FURUNO TZT3 Hybrid Control 12 Inch Sounder – GPS Chartplotter Instructions
- June 5, 2024
- FURUNO
Table of Contents
FURUNO TZT3 Hybrid Control 12 Inch Sounder – GPS Chartplotter Instructions
TZT3 Factory Reset/Clear
Save all valuable user data prior to conducting a reset, such as; waypoints, routes, tracks and user settings. Instructions for saving user data can be found in chapter 8 of the Operator’s Manual, chapter 6 of the onboard eGuide.
From SERVICE Menu selection
-
Turn on the TZT12F/16F/19F and allow it to fully boot up normally.
-
Select “HOME” – “SETTINGS” – and “INITIAL SETUP”
-
Select “Service” and enter Password “FURUNO SERVICE”. Don’t forget the space and use all CAPS.
-
When Service menu boots up, you will need to hit CANCEL to bypass the factory touch pad and enter the service mode.
-
Once into the service menu, select “UTILITY”
-
Select “Factory Default.
-
When the reset menu appears, touch the pull-down arrow and select “Factory Default (Delete All
Settings) WARNING: You are about to clear the unit. Ensure you have backed up any desired user data!!
-
Hit the “RESET” selection
-
The system will ask you “Are you Sure”? You should select “OK”.
-
When the system says “delete succeeded”; select the “OK” button.
-
Select “EXIT”
-
. Select “POWER OFF” from the Service Man menu.
-
The unit is now ready to use and restore any settings or waypoint you wish to restore.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>