Drok 200572 DC Adjustable Boost Converter Module Instruction Manual

June 5, 2024
Drok

200572 DC Adjustable Boost Converter Module

Parameters:

Input Voltage: DC 6-30V Output Voltage: DC 7-32V adjustable

  • NTE: This module can only be used to boost voltage, and the output voltage must be at least 1.5V higher than the input voltage. Output Current:5A(max),adjustable commended to use within 4A.
  • NOTE: If the output current or power is more than 3A or 35W, you’d better enhance the heat dissipation. Output Power: 60W (max), recommended using within 50W.
  • NOTE: Please reduce the power when the difference between input and output voltage is large. Operating Temperature: -20—+70°C
  • NOTE: Pay attention to the temperature of the power tube when using this module, please strengthen heat dissipation if it exceeds 70°C.
    Conversion efficiency: Up to 96%
    Installation: Nylon post 8, 3mm screw 8
    Wiring: Terminals or solder terminals; VIN means input; VOUT means output.
    Dimension:L69.5mm(2.74in),W43.5mm(1.71in),H26.5mm(1.04in).

Drok 200572 DC Adjustable Boost Converter Module

Protections:

Short circuit protection: Yes (currently constant current value) Over temperature protection: Yes (automatically turn off the output if over- temperature)
Tips: There is an additional fan opening on the bottom of the module shell, which can be used to add a fan.
Input reverse polarity protection: Yes
Output anti-backflow: Yes

Drok 200572 DC Adjustable Boost Converter Module - fig
Front View of the Module:
Voltage Calibration:
If you find that the measuring values are not accurate, please do as follows:

  • In the condition of power off, hold press the ” SET” button and power on to enter the voltage calibration mode, at this time the LCD screen starts to flash.
  • Then release the ” SET ” button, and press the ” SET ” button to increase the voltage value while pressing the “ENT” button to reduce, it till the input voltage value is correct. e.g. If the input voltage is 12.65V, adjust the voltage value to 12.65V.
  • It will automatically be saved after 2 seconds, then power off the module to finish calibrating.

Display Description & Setting:

“SET” button for 3 display modes:

  • F-0 mode: Display output voltage
  • F-1 mode: Display input voltage
  • F-2 mode: Alternately display input and output voltage

Instructions:
Press the “SET” button, and the 3 display modes would be displayed cyclically, and the corresponding indicator would be on or off, press the ” ENT ” button to save and exit. Turn on/off the LCD backlight by singly pressing the “ENT” button.

Drok 200572 DC Adjustable Boost Converter Module -
fig3Drok 200572 DC Adjustable
Boost Converter Module - fig1Drok 200572 DC Adjustable Boost Converter Module -
fig2Drok 200572 DC Adjustable
Boost Converter Module - qr codehttps://www.amazon.com/stores/DROK/page/AEB10E82-8554-4FC1-BBD0-354046DAE77C?ref_=ast_bln
https://www.amazon.com//DP/B07JZ2GQJF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals