Shenzhen Meskey Technology W58 4-in-1 Wireless Charger Instructions
- June 5, 2024
- Shenzhen Meskey Technology
Table of Contents
Shenzhen Meskey Technology W58 4-in-1 Wireless Charger
Product introduction
This four-in-one Wireless charger isS an exquisite charging support, which can charge three devices wirelessly with one wireless charger.When charging your phone, Watch, Pencil AirPods Pro or other TWS Bluetooth headset cases, you can automatically charge them wirelessly by placing them in the appropriate charging area, which will make your desktop cleaner and your charging more convenient. Ihis product is designed to save space and help you integrate your smartphone smart life, There is safety protection technology in charging process, charging is safer, 15W high power, charging efficiency greatly increased.
Product appearance
Introduction to bracket
Directions for use
- Please connect the wireless charger to the adapter of 5V/2A-3A,9V/2A-3A, 12V/2A via Type-C fast charging line And power on;
- Put the phone in the charging area to charge it;
- Put the original watch in the watch position and install it to charge the watch;
- Put the wireless bluetooth headset case on it to charge.
- Insert the capacitance pen into the corresponding charging position to charge the capacitive pen;
- The mobile phone charging bracket can be folded
LED state
Support models
For devices with Qi standard wireless charging function.
Note:
To ensure the safety and efficiency of charging three devices at the same
time, it is recommended to use adapters and fast charging lines above 9V/2A.
For example, when the power of mobile phone fast charging reaches 15W, you
must use adapters and fast charging lines of 9V/3A or 12V/2A.(If you use an
adapter less than 5V/2A, the charger may not be able to charge all four
devices at the same time)
Watch charging installation
Points for attention
Place the device supporting wireless charging in the wireless charging area, and the green indicator will light up to proceed wireless charging. If it cannot be charged normally, please adjust the position of the device until the device shows normal charging or the green light will light up (please refer to the product description icon and place location). When the blue light flashes, the wireless charger detects foreign matter or inputs if the voltage is too high and It is in a protected state, please take care to remove the foreign body or replace the power adapter
Product Parameters
- Name: 4 In 1 Wireless Charger
- Input :5V3A, 9V=3A, 12V2A(Max)
- Size:16713123.1mm
- Transmission distance (mobile phone charging):s5 mm
- Conversion rate (mobile phone charging).270%
- Output: 15W/10W/7-5W/5W
- Watch output: 3W(Max)
- TWS earphone output: 2W(Max)
- Pencil Output: 2W (Max)
Packing list
- 4 In 1 VWireless Charger x1
- Data line x1
- Instruction x1
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.