CONSERVATOR VFX17UW Freezer 17 Cf Chest White Owner’s Manual

CONSERVATOR VFX17UW Freezer 17 Cf Chest White

Product Information

The product is a freezer with a lid that has wire baskets, a wire divider, control panel, defrost drain, and rollers. The appliance should be defrosted approximately twice a year or when a 6 mm (1/4 inch) layer of frost has formed. The exterior defrost drain cap is located on the front of the cabinet. It comes with important safety information such as not adding a lock to the door or lid to avoid child entrapment and harm. It should not be connected to extension cords or together with another appliance in  the same wall outlet.

Product Usage Instructions

Defrosting

1. Turn the appliance control knob to the 0 position and unplug the power cord. Remove all contents and leave the lid open.
2. The interior defrost drain is located on the inside floor of the cabinet. Remove the cover from the defrost drain. Defrosted water will flow into the hole and out through the exterior defrost drain cap.
3. The exterior defrost drain cap is located on the front of the cabinet. Turn the cap with a coin or flat-bladed screwdriver and then gently pull out until the water hole is visible.
4. Twist the exterior drain cap so that the arrow points downward. Place a bucket or pan under the drain cap to catch defrosted water. Check the appliance regularly during defrosting to ensure that the water is not overflowing.
5. When all water has been drained, twist the drain cap until the arrow is pointing upwards and then push inward until it is flush with the cabinet.
6. Replace the cover in the interior defrost drain.
7. After defrosting is complete, set the temperature control to maximum for 2 to 3 hours before returning to the desired temperature setting.

Care and Maintenance

Ensure the appliance is unplugged before cleaning. Do not use cleaners containing ammonia or alcohol on the appliance. Ammonia or alcohol can damage the appearance of the appliance. Never use any commercial or abrasive cleaners or sharp objects on any part of the appliance. For vacations, unplug the appliance and remove all items. When moving the appliance, secure all loose items and tape down all doors and lids. During a power failure, minimize the number of times the lid is opened to avoid affecting the temperature of the appliance. If the power is going to be off for a longer period of time, take the proper steps to protect your contents. Wait 3 to 5 minutes before attempting to restart the refrigerator if operation has been interrupted.

Energy Saving Tips

The appliance should be located in the coolest area of the room, away from heat producing appliances, and out of direct sunlight. Do not overload the unit or block any ventilation openings.

SAFETY REQUIREMENTS

• DANGER: Risk of fi re or explosion. Flammable refrigerant used. Do not puncture refrigerant tubing.
  • Do not use mechanical devices to defrost refrigerator.
  • Ensure that servicing is done by factory authorized service personnel, to minimize product damage or safety issues.
  • If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similar qualifi ed person in order to avoid hazard.
  • Consult repair manual or owner’s guide before attempting to service this product. All safety precautions must be followed.
  • Dispose of properly in accordance with federal or local regulations.
  • Follow handling instructions carefully.
  • Do not store explosive substances such as aerosol cans with a fl ammable propellant in this appliance.
• WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
• WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• WARNING: Do not damage the refrigerant circuit.
• WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
• CAUTION: Children should be supervised to ensure that they do not play with the appliance.
• DANGER: Risk of child entrapment. Before throwing away an old appliance:
  • Remove the door or lid.
  • Leave shelves in place so that children may not easily climb inside.
• DANGER: Do not add a lock to the door or lid. This can cause child entrapment and harm.
• This appliance is not intended for use by persons (including children) whose physical, sensory or mental capabilities may be different or reduced, or who lack experience or knowledge, unless such persons receive supervision or training to operate the appliance by a person responsible for their safety.
• This appliance is intended to be used in household and similar applications such as:
  • Staff kitchen areas in shops, offi ces and other working environments;
  • Farm houses and by clients in hotels, motels and other residential type environments;
  •  Bed and breakfast type environments;
  • Catering and similar non-retail applications.

GROUNDING INSTRUCTIONS

• This appliance must be grounded. Grounding reduces the risk of electrical shock by providing an escape wire for the electrical current.

