Bonsenkitchen CM8010 Coffee Maker Instruction Manual

Coffee Maker
Operation Instructions
Model: CM8010

www.bonsenkitchen.com

IMPORTANT SAFEGUARDS

When using electrical appliances. Basic safety precautions should always be followed including the following:

• Read all instructions.
• Make sure that your outlet voltage corresponds to the voltage stated on the rating label of the coffee maker.
• To protect against fire, electric shock, and injury to persons do not immerse cord, plug, or in water or other liquid.
• Close supervision is necessary when any appliance is used by or near children.
• Unplug from outlet when not in use and before cleaning. Allow cooling before putting on or taking off parts, and before cleaning the appliance.
• Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appliance to an authorized service facility for examination, repair, or adjustment.
• The use of accessories not recommended by the appliance manufacturer may result in fire, electric shock, or injury to persons.
• Do not use outdoors.
• Do not let the cord hang over the edge of the table or counter, or touch the hot surface.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Do not use appliances for other than intended use.
• Do not clean the carafe with cleansers, steel wool pads, or other abrasive material.
• To disconnect, turn any control to “Off”, and remove the plug from the wall outlet. Always hold the But never pull the cord.
• Scalding may occur if the cover is removed during the brewing cycles. Be careful not to get burned by the steam.
• Some parts of appliances are hot when operated, so do not touch them with a hand. Use handles or knobs only.
• Do not set a hot carafe on a hot or cold surface.
• Do not let the coffee maker operate without water.
• Do not use a cracked carafe or a carafe having a loose or weakened handle.
• Please do not open the top cover and make sure the glass carafe is placed on the thermal insulation plate correctly during the brewing.
• To reduce the risk of fire or electrical shock, do not remove the cover. No user-serviceable parts inside. Repair should be done by authorized service personnel only.
• The carafe is designed for use with this appliance. It must never be used on a range
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• This appliance is intended to be used in household and similar applications such as:
  – staff kitchen areas in shops, offices, and other working environments;
  – farm houses;
  – by clients in hotels, motels, and other residential type environments;
  – bed and breakfast type environments.

Household use only

Notes for cord plug:

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plugin anyway.

Notes for Power cord:

1. A short power-supply cord (or detachable power-supply cord) is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord.
2. Longer detachable power-supply cords or extension cords are available and may be used if care is exercised in their use.
3. If a long detachable power-supply cord or extension cord is used:

• The marked electrical rating of the detachable power-supply cord or extension cord should be at least as great as the electrical rating of the appliance;
• If the appliance is of the grounded type, the extension cord should be a grounding-type 3-wire cord;
• The longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over.

SAVE THESE INSTRUCTIONS

KNOW YOUR COFFEE MAKER

CONTROL PANEL

BEFORE THE FIRST USE

Check that all accessories are complete and the unit is not damaged. Fill water into the water tank to the MAX level and brew water several times without coffee powder, then discard the water. Clean and dry all detachable parts thoroughly according to the section “CLEANING AND MAINTENANCE”.

USING YOUR COFFEE MAKER

• Open the top cover and fill the water tank with drinking water. The water level should not exceed MAX level as indicated on the water level gauge.
• Place the funnel into the funnel support, and make sure it is assembled correctly, other­wise the top cover cannot be closed. Place a filter or paper filter in the funnel.
• Add coffee powder into the filter. Usually, a cup of coffee needs a level spoon of coffee powder, but you may adjust according to personal taste. Close the top cover
• Insert the glass carafe with the lid closed onto the thermal insulation plate horizontally.
• Plug the power cord into the outlet, the LCD display indicates “12:00” and it blinks.
• Rotate the knob to set the current clock. Turn the knob to the “HOUR” setting and then press the knob once, one hour can be increased. And the “HOUR” can be increased fast if hold and press the knob for more than 1.5 seconds.
• After setting the “HOUR”, turn the knob to the “MIN” setting and then press the knob once, one minute can be increased. And the “MINUTE” can be increased fast if hold and press the knob for more than 1.5 seconds.
• After finishing setting the current clock, press the knob once to confirm, then the clock starts to run.
• Rotate the knob to the “ON/OFF” setting, then press the knob once, the ON/OFF indicator illuminates in red, and the coffee maker starts to brew normal coffee. If you want to brew thick coffee, turn the knob to the “STRENGTH” setting, the “STRENGTH” indicator illuminates in orange, then turn the knob to the “ON/OFF” setting and press the knob once, the ON/OFF indicator will illuminate in red and the coffee maker will brew thick coffee.

Note: To cancel the “STRENGTH” setting, turn the knob to the “STRENGTH” setting and press the knob once.

• The brewing process can be interrupted by pressing the knob again at any time, and the ON/OFF indicator will extinguish, indicating your coffee maker is shut off.

Note: You can take out the carafe, pour and serve at any time. The appliance will stop dripping automatically. But the time cannot exceed 30 seconds.

