BASETech 2348566 Automatic Soap Dispenser Instruction Manual

June 5, 2024
BASETech

Operating Instructions
Automatic Soap Dispenser, White
Item No. 2348566

Intended use

The product is a battery-powered automatic soap dispenser. It is intended for indoor use only. Contact with moisture must be avoided under all circumstances. For safety and approval purposes, you must not rebuild and/ or modify this product. If you use the product for purposes other than those described above, the product may be damaged. In addition, improper use can result in other hazards. Read the instructions carefully and store them in a safe place.  Make this product available to third parties only together with its operating instructions. This product complies with the statutory national and European requirements. All company names and product names are trademarks of their respective owners. All rights reserved.

Delivery content

  • Product
  • Operating instructions

http://www.conrad.com/downloads

Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code shown. Follow the instructions on the website.

Explanation of symbols
The symbol with the exclamation mark in the triangle is used to indicate important information in these operating instructions. Always read this information carefully.

Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

 General information

  • The device is not a toy. Keep it out of the reach of children and pets.

  • Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.

  • Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, steam, and solvents.

  • If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. The safe operation can no longer be guaranteed if the product:
    – is visibly damaged,
    – is no longer working properly,
    – has been stored for extended periods in poor ambient conditions or
    – has been subjected to any serious transport-related stresses.

  • Please handle the product carefully. Jolts, impacts, or a fall even from a low height can damage the product.

  • Consult an expert when in doubt about the operation, safety, or connection of the appliance.

  • Maintenance, modifications, and repairs must only be completed by a technician or an authorized repair center.

  • If you have questions that remain unanswered by these operating instructions, contact our technical support service or other technical personnel.

b) (Rechargeable) batteries

  • Correct polarity must be observed while inserting the (rechargeable) batteries.
  • The (rechargeable) batteries should be removed from the device if it is not used for a long period of time to avoid damage through leaking. Leaking or damaged (rechargeable) batteries might cause acid burns when in contact with skin, therefore use suitable protective gloves to handle corrupted (rechargeable) batteries.
  • (Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable) batteries lying around, as there is a risk, that children or pets swallow them.
  • All (rechargeable) batteries should be replaced at the same time. Mixing old and new (rechargeable) batteries in the device can lead to (rechargeable) battery leakage and device damage.
  • (Rechargeable) batteries must not be dismantled, shortcircuited, or thrown into the fire. Never recharge non-rechargeable batteries. There is a risk of explosion!

Operation

Note

  • Do not place the dispenser above a mirrored surface or close to running water as this can unintentionally trigger the sensor.
  • Make sure no bright light is aimed at or reflected towards the sensor.
  • Do not install in areas where the product can get covered or splashed by water.
  • Keep away from direct sunlight.
  • Insert 4x AAA batteries matching polarities as shown inside the compartment.
  • Unscrew the container from the pump and fill it with liquid soap.
  • Place your hands under the sensor to dispense soap.
    → After refilling the soap, you may need to act

Care and cleaning

  • Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can cause damage to the housing and malfunction.
  • Clean the product with a dry, fiber-free cloth. Lightly moisten the cloth if needed

Disposal

a) Product
Electronic devices are recyclable waste and must not be disposed of in the household waste. At the end of its service life, dispose of the product in accordance with applicable regulatory guidelines.
Remove any inserted (rechargeable) batteries and dispose of them separately from the product.
b) (Rechargeable) batteries
You as the end-user are required by law (Battery Ordinance) to return all used (rechargeable) batteries. Disposing of them in household waste is prohibited.
Contaminated (rechargeable) batteries are labeled with this symbol to indicate that disposal in domestic waste is forbidden. The designations for the heavy metals involved are Cd = Cadmium, Hg = Mercury, and Pb = Lead (name on (rechargeable) batteries, e.g. below the trash icon on the left). Used (rechargeable) batteries can be returned to collection points in your municipality, our stores, or wherever (rechargeable) batteries are sold.
You thus fulfill your statutory obligations and contribute to the protection of the environment.

Technical data

Power supply ……………………….. 4x AAA 1.5 V batteries
Activations …………………………… approx.3000 dispenses
(full batteries
Soap type ……………………………. soap (not foam)
Capacity ………………………………. 340 ml
Sensing distance ………………….. 2 – 8 cm
Operating conditions ……………… +10 to +40 ºC, ≤85 % RH (non-condensing)
Storage conditions ………………… -10 to +50 ºC, ≤85 %
RH (non-condensing)
Dimensions (L x W x H) …………. 88 x 108 x 200 mm
Weight ………………………………… 170 g

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems requires prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represents the technical status at the time of printing.

Copyright 2021 by Conrad Electronic SE.
*2348566_v2_0321_02_dh_m_en

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals