KOHLER 3255554 ClearFlo Plastic Toe Tap Drain Installation Guide
- June 6, 2024
- Kohler
Table of Contents
KOHLER 3255554 ClearFlo Plastic Toe Tap Drain
TOOLS
Plus
PVC Primer and Cement
CAUTION: Risk of property damage.
Leaky drain connections will damage property. Ensure that a watertight seal
exists on all drain connections.
Important Information
To perform a pressure test on a drain waste vent and water supply lines, order
a seal test kit [K-7117]. Perform the pressure test before covering the
plumbing with wall material.
Important Information
If possible, install the drain before installing the bath.
Hand tighten the overflow nut to avoid cross-threading.
Observe all local plumbing and building codes.
Installation Guide
- To measure the pipe lengths before cutting, dry fit the overflow components to the bath.
- Dry fit the drain ell.
- Insert the pipe into the overflow. Draw a line on the pipe level with the bottom of the drain ell.
- Mark a line 2-1/8″ (54 mm) above the first line.
- Remove the pipe from the bath and cut at the second marked location.
- Using the tee for a measurement, mark the pipe to fit into the tee and the ell about 5/8″ (16 mm).
- Remove the pipe from the bath and cut at the marked location.
- Check for a proper fit.
- Remove the overflow and drain ell from the bath.
- Apply silicone sealant to the overflow gasket.
- Using the overflow mounting plate, reattach the overflow to the bath.
- Apply plumbers putty to the flange and 100% silicone sealant to the gasket.
- Secure with the flange.
- Apply PVC primer and cement to the pipes.
- Connect the drain pipes and waste pipe to the tee and the drain ell.
- Attach the overflow cover and install the stopper.
- Allow the sealant to cure. Fill the bath past the overflow and check for leaks.
Finish/color code must be specified when ordering.
ONE-YEAR LIMITED WARRANTY
KOHLER plumbing products are warranted to be free of defects in material and
workmanship for one year from date of installation.
Kohler Co. will, at its election, repair, replace or make appropriate
adjustment where Kohler Co. inspection discloses any such defects occurring in
normal usage within one (1) year after installation. Kohler Co. is not
responsible for removal or installation costs. Use of in-tank toilet cleaners
will void the warranty.
To obtain warranty service contact Kohler Co. either through your Dealer, Plumbing Contractor, Home Center or E-tailer, or by writing Kohler Co., Attn.: Customer Care Center, 444 Highland Drive, Kohler, WI 53044, USA, or by calling 1-800-4-KOHLER (1-800-456-4537) from within the USA and Canada, and 001-800-456-4537 from within Mexico, or visit www.kohler.com within the USA, www.ca.kohler.com from within Canada, or www.mx.kohler.com in Mexico.
IMPLIED WARRANTIES INCLUDING THAT OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE EXPRESSLY LIMITED IN DURATION TO THE DURATION OF THIS
WARRANTY. KOHLER CO. AND/OR SELLER DISCLAIM ANY LIABILITY FOR SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states/provinces do not allow
limitations on how long an implied warranty lasts, or the exclusion or
limitation of special, incidental or consequential damages, so these
limitations and exclusions may not apply to you. This warranty gives you
specific legal rights.You may also have other rights which vary from
state/province to state/province.
This is Kohler Co.’s exclusive written warranty.
SERVICE PARTS
For service parts information, visit
www.kohler.com/serviceparts
For copies of our literature, call our Customer Care Center: 1-800-4KOHLER
(1-800-456-4537).
For care and cleaning and other information go to:
www.us.kohler.com
USA/Canada: 1-800-4KOHLER
Mexico: 001-800-456-4537
www.kohler.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>