AUDIORANGE OTE 1000 Wireless TV Headphones User Guide
- June 5, 2024
- AUDIORANGE
Table of Contents
AudioRange OTE 1000
Wireless TV Headphones
Easy Setup Guide
Important Safety Instructions
Please read these safety instructions carefully before using your the
Audiorange OTE-1000
WARNING: Consult your doctor or physician if you have a pacemaker before
using This device is intended for home and personal use only.
- Keep the device dry and away from water. Water may damage the device.
- Do not open the unit or battery. Opening the battery compartment violates this product’s warranty.
- The Wireless TV Speakers use a lithium-ion battery. Do not burn or place used batteries/devices in household trash.
- Do not pull on the cord to unplug this device, doing so may damage the cord.
- The device should not be used if damaged or malfunctioning.
- Make sure the device is unplugged when cleaning.
- Consult your doctor or physician when using this device around medical equipment such as a pacemaker.
Set-up Preparations
Plug AC adapter into dock and place headphones on the dock to begin charging.
A blue LED will flash as the headphones charge.
Allow up to 2 hours to charge.
| If you are using RCA connections please start with STEP 1a.
---|---
| if you are using the 3.5mm headphone connection please start with STEP 1a.
| If you are using an Optical connection please start with STEP 1b.
Installation using ANALOG Outputs
STEP 1a:
Turn on the TV.
There are two options for using the 3.5mm/RCA cable depending on your TV’s
connections.
Option 1: Plug the red/white RCA cables into the matching ports on the TV.
Then plug the 3.5mm in-line jack into the dock.
Option 2: Plug the 3.5mm in-line jack into the TV. Then plug the red/white RCA
cables into the matching ports on the dock.
STEP 2a
On the side of the dock, there is a switch for ANALOG or DIGITAL.
Slide the switch to ANALOG.
STEP 3a
Remove headphones from the dock and hold the power button for 3 seconds to
turn the headphones on.
After 3-7 seconds you should begin to hear audio.
STEP 4a
You have successfully set up your Audio range OTE-1000.
If you cannot hear any sound:
- Increase the volume on your headphone
- Increase the volume on the TV
- Check that your TV’s audio settings are set to an external speaker
IMPORTANT: If you cannot access your TV’s audio settings, please refer to your TV manual for help.
Installation using DIGITAL Outputs
STEP 1b
Turn on the TV.
Plug the optical cable into the TV and dock.
Remove plastic protective tips at the ends of the cord.
STEP 2b
On the side of the dock, there is a switch for ANALOG or DIGITAL.
Slide the switch to DIGITAL.
STEP 3b
Remove headphones from the dock and hold the power button for 3 seconds to
turn the headphones on.
After 3-7 seconds you should begin to hear audio.
STEP 4b
You have successfully set up your Audio range OTE-1000.
If you cannot hear any sound:
- Increase the volume on your headphone
- Increase the volume on the TV
- Check that your TV’s audio settings are set to an external speaker
IMPORTANT: If you cannot access your TV’s audio settings, please refer to
your
TV manual for help.