smartbitt SBAVRC-2000 Automatic Voltage Regulator User Manual
- June 5, 2024
- smartbitt
Table of Contents
**smartbitt SBAVRC-2000 Automatic Voltage Regulator User Manual
**
Introduction
This AVR series is designed to automatically maintain a constant voltage level to protect sensitive electronics from brownouts and over voltages. Equipped with comprehensive information display, it’s easy to monitor the power status.
- Microprocessor control guarantees high reliability
- Time delay function eliminates transients that can affect connected equipment.
- Over-voltage, under-voltage, over-heat and over current protection
- Provides surge and spike suppression
Product Overview
-
Side View
-
Back View
- Power switch
- Handle
- Power LED (Green)
- AVR LED (Yellow)
- Fault indicator (Red)
- Output sockets
- AC input
Important Safety Caution (SAVE THESE INSTRUCTION)
To safely operate this AVR, please read and follow all instructions carefully. Read this manual thoroughly before attempting to unpack, install, or operate. You may keep this quick guide for further reference.
CAUTION: The unit is designed only for use under pure sine wave environment. Any other waveform will effect the voltage range and load capability.
CAUTION: Please DO NOT connect the unit to the environment with direct voltage (DC) or simulated sine wave.
CAUTION: To prevent the risk of fire or electric shock, install in a temperature and humidity controlled indoor area free of conductive contaminants. (See the specifications for the acceptable temperature and humidity range.)
Installation
Inspection
Remove the AVR from the shipping package and inspect the unit. Be sure that nothing inside the package is damaged.
Placement
Please install the AVR in a protected environment.
- Do NOT block the top or side air vents on the unit. Please reserve 20cm space to avoid interference.
- Do NOT operate the AVR where the temperature and humidity is outside the specific limits. (Please check the specs for the limitations.)
Connect To Utility
Plug the unit into a 3-wire grounded receptacle.
Connect Your Equipment
Plug equipment into the AVR rear-panel outlets. Then, switch the unit on by press the front panel power switch to “RESET” position.
CAUTION: The total power consumption of all equipment plugged into the AVR must not exceed its capacity (Refer to spec). It may cause the breaker to fault (blow).
Applications
CAUTION: The total power consumption of all equipment plugged into this AVR must not exceed its capacity. A total load in excess of its capacity will cause the breaker to fault (blow) For the capacity of unit, please check the specifications. This AVR is designed for use with voltage sensitive equipment such as: a home computer, monitor, inkjet printer, scanner or fax. It is also designed for use with home electronics equipment such as television, stereos, CD players, VCRs, and DVD players, data processing equipment, modems, typewriters, calculators, and telephone equipment. When startup delay time is et up as 3 minutes, it’s perfect to use with devices such as refrigerators, freezers, air conditioners or dehumidifiers. When using this AVR with an Uninterruptible Power Supply (UPS), connect the UPS to the output of this product, then connect this product to the wall outlet..
Specification
Model | SBAVRAC2000 |
---|---|
Capacity | 2000VA/1200W |
Input
Voltage| 120 VAC
Voltage Range| 80-150 VAC
Frequency Range| 60 Hz
Output
Output Voltage| 120VAC
Voltage Regulation| -10% ~ +10%
Efficiency
Normal Mode| 93%
AVR Mode| 91%
Physical
Dimension (DxWxH)| 196.8 x 110 x 123.5 mm
Net Weight (kgs)| 4.31
Environment
Temperature| 0-40°C
Humidity| 0-90% relative humidity (Non-condensing)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>