SEALEY YKSG20 Hydraulic Floor Press Instruction Manual
- June 5, 2024
- SEALEY
Table of Contents
SEALEY YKSG20 Hydraulic Floor Press
Thank you for purchasing a Sealey Jack. Manufactured to a high standard this product will if used according to these instructions and properly maintained, give you years of trouble-free performance.
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS JACK CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO so
MAY CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY.
RETAIN THESE INSTRUCTIONS FOR
FUTURE USE.
SAFETY INSTRUCTIONS
-
Regularly check guard for worn, loose, or damaged parts. If you find any of these conditions DO NOT USE THE GUARD.
Failure to do so may cause severe injury! -
Keep the guard free of dirt and debris.
-
DO NOT add to or modify any part of the guard. Doing so will void your warranty.
-
DO NOT use the guard for purposes other than those it was designed for.
-
Clean guard with water and mild detergent.
-
Always refer to the safety instructions provided in your floor press instruction manual.
WARNING! The warnings, cautions, and instructions referred to in this manual cannot cover all possible conditions and situations that may occur. It must be understood that common sense and caution are factors that cannot be built into this product but must be applied by the operator.
DESCRIPTION & SPECIFICATION
Lightweight aluminum frame with tough steel mesh. The adjustable guard
protects the user and/or passerby from being injured if the workpiece is
accidently dislodged under load. Bolts onto either side of the table and
features five height increments, allowing the workpiece to be placed onto the
table with no obstruction. One-way spring-loaded locking clips then allow the
guard to be pulled up quickly and snap straight into position for full
protection.
ASSEMBLY/ OPERATION
Choose which side of the floor press to fit the guard, and fix the guard
support brackets to the table using the
pre-drilled holes and fixings provided. See Fig.182. Ensure the brackets are
fitted with the locks on the outside and the
correct way up as Fig.1.
Take the guard and slide it into the brackets from above; the guard has a stop
on either side at the top of the frame, this should be uppermost and facing
towards the operator (Fig.3).
Pull the locks back on either side and lower the guard all the way down.
CAUTION! The guard will drop freely until it reaches the stops
To raise the guard to one of the five height increments, pull up the guard and the spring-loaded locking clips will snap into position at the desired height.
NOTE: It is our policy to continually improve products and as such, we
reserve the right to alter data, specifications and component parts without
prior notice. IMPORTANT: No liability is accepted for incorrect use of this
product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will
be required for any claim.
INFORMATION: For a copy of our latest catalog and promotions call us on
01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park, Bury St. Edmunds, Suffolk,
IP32 7AR
Phone: 01284 757500
Web: www.sealey.co.uk
Email: sales@sealey.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>