KLARSTEIN 10007544 IVC-50 Wet-Dry Vacuum Cleaner Instruction Manual

IVC-50
Wet/dry vacuum cleaner
10007544
www.klarstein.com

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damage. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

https://use.berlin/10007544

TECHNICAL DATA

SAFETY INSTRUCTIONS

• Children over the age of 8 and persons with reduced physical, sensory or mental capabilities or those with a lack of experience and knowledge may only use the device if they are instructed on how to do so by a person responsible for their safety, or if they are supervised and understand the hazards associated with the use of the device.
• Before use, check the voltage on the device badge. Connect the device only to sockets that correspond to the voltage of the device.
• Do not vacuum near flammable or explosive materials as these may be ignited by the motor.
• Do not obstruct the air intake as heat accumulation may damage the motor.
• Do not vacuum flammable or explosive materials such as burning cigarettes or gasoline. Do not suck up any sharp objects that may stick to the filter or clog it. Do not absorb powdery materials such as lime powder, gypsum, or graphite powder, which could damage the engine.
• Do not turn the unit over as water may enter the motor.
• Switch off the appliance after each use and before cleaning and disconnect it from the main supply.
• Keep the unit away from direct sunlight or intense heat as this may deform the plastic.
• To avoid damage, do not twist or step on the suction hose.
• Do not allow water to run on or into the cover during cleaning as this may damage the electrical components.
• Only use the product as described in the instructions. Any other use may result in damage to the product or personal injury.
• Modification or alteration of the product may affect product safety.
• Handle the product with care. It can be damaged by shocks, blows, or falling from a low height.
• Keep the product away from moisture and extreme heat.
• Repairs to the device should only be carried out by an authorized specialist workshop. Do not open the unit under any circumstances. Incorrect assembly may result in malfunction or total failure.
• The unit should be protected from all moisture and direct sunlight.
•  Do not clean the unit with cleaning agents. Use a dry or slightly damp (microfiber) cloth for cleaning.

Note: If water escapes from the air outlet, do not tilt the unit as this will damage the motor. Do not use the unit as a pump, as this may damage the motor.

PRODUCT OVERVIEW

OPERATION

Assembling and Disassembling

Insert the hose connector into the air inlet mouth as the picture shows to make sure the connector is tightly fastened. Press the connector button as the picture shows and pull the connector out when want to pull the hose connector from the machine.

Insert the hose connector into the blowing mouth when you want to use its blowing function. Connect all the accessories as the picture shows.

Getting Started

Insert the plug into the supply socket. Press the switch button, the machine begin to work. You can adjust the airflow by pushing the sliding block up and down.

Operation of blower

• Always wear safety goggles before using the blower.
• Keep bystanders clear from blowing debris.
• Wear a dust mask if blowing creates dust that might be inhaled.

1

| Make sure that the power cord is disconnected from the socket.
---|---

2

| Unscrew the inserted hose assembly from the suction port with a left-hand rotation.

3

| Insert the main cannula of the hose assembly into the air outlet on the top of the head and tighten it with the right-hand rotation.

4

| Insert the power cord.

5

| Start the switch button.

6

| Hold the hose assembly, let the outlet port aimed at the leaves, and so on.

Using the Accessory

Wet floor nozzle for the floor,  carpet, etc.| Bristle for Windows,  table, etc.| Crevice nozzle for a crevice, corner, etc.| Blowing mouth for blowing the dust away in the crevice of the machine.

CLEANING AND CARE

Barrel Cleaning
After working or when the barrel is full of dust which causes suction to decrease considerably, you should cut off the electricity and clean the dust away from the barrel.

•  Unfasten the locking knob, and lift up the top cover.
• Take off the filter bag, and clean the dust away in the dust barrel.
• Install the filter bag back and place the top cover.

Cleaning the HEPA filter
The HEPA filter should be washed with clean, warm water if it is covered with dust. If necessary, use a mild detergent.

• Remove the HEPA filter.
• Wash it.
• Let it dry.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Berlin Brands Group UK Ltd
PO Box 1145
Oxford, OX1 9UW
United Kingdom

References

• Klarstein | Your home. Your kitchen. Your style.
• Take-e-way GmbH | take-e-back | Elektroschrott Rücknahmesystem Onlinehandel

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>