COSTWAY FP10046US 18 Inch Electric Fireplace Freestanding User Manual
- June 5, 2024
- COSTWAY
Table of Contents
USER’S MANUAL
Electric Fireplace
FP10046US
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Please give us a chance to make it right and do better！
Contact our friendly customer service department for help first.
Replacements for missing or damaged parts will be shipped ASAP!
Follow Costway
Contact Us!
Do NOT return this item.
Contact our friendly customer service department for help first.
Before You Start
Please read all instructions carefully.
Retain instructions for future reference.
Separate and count all parts and hardware.
Read through each step carefully and follow the proper order.
We recommend that, where possible, all items are assembled near to the
area in which they will be placed in use, to avoid moving the product
unnecessarily once assembled.
Always place the product on a flat, steady and stable surface.
**** Keep all small parts and packaging materials for this product away from
babies and children as they potentially pose a serious choking hazard.
CONSUMER SAFETY INFORMATION
- Read this manual before installing and operating this appliance.
- Failure to follow these instructions may result in electric shock, fire, property damage or personal injury.
- Do not store or use gasoline or other flammable liquids in the vicinity of this appliance.
IMPORTANT SAFETY INFORMATION!
WARNING
-
ALWAYS keep electric cords, home furnishings, drapes, clothing, papers, or other combustibles at least 3 feet (0.9m) away from the front of this heater, and away from the
bottom, sides, and rear of this heater. -
DO NOT place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater.
-
DO NOT COVER this heater or block the air vents at all. Doing so could cause a fire.
-
AVOID fire or electric shock! NEVER insert or allow any foreign objects to enter the ventilation or exhaust openings of this heater.
-
Prevent Fire! Keep all flammable liquids, like gasoline or paint, away from this heater. This heater produces arcing sparks that could ignite flammable liquids.
-
DO NOT cover this heater in any manner. Doing so could block the airflow and cause the unit to overheat, or could ignite the material covering the heater.
-
NEVER run the power cord under the carpet, rugs, runners, or any other covering. Doing so could cause the cord or materials covering the cord to overheat.
-
AVOID FIRE! Regularly inspect all air vents to make sure they are free from dust, lint, or another blockage. Unplug the unit and clean with a vacuum ONLY. DO NOT rinse or get wet.
WARNING
- For residential use only! NOT for commercial use! NEVER use this fireplace for other than its intended purpose.
- Only use this insert with the mantel that came with the insert. NEVER use a mantel from another manufacturer.
- NEVER use this electric fireplace insert unless it is properly installed in the correct mantel.
- Use extreme caution if using this heater near children, or where children may be present.
- NEVER leave this heater unattended. ALWAYS unplug this heater when not in use.
- This heater is hot when in use. AVOID INJURY! DO NOT TOUCH hot surfaces, or attempt to move this heater while it is hot.
- ALWAYS turn this heater off before unplugging it from the outlet.
- AVOID INJURY! Keep the cord from crossing traffic areas to avoid tripping.
- NEVER modify this fireplace. Doing so could result in personal injury or property damage. Modification of this fireplace completely voids all warranties.
- Discontinue use if this fireplace malfunctions or is dropped or damaged in any manner.
WARNING
-
Risk of electric shock! DO NOT OPEN IT! No user-serviceable parts inside!
-
ALWAYS disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace.
-
ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.
-
NEVER use this heater in bathrooms, laundry rooms, or any other location where the heater could fall into a bathtub or pool, become damp or come in contact with water.
-
NEVER hang this unit on a wall directly below an electrical outlet.
-
NEVER operate this heater if the power cord or plug has become damaged, or if the grounding pin is damaged or missing.
-
Place the heater near a wall outlet so an extension cord is not needed. If an extension cord is needed, the gauge of the cord must be at least 14AWG, and the rating must be at least 1875 Watts. NEVER use a smaller gauge cord with a lower rating. Doing so may result in fire or electric shock.
-
ONLY use this heater on a 110-120 Volt 15 Amp grounded circuit. NEVER overload the circuit. If this heater trips the circuit breaker, unplug all other appliances on the same circuit before the next use. Avoid plugging other appliances into the same circuit as this heater.
-
NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or connections. Plugging this heater into a faulty outlet could result in electric arcing within the outlet that could cause the outlet to overheat or catch fire.
-
ALWAYS check your heater cord and plug connections with each use!
i) MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs can cause the outlet to overheat.
ii) Heaters draw more current than small appliances. Overheating may occur even if it has not occurred with the use of other appliances.
iii) During use check frequently to see if the plug outlet or faceplate is HOT!
iv) If the outlet or faceplate is HOT, discontinue use immediately and have a qualified electrician inspect and/or replace the faulty outlets.
-
The cord supplied with the heater has a plug with two blades (live and neutral) and one round pin (ground). If a 3-slot receptacle is not available, an adapter MUST be used. The adapter MUST be properly grounded to the outlet box (see figure at right).
PREPARATION
**** This insert has a front panel made of GLASS! ALWAYS use extreme caution
when .. handling glass. Failure to do so could result in personal injury or
property damage.
Remove all parts and hardware from the carton and place them on a clean, soft,
dry surface. Check the parts list to make sure nothing is missing. Dispose of
packaging materials properly. Please recycle whenever possible.
OPERATION
**** Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death.
Power
Make sure the ON/OFF switch, located on the control panel, is in the OFF
position. Plug the power cord into a 110-120 Volt 15 Amp grounded outlet (see
IMPORTANT SAFETY INFORMATION section). Make sure the outlet is in good
condition and that the plug is not loose. NEVER exceed the maximum amperage
for the circuit. DO NOT plug other appliances into the same circuit.
