BRESSER 8020115Qt5Qua My Time Bath Mini Instruction Manual
- June 5, 2024
- BRESSER
Table of Contents
BRESSER 8020115Qt5Qua My Time Bath Mini
OVERVIEW
This product is intended only for private use. The device is intended only for indoor use.
GENERAL WARNINGS
-
RISK OF CHOKING!
This product contains small parts that could be swallowed by children. There is a RISK OF CHOKING. -
RISK OF CHEMICAL BURN!
Leaking battery acid can lead to chemical burns. Avoid contact with battery acid on skin, eyes, and mucous membranes. In the event of contact, rinse the affected region immediately with a plenty of water and seek medical attention. -
RISK OF FIRE/EXPLOSION!
Do not expose the device to high temperatures. Use only the recommended batteries. Do not short-circuit the device or batteries, or throw them into a fire. Excessive heat or improper handling could trigger a short-circuit, a fire or an explosion. -
NOTE!
Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if necessary. Protect the device from severe shocks! The manufacturer is not liable for damage related to improperly installed batteries.
START-UP/POWER SUPPLY
- Remove the cover from the battery compartment (5).
- Insert a 1.5V AA/LR6 battery into the battery compartment (5). Pay attention to the correct polar direction (+ / – ) of the battery as indicated inside the battery compartment.
SETTING THE TIME
- After inserting the battery, the movement works (hands move).
- Turn the setting wheel (6) to set the correct time.
- Put the cover back on the battery compartment.
HUMIDITY INDICATOR
The humidity indicator displays the following conditions:
- WET
- Wet. Indoor humidity is between 66% and 100%
- COMFORT
- Comfortable. Indoor humidity is between 36% and 65%
- DRY
- Dry. Indoor humidity is between 0% and 35%
IMPORTANT!
Windows should be opened wide for a short time (a few minutes) for effective
ventilation. If possible, open windows on opposite sides of the apartment
(full ventilation).
MOUNTING/POSITIONING OF THE CLOCK
There are 2 ways to mount this clock on the wall or on a flat surface:
- Positioning on a table: Put the pins of the stand (4) into the holes in the housing’s backside. Position the clock on a flat surface (e.g. bathroom cabinet).
- Slightly moisten the suction cups (3) and press the clock with the suction cups against a flat wall surface.
CAUTION!
Always make sure to mount or stand the clock securely. Dropping the unit may
cause serious damage, for which the manufacturer takes no responsibility! The
suction cups must be placed on a perfectly flat, clean and dry surface.
Moisture favours slipping!
MAINTENANCE/CLEANING
Before cleaning the device, disconnect it from the power supply (remove the battery). Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid.
DISPOSAL
Dispose of the packaging materials properly, according to their types, such as
paper or cardboard. Contact your local waste disposal service or environmental
authority for information on the proper disposal. Do not dispose of electronic
devices in the household garbage! As per Directive 2002/96/EC of the European
Parliament on waste electrical and electronic equipment and its adaptation
into German law, used electronic devices must be collected separately and
recycled in an environmentally friendly manner.
EC DECLARATION OF CONFORMITY
Bresser GmbH has issued a “Declaration of Conformity” in accordance with applicable guidelines and corresponding standards. This can be viewed at any time upon request.
WARRANTY & SERVICE
The regular guarantee period is 2 years and begins on the day of purchase. To benefit from an extended voluntary guarantee period as stated on the gift box, registration on our website is required. You can consult the full guarantee terms as well as information on extending the guarantee period and details of our services at www.bresser.de/warranty_terms. Would you like detailed instructions for this product in a particular language? Then visit our website via the link below (QR code) for available versions. Alternatively, you can also send an email to manuals@bresser.de or leave a message at +49 (0) 28 72 – 80 74-220*. Please always state your name, precise address, a valid phone number, and email address, as well as the article number and name.
Bresser GmbH
Gutenbergstr. 2 · DE-46414 Rhede Germany
www.bresser.de ·
service@bresser.de
References
- Bresser | Startseite | Expand Your Horizon mit BRESSER
- index · powered by h5ai 0.26.1 (http://larsjung.de/h5ai/)
- Bresser | Social | Expand Your Horizon
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>