COSTWAY ES10150US Air Blower for Inflatables User Manual

COSTWAY ES10150US Air Blower for Inflatables User Manual

WARNING

1. The air blower, cord and plug must not be submerged in or exposed to water and liquids. If the power cord is damaged, please disuse the air pump. Do not use an extension cord with this blower.
2. To reduce the risk of fire or electric shock, do not use this blower with any solid-state speed control device.
3. Do not drop or strike the blower which may result in malfunction.
4. The air blower is not intended for use by persons(including children) with a physical, sensory or psychological disability or who lack experience and knowledge, unless they are supervised or have been instructed in how to use it by person responsible for their safety.
5. Children must be supervised to ensure that they do not play with the air blower.
6. Unplug the air blower when it is not in use and before cleaning it or performing maintenance

MAIN COMPONENTS

TECHNICAL DATA

MAINTENANCE OF AIR BLOWER

THE SOURCE OF ELECTRICAL SUPPLY MUST BE DISCONNECTED PRIOR TO ANY SERVICING OR CLEANING.

1. USE A DRY CLOTH TO GENTLY CLEAN ALL SURFACES.
2. STORE IN A COOL ,DRY PLACE AND OUT OF CHIDREN’S REACH.

Troubleshooting

1. Switch not turned on.
2. The circuit is opened or it is poor contact.
3. Electric capacity is damaged.
4. Choked up by hard objects

Motor runs but wheel makes a scraping noise|

1. Screws on the vaned wheel are loose.
2. Foreign objects in air-blower.

Motor is unable to run normally|

1. The voltage is unstable.
2. Motor is affected with damp.
3. Electric capacity is failure.
4. The impeller is loose.

ENVIRONMENTAL INFORMATION

Electrical and electronic equipment(EEE)contains material, components and substances that may be hazardous and harmful to human heath and environment if waste electrical and electronic equipment(WEEE)is not disposed of correctly. Products marked with a crossed-out wheeled bin are electrical and electronic equipment. The crossed-out wheeled bin indicates that waste electrical and electronic equipment must not be disposed of with unsorted household waste, but must be collected separately.

GROUNDING INSTRUCTIONS

This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.

WARNING – Improper installation of the grounding plug is able to result in a risk of electric shock. When repair or replacement of the cord or plug is required, do not connect the grounding wire to either flat blade terminal. The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire.

Substitution of the signal word “DANGER” for “WARNING” is not prohibited when the risk associated with the product is such that a situation exists which if not avoided will result in death or serious injury.

Check with a qualified electrician or serviceman when the grounding instructions are not completely understood, or when in doubt as to whether the product is properly grounded. Do not modify the plug provided; if it does not fit the outlet, have the proper outlet installed by a qualified electrician.

This product is for use on a nominal 120-V circuit, and has a grounding plug similar to the plug illustrated in sketch A in Figure 69.1. A temporary adapter similar to the adapter illustrated in sketches B and C may be used to connect this plug to a 2-pole receptacle as shown in sketch B when a properly grounded outlet is not available. The temporary adapter shall be used only until a properly grounded outlet (sketch A) is installed by a qualified electrician. The green colored rigid ear, lug, or similar part extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw
Figure 69.1 Grounding methods

Documents / Resources

| COSTWAY ES10150US Air Blower for Inflatables [pdf] User Manual
ES10150US Air Blower for Inflatables, ES10150US, ES10150US Air Blower, Air Blower, Air Blower for Inflatables
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>