• This appliance has a cord that has a grounding wire with a 3-prong plug. The power cord must be plugged into an outlet that is properly grounded.

• If the outlet is a 2-prong wall outlet, it must be replaced with a properly grounded 3-prong wall outlet. The serial rating plate indicates the voltage and frequency the appliance is designed for.
  WARNING – Improper use of the grounding plug can result in a risk of electric shock.

• Consult a qualifi ed electrician or service agent if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

• Do not connect your appliance to extension cords or together with another appliance in the same wall outlet. Do not splice the power cord.

• Do not under any circumstances cut or remove the third ground prong from the power cord. Do not use extension cords or ungrounded (two prongs) adapters.

INSTALLATION INSTRUCTIONS

LOCATION

• Two people should be used when moving the appliance.
• Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a soft, dry cloth and the inside with a lukewarm wet cloth.
• Place the appliance on a floor that is strong enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this can increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance to perform improperly.
• Do not use the appliance near water, for example, in a wet basement or near a sink.
• This appliance is intended for indoor household and garage use only. Freezers are tested to perform in temperatures ranging from 0°F to 110°F (-17°C to 43°C). It is not designed for outside installation, including anywhere that is not temperature controlled such as porches, vehicles, etc.
• Before connecting the appliance to a power source, let it stand upright for approximately 6 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Allow 12.7 cm (5 inches) of space between the back and sides of the appliance and all adjacent walls.
• This appliance is intended for free-standing installation only and is not intended to be built into a cabinet or counter. Building in this appliance can cause it to malfunction.

OPERATING INSTRUCTIONS

FEATURES

1. Handle
2. Lock
3. Wire baskets
4. Wire divider
5. Control panel
6.  Defrost drain
7. Rollers

I MPORTANT NOTE

• The freezer lid may be difficult to open immediately alter closing it. This is normal and is due to the pressure difference between the cold interior of the freezer and the warm air that has just entered the freezer when the lid was opened. The pressure will equalize within a few minutes.
• If the lid is especially difficult to open, wait 5 minutes to allow the pressure to equalize and then try again.

OPERATING INSTRUCTIONS

TEMPERATURE CONTROL

1. Po w er indicator light: Illuminates when the appliance is connected to a working power source.
2. Run indicator  light: Illuminates when the compressor is running.

The temperature of the appliance is controlled by setting the thermostat dial on the front of the cabinet.

• The number 1 indicates the warmest setting.
• The number 7 indicates the coldest setting.
• The number 4 setting should be sufficient for regular home use.
• The temperature range of the appliance is approximately – 12 ~ -24°C (10.4 ~ – 11.2°F).
• To stop the cooling function, turn the dial to the “O” position.

Important:

• The temperature inside the appliance can vary based on ambient room temperature, the frequency that the lid is opened and the amount of fresh food that has recently been added to the appliance.
• Do not overload the appliance as this can affect performance.
• Do not freeze large quantities of fresh food at the same time.

DOOR HANDLE INSTALLATION

1. Remove the handle base, the handle cover and the screws from the accessory bag. Remove the screw hole plugs from the lid and attach the handle base to the lid using the screws.
2. Insert one end of the handle cover into the side of the handle base.
3. Insert the other end of the handle cover into the handle base.
4. Press the handle into the base until it clicks. Repeat this process for both handles.

DEFROSTING

• This appliance should be defrosted approximately twice a year or when a 6 mm (1/4 inch) layer of frost has formed.
• Turn the appliance control knob to the “O” position and unplug the power cord. Remove all contents and leave the lid open. Follow the instructions below:
  1. The interior defrost drain is located on the inside floor of the cabinet. Remove the cover from the defrost drain. Defrosted water will flow into the hole and out through the exterior defrost drain cap.
  2. The exterior defrost drain cap is located on the front of the cabinet. Turn the cap with a coin or flat-bladed screwdriver and then gently pull out until the water hole is visible.
  3. Twist the exterior drain cap so that the arrow points downward. Place a bucket or pan under the drain cap to catch defrosted water. Check the appliance regularly during defrosting to ensure that the water is not overflowing.
  4. When all water has been drained, twist the drain cap until the arrow is pointing upwards and then push inward until it is flush with the cabinet.
  5. Replace the cover in the interior defrost drain.
• After defrosting is complete, set the temperature control to maximum tor 2 to 3 hours betore returning to the desired temperature setting.

