AUDIORANGE ITE-1000 Wireless TV Listening System User Guide
- June 5, 2024
- AUDIORANGE
Table of Contents
AUDIORANGE ITE-1000 Wireless TV Listening System User Guide
Important Safety Instructions
Please read these safety instructions carefully before using your the Audiorange ITE-1000
WARNING: Consult your doctor or physician if you have a pacemaker before using
- This device is intended for home and personal use only.
- Keep the device dry and away from water. Water may damage the device.
- Keep headset and accessories out of reach of pets and children.
- The headset uses a lithium ion battery. Do not burn or place used batteries/device in household trash.
- Do not pull on cord to unplug this device, doing so may damage the cord.
- Device should not be used if damaged or malfunctioning.
- Make sure device is unplugged when cleaning.
- Consult your doctor or physician when using this device around medical equipment such as a pacemaker.
TIP: This device can caused fatigue with prolonged use. If fatigue occurs, headset can be worn behind the head with headset body resting on your neck.
Set-up Preparations
Plug AC adapter into transmitter and place headphones on dock. The charge light on the front of the headset will indicate charge status. Allow up to 2 hours to charge.
Locate Audio Connections on the back or side of your TV.
If you are using RCA connections please start with STEP 1a.
If you are using the 3.5mm headphone connection please start with STEP 1a.
If you are using Optical connection please start with STEP 1b.
Installation using ANALOG Outputs
STEP 1a:
Turn on TV
Option 1 : Plug the red/white RCA cables into the matching ports on the TV. Then plug the 3.5mm in-line jack into the dock.
Option 2 : Plug 3.5mm in-line jack into Audio Out port on TV. Then plug 3.5mm in-line\ jack into the dock.
Once the desired connection is made, proceed to STEP 2
Installation using DIGITAL Outputs
STEP 1b:
Turn on TV.
Plug the optical cable* into the TV and dock.
*Remove plastic protective tips at ends of cord.
Once the Optical Cable is\ plugged in, proceed to STEP 2
STEP 2
Turn on dock by sliding the switch, located on the back of the dock, into the mono or stereo position
STEP 3
Remove the headphones from the dock. Press and hold the power button until the power indicator light turns on.
Once the headset is on, proceed to Step 4.
STEP 4
You have successfully setup your Audiorange ITE-1000.
If you cannot hear any sound:
- Increase the volume on your headphone
- Increase the volume on the TV
- Check that your TV’s audio settings are set to external speaker
IMPORTANT: If you cannot access your TV’s audio settings, please refer to your TV manual for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>