet will not be responsible for any resulting damages or claims related to the misuse or distribution of non Bio Bidet DIB filters.
MAINTENANCE & CLEANING
SPECIFICATIONS
TROUBLESHOOTING
Please check the following points before requesting the repair of the product.
WARRANTY
3 YEAR WARRANTY
Bio Bidet warrants its products to be free from manufacturing defects under normal use and service for a period of 3 year from the date of purchase. This warranty is extended only to the original purchaser.
For full warranty details, visit www.biobidet.com
Contact Bio Bidet customer support with any questions you may have.
847.458.2334
support@biobidet.com
www.biobidet.com
Thank You
Technical Support/Customer Service
7900 S Route 31 Crystal Lake, IL 60014
T: 847.458.2334
U.S. TOLL FREE: 877.339.5214
support@biobidet.com
www.biobidet.com