• Remove out carafe to serve when finished brewing (about one minute later after the coffee stops dripping out.)

Note: The coffee you get will be less than the water you have added, as some water is absorbed by the coffee ground and adhere to the plastic.

• When the process is finished, if you do not want to serve immediately, keep the coffee maker energized, the coffee can be kept warm on the thermal insulation plate. And the appliance will shut off automatically after 120 minutes from the ON/OFF setting being activated if it has not been manually disconnected at the completion of brewing. For an optimum coffee taste, serve it just after brewing.
• Always turn the coffee maker off and disconnect the power supply when not used.

Note: Pay attention to pouring the coffee out, otherwise you may be hurt as the tempera­ture of coffee just finished is high.

DELAY FUNCTION

If you do not want the coffee maker to start operation immediately, for example now it is AM8:00, you hope that the coffee maker will automatically start working at PM1:00, first follow steps 1 to 5 of “USING YOUR COFFEE MAKER”, and then you can set the automatic start function as follows:

• Follow steps 6 to 7 of “USING YOUR COFFEE MAKER” and set the current time that is AM8:00.

Note: The time cycle is 12 hours.

• Turn the knob to the “PROGRESS” setting and then press the knob once, the ON/OFF indicator blinks in green, and the LCD display indicates AM”12:00″.
• Follow steps 6 to 7 of “USING YOUR COFFEE MAKER” and set the automatic start time that is PM1:00.
• After setting the automatic start time, turn the knob to the “PROGRESS” setting and press the knob once, the ON/OFF indicator illuminates in green solidly. After a while, the LCD display indicates the current time.

Note: You may cancel the automatic start function by turning the knob to the “PROGRESS” setting and pressing the knob once. If you want to change the automatic start time, only follow the above steps 2-3 again.

• When the time is due, the ON/OFF indicator will illuminate in red and the appliance starts brewing. When the process is finished, if you do not want to serve immediately,

k eep the coffee maker energized, the coffee can be kept warm on the warming plate. And the appliance will shut off automatically after 120 minutes from the ON/OFF setting being activated if it has not been manually disconnected at the completion of brewing. For an optimum coffee taste, serve it just after brewing.

Note: During the delayed brewing process, the settings of “HOUR” and “MINUTE” are invalid.

CLEANING AND MAINTENANCE

CAUTION: Be sure to unplug this appliance before cleaning. To protect against electrical shock, do not immerse the cord, plug, or unit in water or liquid. After each use, always make sure the plug is first removed from the wall outlet.

• Clean all detachable parts after each use in hot sudsy water.
• Wipe the exterior surface of the unit with a soft, damp cloth to remove stains.
• Water droplets may build up in the above area of the funnel and drip onto the product base during brewing. To control the dripping, wipe off the area with a clean, dry cloth after each use.
• Use a damp cloth to gently wipe the thermal insulation plate. Never use abrasive cleaner to clean it.
• Replace all parts and keep them for the next use.

REMOVING MINERAL DEPOSITS

To keep your coffee maker operating efficiently, periodically you should clean away the mineral deposits left by the water according to the water quality in your area and the use frequency, we recommend removing mineral deposits as follows:

• Fill the water tank with water and descaler to the max level as indicated on the water level gauge (the scale of water and descaler is 4:1, the detail refers to the instruction of the descaler. Please use “household descaler”, you may also use the citric acid instead of the descaler (the one hundred parts of water and three parts of citric acid).
• Insert the glass carafe onto the warming plate.
• Make ensure the filter (without coffee powder) and funnel are assembled in place.
• Turn on the appliance and allow it to “brew” a de-scaling solution by following the operation
• After “brewing” one-cup solution, switch off the appliance.
• Leave the solution stay for 15 minutes and repeat steps 3-5.
• Turn on the appliance and run off the solution until the water tank is completely empty.
• Rinse by operating the appliance with water at least 3 times.

HINTS FOR GREAT-TASTING COFFEE

• A clean coffee maker is essential for making great-tasting coffee. Regularly clean the coffee maker as specified in the “CLEANING AND MAINTENANCE” section. Always use fresh, cold water in the coffee maker.
• Store unused coffee powder in a cool, dry place. After opening a package of coffee powder, reseal it tightly and store it in a refrigerator to maintain its freshness.
• For an optimum coffee taste, buy whole coffee beans and finely grind them just before brewing.
• Do not reuse coffee powder since this will greatly reduce the coffee’ flavor. Reheat­ing coffee is not recommended as coffee is at its peak flavor immediately after
• Clean the coffee maker when over-extraction causes oiliness. Small oil droplets on the surface of brewed, black coffee are due to the extraction of oil from the coffee
• Oiliness may occur more frequently if heavily roasted coffees are used.

Register your product at www.bonsenkitchen.com to get more perks!

Follow us @bonsenkitchen

BONSEN ELECTRONICS INC.
: 5805C Peachtree Corners East Norcross, GA,30092
:1-888-965-8032
: support@bonsenkitchen.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>