Thermostat
This heater is equipped with a Thermostat. Should the ambient temperature
exceeds or falls below the set temperature, the heater will automatically turn
OFF/ON.
Control Panel and Remote
Control panel/Remote control Operation
| BUTTON | FUNCTION | ACTION & INDICATION |
|---|---|---|
| 1. Press once to turn on the flame effect, fuel bed lights, and enable |
remote control functions.
2. Press again to turn off the flame effect, and shut off power to the remote
control, and all functions.| 1. Flame effect and fuel bed turn on. Remote
control functions are enabled.
2. Flame effect turns off. The remote control functions will not work.
| The DIMMER controls the brightness of the flame effect. Press the button to
set the flame effect to the desired level.| The flame effect cycles through
different levels and then returns to the first level.
- | HEATER button: Turn the heater on and off
NOTE: To prevent overheating, the heater fan will blow out cool air for 30 seconds after the heater is turned off.| 1. Press once. The indicator lights up. 750W heater turns on and blows warm air.
2. Press again. The indicator lights up. 1500W heater turns on and blows hot air.
3. Press again. The heater turns off.
| TIMER button: Control timer settings to turn off the fireplace at the selected time.| 1. Press once. An indicator light turns on.
The temperature is set to hours.
Press again until the desired setting is reached. The LED display shows the setting.
NOTICE
To improve operation, DO NOT press the buttons too quickly. Give the unit time
to respond to each command.
WARNING
NEVER leave the heater unattended during operation! Failure to do so could
result in personal injury or property damage.
NOTICE
When the heater is first turned on, a slight odor may be present. This is
normal and should not occur again unless the heater is not used for a long
period of time.
Remote Control Battery Information
- The small remote control uses one CR2025 battery(included)
NEVER dispose of batteries in a fire. Failure to observe this precaution may result in an explosion. Dis one of the batteries at our local hazardous material processing center.
CARE AND MAINTENANCE
ALWAYS turn the heater OFF and unplug the power cord from the outlet
before cleaning, performing maintenance, or moving this fireplace. Failure to
do so could result in electric shock, fire, or personal injury.
Cleaning
** NEVER immerse in water or spray with water. Doing so could result in
electric shock, fire, or personal injury.
Metal:**
-
Buff using a soft cloth, slightly dampened with a citrus oil-based product.
-
DO NOT use brass polish or household cleaners as these products will damage the metal trim.
Glass: -
Use a good quality glass cleaner and dry thoroughly with a paper towel or lint-free cloth.
-
NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.
Vents: -
Use a vacuum or duster to remove dust and dirt from the heater and vent areas.
-
Clean the exterior of the fireplace with a slightly damp cloth or duster.
Maintenance
**** Risk of electric shock! DO NOT OPEN IT! No user-serviceable parts
inside!
** ALWAYS turn the heater OFF and unplug the power cord from the outlet
before cleaning, performing maintenance, or moving this fireplace. Failure to
do so could result in electric shock, fire, or personal injury.
Electrical and Moving Parts:**
- The fan motors are lubricated at the factory and will not require lubrication.
- Electrical components are integrated into the fireplace and are not serviceable by the consumer.
Storage:
- Store heater in a clean dry place when not in use.
WARNING! No other servicing should be performed by the consumer. Do not attempt to service the unit yourself.
Installation and Assembly
-
Select a suitable location that is not susceptible to moisture.
-
Fix part A on the fireplace with 2 screws. (Fig A)
-
Fix the fireplace in the fireplace mantel by screws (Fig. B)
TROUBLESHOOTING
WARNING: Tum off the appliance, unplug, and let cool for at least 10 minutes before attempting to service. Only a qualified professional should attempt to service or repair the appliance.
| Problem | Possible Cause | Corrective Action |
|---|---|---|
| No flame | 1. Dimmer control button set too Low. |
2. LED bulbs are burned out.
3. “Flame wand” has come loose from the bracket.
4. “Flame wand” motor is not functioning.| 1. Push the Dimmer button to
increase light
2. Contact the technical
3. Remove the back panel. Secure end of” flame wand” back into the
support bracket.
4. Call our customer service.
The appliance turns off and will
not tum back on| I. The overheat protection device in the appliance has been
triggered.
2. House circuit breaker has been tripped| 1. Tum all controls off, unplug
the appliance, allow cooling for at least 10 minutes, then plug back in and
restart.
2. Reset house circuit breaker.
The appliance does not tum on when the button is pushed to
“ON”| 1. The overheat protection device in the appliance has been triggered.|
1. Tum all controls off, and unplug the appliance. Allow cooling for at least
10 minutes, then plug back in and restart.
The remote control does not work| 1 . Low batteries.
2. Manual control on the appliance must be “ON” before operating the remote
control.| I. Replace all batteries in the remote control
2. Push the appliance “ON” using the manual control panel, then use the
remote control to operate. If using the remote to control the appliance, you
must also press the “Power On” button on the remote control.
Welcome to visit our website and purchase our quality products!
With your inspiring rating, COSTWAY will be more consistent to offer you
EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE!
US office: Fontana, California
UK office: Ipswich
- Reward Points
- Exclusive Customer Service
- Personalized Recommendations
- Permanent Shopping Cart
- Order History
We would like to extend
our heartfelt thanks to all of our customers for taking the time to assemble
this product and giving us valuable feedback.
http://www.costway.com/hysalesrule/qr
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>