EDIFIER NeoBuds S True Wireless Noise Cancelling ln-Ear Headphones User Manual

EDIFIER NeoBuds S True Wireless Noise Cancelling ln-Ear Headphones User Manual

Power ON/OFF

1. Power ON when the case is opened.
2. Power OFF when placed in the case and the case is closed.

Pairing

1. Placed in the case.
2. Press and hold the button on the case for around 3s. LEDs will be lit one by one from left to right in a circulating pattern.
3. Select “EDIFIER NeoBuds S” in your device setting to connect.

1st Pairing

1. Open the case. LEDs will blink from left to right.
2. Select “EDIFIER NeoBuds S” in your device setting to connect.

Note:

For subsequent use, the earbuds will auto-connect to device used last time

Left & Right connection/Reset 

1. Placed in the case.
2. Press 3 times the button on the case to enter left & right connection and to clear pairing records.
3. LEDs will be lit one by one from sides to center in a circulating pattern.
4. After the earbuds are connected, it will enter pairing mode automatically.

Controls

Note:

1. Both Earbuds mode switch: High noise cancellation mode & ambient sound mode.
2. Single Earbud mode switch: Normal mode & ambient sound mode.
3. Customized controls via Edifier Connect App.
4. Images are for illustrative purposes only and may differ from the actual product.

Brand App

Edifier Connect

Note:
Images are for illustrative purposes only and may differ from the actual product.

Snapdragon Sound is a product of Qualcomm Technologies, Inc. and/or its subsidiaries. Snapdragon and Snapdragon Sound are trademarks or registered trademarks of Qualcomm Incorporated.

FCC statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IC statement:CAN ICES-003(B) / NMB-003(B).
FCC ID: Z9G-EDF178
IC: 10004A-EDF178

Hereby, Edifier International Limited declares that the radio equipment type
EDF200068 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.edifier.com/int/eu-doc.html

Model: EDF200068
Edifier International Limited
P.O. Box 6264
General Post Office
Hong Kong
www.edifier.com
2022 Edifier International Limited. All rights reserved. Printed in China

NOTICE:

For the need of technical improvement and system upgrade, information contained herein may be subject to change from time to time without prior notice.

Products of EDIFIER will be customized for different applications.

Pictures and illustrations shown on this manual may be slightly different from actual product.

If any difference is found, the actual product prevails. IB-200-NEOBUS-00 V1.0

FCC Regulatory Compliance

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

ISED Regulatory compliance

This device contains licence-exempt transmitters that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference.

This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.

For more information, please visit our website:

http://www.edifier.com/

Facebook: @Edifierglobal
Instagram: @Edifier_Global
Twitter: @Edifier_Global

References

• Headphones, Speakers | A Passion for Sound -【Edifier】

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>