Targus KM001 Wireless Keyboard and Mouse Combo User Guide
- June 5, 2024
- Targus
Table of Contents
KM001 Wireless Keyboard and Mouse Combo
User Guide
Specifications summary
Keyboard
| Keyboard Partition | Three areas |
|---|---|
| Keys spec | 104 keys, 8 media keys |
| Interface | 2.4GHz Wireless |
| Weight | 460g |
| Dimensions | 434 X 143 X 23.4mm |
| System Requirements | Windows98/SE/ME/2000/XP/VISTA/WIN7/WIN8/WIN10/WIN11 |
| Power Consumption | 3V 20MA |
Mouse
| Button | 3 Keys |
|---|---|
| Resolution | Wireless 1200DPI/1200DPI |
| Interface | 2.4 GHz Wireless |
| Weight | 57.15 ± 5g |
| Dimensions | 103 X 60 X 34.45mm |
| System Requirements | Windows98/SE/ME/2000/XP/VISTA/WIN7/WIN8/WIN10/WIN11 |
| Power Consumption | 1.5V 30MA |
Installing the batteries
-
Insert three batteries (two AAA batteries for the keyboard and one AA battery for the mouse) into the battery slots of your keyboard and mouse.
-
Insert the bundled USB dongle into your computer’s USB port. It takes about ten seconds for the system to automatically connect to your wireless keyboard and mouse.
Your keyboard and mouse is set
at the factory to automatically connect to the system. There’s no dedicated
pairing button, so no manual pairing is required.
Keyboard hotkeys
| Play/Pause
Stop
Previous
Next
Volume down
Volume Up
Mute
Calculator
---|---
DPI switching mode
Bean Mouse DPI switching mode: After the mouse is powered on, press and hold
the left and right buttons for 3 seconds to enter DPI switching:
First stage is 1000 DPI, the red LED at the top flashes once, on for 100ms,
and off for 100ms.
Second stage is 1200 DPI, The top red LED flashes twice, on for 100ms/off for
100ms.
The third stage is 1600 DPI, the top red LED flashes 3 times, on for 100ms/off
for 100ms.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
FCC STATEMENT
Changes or modifications not expressly approved by the party responsible or
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>