Webasto T99 Telestart User Guide

June 5, 2024
Webasto

Webasto-T99-Telestart-logo

Webasto T99 Telestart

Webasto-T99-Telestart-prod

Operational features

  1.  LED
  2.  “OFF” button
  3.  “ON” buttonWebasto-T99-Telestart-fig-1

Buttons and control

Button            Control and function
ON                Switching on heater or ventilation
OFF              Switching off heater or ventilation
ON+OFF    To change operating time, see operating instructions, To change mode, see operating instructions

Switching on heater or ventilation

  • X Hold the hand-held transmitter with aerial vertical upward
  • X Press the ON button until the LED comes on (approx. 1 second). The Telstar receiver in the vehicle confirms that it has received the signal. See the table for an overview of the feedback signals. The LED goes out after:
    •  the operating time has elapsed
    •  pressing the OFF button.

Switching off heater or ventilation

  • X Hold the hand-held transmitter with aerial vertical upward.
  • X Press the OFF button until the LED comes on (approx. 1 second).
    The Telstar receiver confirms that it has received the signal. See the table for an overview of the feedback signals. Feedback from the hand-held transmitter when switching on and off

    The LED on the transmitter lights up for 2 seconds:

Red = Heating mode

Green = Ventilation* mode

|

The signal has been received and the heater/vehicle fan switched on or off.

The LED on the transmitter flashes for 4 seconds| Error during signal transmission. X Move to a different location, X repeat procedure.

  • If there are no special instructions on setting the vehicle heating system during parking heating operation the vehicle heating system must be set to “warm” before switching on the heater.
  •  Set the vehicle fan to the lowest setting (lower power consumption).

Restoring factory setting

X Press the ON and OFF buttons simultaneously for at least 10 seconds. Ignore color changes in the LED.
Factory setting:

  •  Mode: Heating
  •  Operating time: 30 minutes

Declaration of Conformity
CE-Declaration of Conformity and UKCA-Declaration of Conformity The Telstar T99 was developed, manufactured, tested, and supplied in accordance with the relevant directives, regulations, and standards for safety, EMC, and environmental compatibility. Webasto declares that the product Telestart T99 is manufactured and delivered in accordance with the directives and regulations.
The complete CE Declaration of Conformity and UKCA Declaration of Conformity can be found
in the download area at https://dealers.webasto.com

Important Information on Operating and Installation Instructions
Use of symbols and highlighting: Note on a special technical feature Important Information (not complete) Installation / Repair To install and repair control elements you need to have completed a Webasto training course and have the appropriate technical documentation, and special tools and special equipment. Installation and repair may ONLY be carried out by persons trained and certified in a Webasto training course. NEVER try to install or repair control elements if you have not completed a Webasto training course, you do not have the necessary technical skills and you do not have the technical documentation, tools, and equipment available to ensure that you can complete the installation and repair work properly. Only use genuine Webasto parts. See the Webasto air and water heaters accessories catalog for this purpose. Operation Do not operate the heater in closed rooms due to the danger of poisoning and suffocation. Always switch off the heater before refueling. Please note ALWAYS follow all Webasto installation and operating instructions and observe all warnings. To become familiar with and understand all functions and properties of the control element, the operating instructions must be read carefully and observed at all times. The operating instructions are available at www.webasto.com For proper, safe installation and repair work, the installation instructions with all warnings and safety information must be carefully read and observed at all times. Please always contact a workshop authorized by Webasto for all installation and repair work.

IMPORTANT

The instructions in this document are not complete and do not replace the detailed installation and operating instructions. You will find the general installation and operating instructions with all warnings and safety information at http://dealers.webasto.com. Webasto shall assume no liability for defects, damage and injuries resulting from a failure to observe the installation and operating instructions of the information contained in them. This liability exclusion particularly applies to improper installations and repairs, installations and repairs by untrained persons or in the case of a failure to use genuine spare parts. The liability due to culpable disregard to life, limb or health and due to damage or injuries caused by a willful or reckless breach of duty remain unaffected, as does the obligatory product liability.

7 Statutory regulations governing installation

IMPORTANT
Failure to follow the installation instructions will result in the invalidation of the type approval for the control element and therefore invalidation of the general homologation of the vehicle.
Disposal
Batteries and electronic devices are subject to the current versions of the European Directive 2006/66/EC or 2002/96/EC and must not be disposed of as household waste. Every consumer is therefore legally obligated to dispose of batteries and used/ scrap electronic devices in the marked recycling containers at a waste collection point or return to the retail trade. Return is free of charge. Dispose of packaging in corresponding recycling container in accordance with national regulations.
ATTENTION
Improper use can cause the batteries to leak, overheat or explode. When handling the battery, follow all instructions and warnings that are supplied with or printed on the battery. The battery is not rechargeable therefore never attempt to charge the battery. Never short-circuit the battery. Never expose the battery to high heat. Do not transport the battery together with metal objects, e.g. necklaces or hairpins. The risk of the battery leaking is greatest when the battery is discharged. To avoid damage to the hand-held transmitter you should remove the battery when it is discharged or if the hand-held transmitter will not be used for a prolonged period. If the liquid from a damaged battery comes in contact with clothing, the eyes or the skin, immediately flush the affected area with ample water. Dispose of the battery in accordance with locally applicable disposal regulations. Insulate the contacts with insulating tape. Keep new and used batteries out of the reach of children. Swallowing the battery can seriously damage your health. If a battery is swallowed immediately seek medical assistance. To extend the life of the battery, we recommend removing the battery from the hand-held trans – mitter if it is not to be used for a longer period of time.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals