Klarstein 2G Ice Cube Maker User Manual

Klarstein 2G Ice Cube Maker

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damages. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

TECHNICAL DATA

SAFETY INSTRUCTIONS

•  Check that the mains voltage corresponds to the rating of the appliance before operating.
•  Use handles or knobs when moving. Place on a flat stable surface for use. Do not use outdoors.
•  Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid.
•  Unplug from socket outlet when not in use.
•  To protect against electric shock, do not immerse cord or plug in water or any other liquid.
•  The use of accessory attachments not recommended by the appliance manufacturer, may cause injury.
•  Do not locate this appliance immediately below a socket outlet.
•  Do not allow cord to overhang the counter top where it can be easily pulled by children.
•  Do not overfill as this may cause a hazard. Ensure lid is closed when in operation.
•  To remove plug from outlet, do not pull on supply cord. Grasp plug firmly and pull to remove.
•  Do not use this appliance for anything else other than its intended use. No liability can be accepted for any damage caused by non-compliance with these instructions or any other improper use or mishandling.
•  This appliance is for household use only.
•  This appliance is not intended to be operated by means of an external timer or separate remote control system.
•  This appliance is not intended to be immersed in water.
•  If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
•  Please according to local regulations regarding disposal of the appliance for its flammable blowing gas.
•  Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
•  Fill with potable water only.
•  This device may be only used by children 8 years old or older and persons with limited physical, sensory and mental capabilities and / or lack of experience and knowledge, provided that they have been instructed in use of the device by a responsible person who understands the associated risks.

This appliance contains the coolant isobutane (R600a),a natural gas whichis environmentally friendly. Although it is flammable, it does not damage theozone layer and does not increase the greenhouse effect. The use of this coolant has,however,led to a slight increase in the noise level of the appliance. In addition to the noise of the compressor,you might be able to hear the coolant flowing around the system. This is unavoidable and does not have any adverse effect on the performance of the appliance. Care must be taken during the transportation and setting up of the appliance that no parts of the cooling system are damaged. Leaking coolant can damage the eyes.

WARNING
Danger from fi re/flammable materials. Please observe the local regulations for the disposal of units with fl ammable refrigerants and gases.

•  Keep ventilation openings in the unit housing free of obstacles.
•  Do not damage the refrigerant circuit.
•  Do not use any mechanical devices or other means to accelerate the defrosting process or the ice recovery process.
•  Do not use other types of electrical appliances inside the ice cube machine.

Special Notes

•  When positioning the unit, make sure that the power cord is not pinched or damaged.
•  Make sure that there are no multiple sockets or power supplies on the back of the unit.

To avoid contamination of food, please follow the instructions below:

•  Regularly clean surfaces that may come into contact with food. Clean the water drain regularly.
•  If the appliance contains a water tank, clean it if it has not been used for 48 hours. Rinse the tank if no water has been removed for 5 days.

WARNING
When using, servicing and disposing of the unit, pay attention to the left symbol on the rear of the unit or on the compressor. This symbol warns of possible fi res. There are fl ammable substances in the refrigerant lines and in the compressor. Keep the appliance away from sources of fi re during use, maintenance and disposal.

DEVICE OVERVIEW

1. Logo
2.  Water reservoir
3.  Logo
4.  Filter
5.  Air outlet
6.  Drain plug
7. Top lid
8. Infrared light-emitting diode
9.  Viewing window
10.  Infrared light-receiving diode
11.  Ice tray
12.  Ice basket
13.  Ice shovel
14.  Ice scoop
15.  Evaporator
16.  Control panel
17.  MAX water level

CONTROL PANEL, BUTTONS AND INDICATORS

Ice making (indicator):

The indicator flashes in black when making ice.

****| Water reservoir empty (indicator):

The indicator lights in black when there is a lack of water in the water reservoir.

|

Ice basket full (indicator):

The indicator lights in black when the ice basket is full.

|

Troubleshooting indicator

The indicator lights up in case of a malfuction.

Timer off (indicator)

|

Timer on (indicator)

|

Timer (indicator)

|

Time display

| Small ice cubes (indicator):

When small ice cubes are selected, the indicator lights

up black.

| Medium ice cubes (indicator):

When medium ice cubes are selected, the indicator

lights up black.

| Large ice cubes (indicator):

When large ice cubes are selected, the indicator lights

up black.

|

Timer setting (button)

|

Timer confirmation (button)

|

Size selection (button):

Select the desired ice cube size (large, medium, small).

|

ON/OFF (buttton):

Start or stop the appliance with this button.

INSTALLATION

1.  Remove the appliance from the packaging and make sure that all accessories (incl. ice basket and ice spoon) are included. Contact the costumer service if any accessories are missing.
2.  Make sure that the appliance is level and placed on a stable table or work surface to avoid malfunctions.
3.  The incline angle of the ice cube maker cabinet should not exceed 45° during transportation or use. Do not turn the appliance upside down as this could damage the compressor or the cooling system. After moving or transporting the appliance, leave it unused for some time to allow the liquids in the compressor to settle. Wait at least 2 hours before using the appliance for the first time and after you have placed it in the appropriate location and aligned it correctly.
4.  Place the appliance in an adequately ventilated place on a dry and level surface. Do not use the appliance near heat sources such as stoves, heaters or corrosive gases. Keep a minimum distance of 20 cm to all sides of the ice cube maker to ensure proper ventilation.
5.  Do not fill the water reservoir with hot water as this may damage the appliance. It is best to fill the water reservoir with water that is at room temperature or cooler.
6.  Do not use the appliance at a very cold environment (lower than 5 °C).
7.  Clean the appliance before use (see section “Cleaning and Maintenance“).

COMMISSIONING AND OPERATION

1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice cube maker into the wall outlet, the ice making indicator solidly.
3.  Open the top lid and remove the ice basket.
4.  Fill the water reservoir with drinking water.
5.  Replace the ice basket and close the top lid.
6.  Press the ON/OFF button and the ice making indicator blinks.
7.  The ice-making cycle will last approximately 7-15 minutes, depending on the ambient temperature and water temperature.
8.  The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator. Over the next 7-15 minutes ice forms on the evaporator. Once this has completed, the ice tray will tilt backwards and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel.The ice tray will automatically move back into position under the evaporator and start the next cycle.
9.  The ice basket full indicator will light up when the ice basket is full and the ice  cube maker will stop the ice-making cycle automatically. Gently remove the ice from the ice basket with the ice scoop. About 5 seconds later, the ice cube maker will restart its ice making function automatically.
10. The water reservoir empty indicator will light up when the water reservoir is lack of water and the ice-making cycle will stop automatically. At that time, remove the ice basket and add water to the water reservoir, and then press the ON/OFF .
11.  When you have got your desired amount of ice, stop the ice making cycle by pressing the ON/OFF button
12.  Open the top lid and transfer the ice to a freezer.
13.  Allow the ice cube maker to reach room temperature.
14.  Suggest replacing the water at least once a week. Please empty the water reservoir if the ice cube maker is not used for a long time.

CLEANING AND MAINTENANCE

To keep your ice tasting fresh and your ice cube maker looking great, we recommend cleaning your ice cube maker once per week.

1.  Stop the ice-making cycle by pressing the ON/OFF button cube maker from the wall outlet and allow it to warm up to room temperature.

2.  If residual water is found in the ice tray, gently push the ice tray back so that all water drains into the water reservoir.

3.  Move the appliance forward to a position 75 mm away from the working table and open the drain plug to drain out excess water (see below figures).

4.  Hold and press the ice size selection button and the timer setting button
   for 3.5 seconds within 5 seconds after plug in. Then three beeps can be heard and the appliance enters into the cleaning mode. At that time, the indicators for the ice cube size large  , medium  , small and the ice basket full indicator blink in sequence, and the pump will start to pump water and keep running for 15 minutes, and it will enter into standby condition after running for 15 minutes, finally, open the drain plug and empty the water.

5. clean the ice cube maker interior with a soft cloth soaked with warm water and vinegar, then rinse with clean water and then drain all the water.

6.  Replace the drain plug well in position. Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.

7.  Clean the exterior of the ice cube maker with a soft damp cloth. Use a mild dishwashing soap, if necessary.

8.  Please empty the water reservoir and dry it for storage if the ice cube maker is not used for a long time.

TROUBLESHOOTING

The water reservoir empty indicator lights up.

| Low water level or no water in the water reservoir.| Stop making ice, refill water and then press the ON/ OFF button to restart the ice- making cycle.
The water screen at the bottom of the water reservoir is blocked.| Clean the water reservoir.
Pump malfunction| Contact the costumer service.

The ice basket full indicator lights up.

| Ice basket is full and the infrared light is blocked by the ice.| Remove the ice from ice basket.
The Infrared light-emitting diode and the light-receiving diode do not work.| Remove dirt from the diodes and restart the appliance.
Contact the costumer service if the diodes still do not work after cleaning and restarting.

The troubleshooting indicator lights up.

| The ice tray is not in the right position.| Check if the ice tray is blocked.
Unplug the mains plug from the socket. Plug it back in and restart the appliance.
The ice collects together.| Making ice takes too much time.| Stoppen Sie die Eiswürfel- herstellung. Warten Sie, bis das Eis geschmolzen ist, bevor Sie die Eiswürfel- herstellung fortsetzen.
The water temperature in the water reservoir is too low.| Fill the water reservoir with water that has a temperature between 8 °C and 25 °C.
Problem| Possible cause| Suggested solution
---|---|---
The ice-making cycle seems normal but no ice is produced.| The ambient temperature or water temperature is too high.| Use the appliance at an ambient temperature between 10 °C and 32 °C and fill the water reservoir with some cold water.
The refrigerant system is leaking.| Contact the costumer service.
The refrigerant system is blocked.| Contact the costumer service.
Poor ice cube quality| Poor heat dissipation.| Leave a clearance of at least

20 cm to all sides of the ice cube maker for proper ventilation.

The water temperature is too high.| Fill the water reservoir with water that has a temperature between 8 °C and 25 °C.
The ambient temperature is too high.| Use the appliance at an ambient temperature between 10 °C and 32 °C.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>