IMPORTANT
Never use electrical appliances during defrosting. Do not use pointed or sharp objects to remove frost as this can damage the refrigerant lines. If these lines are accidentally pierced it will render the freezer inoperable and void the manufacturer’s warranty.

CARE & MAINTENANCE

CLEANING
Ensure the appliance is unplugged before cleaning.

• To clean the inside of the appliance, use a soft cloth and a solution of a tablespoon of baking soda to one quart of water or a mild soap solution or some mild detergent.
• Clean the outside with a soft, damp cloth and some mild detergent.
• It is important to keep the area where the lid seals against the cabinet clean to ensure a tight seal. Clean this area with a soapy cloth. Rinse with a damp cloth and let dry.
  Note: Do not use cleaners containing ammonia or alcohol on the appliance. Ammonia or alcohol can damage the appearance of the appliance. Never use any commercial or abrasive cleaners or sharp objects on any part of the appliance.

POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you minimize the number of times the lid is opened. If the power is going to be off for a longer period of time, take the proper steps to protect your contents.
Note: Wait 3 to 5 minutes before attempting to restart the refrigerator if operation has been interrupted.

ENERGY SAVING TIP
The appliance should be located in the coolest area of the room, away from heat producing appliances, and out of direct sunlight. Do not overload the unit or block any ventilation openings.

VACATION

• Short vacations: Leave the appliance operating during vacations of less than three weeks.
•  Lo n g vacations: If the appliance will not be used for several months, remove all items and turn off the appliance. Defrost, clean and dry the interior thoroughly. To prevent odor and mold growth, leave the lid open slightly, blocking it open it necessary.

MOVING

• Remove all items.
• Tape the lid shut.
• Be sure the appliance stays secure in the upright position during transportation. Also protect the outside of the appliance with a blanket or similar item.
• If the appliance is placed on its back or side during transportation, upon reaching the destination, allow it to remain in its operating position for 6 hours to avoid damage to internal components.

DISPOSAL

• This appliance may not be treated as regular household waste, it should be taken to the appropriate waste collection point tor recycling of electrical components. For information on local waste collection points, contact your local waste removal agency or government office.
• Disposal of this appliance should be in accordance with federal and local regulations.

FREQUENTLY ASKED QUESTIONS

• What are the standard wattage and amps used?
  This information can be found on the rating plate located on the back of the cabinet.

• How much does it cost to run the freezer?
  Please refer to the energy guide.

• Can I use an extension cord?
  No, an extension cord may not be used.

• I am having trouble opening the door or lid; why?
  The freezer door or lid may be difficult to open immediately after closing it. This is normal and is due to the pressure difference between the cold interior of the freezer and the warm air that has just entered the freezer when it was opened. The pressure will equalize within a few minutes.

TROUBLESHOOTING

• No power
  • A fuse may be blown or the circuit breaker tripped
  • Plug not fully inserted into the wall outlet
• Internal temperature not cold enough
  • Temperature settina is too warm
  • The door or lid is not shut properly or opened excessively
  • Recently added a large quantity of warm food to the cabinet
  • Close proximity to heat source or direct sunlight
  • Ambient temperature or humidity is very high
• Freezer runs continuously
  • Temperature setting is too cold
  • The door or lid is not shut properly or opened excessively
  • Recently added a large quantity of warm food to the cabinet
  • Close proximity to heat source or direct sunlight
  • Ambient temperature or humidity is very high
• Freezer makes a gurgling noise when operating
  This noise is completely normal. The refrigerant inside the appliance will make a gurgling noise as it changes from a liquid to a gas and back again.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>