KLARSTEIN 10034654 WINDSPIEL Air Cooler Instruction Manual
- June 5, 2024
- Klarstein
Table of Contents
WINDSPIEL
Air Cooler
10034654
Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following hints to avoid damages. Any failure caused by ignoring the items and cautions mentioned in the instruction manual are not covered by our warranty and any liability. Scan the QR code to get access to the latest user manual and other information about the product.
TECHNICAL DATA
Item number | 10034654 |
---|---|
Power supply | 220-240 V ~ 50 Hz |
Power rating | 100 W |
SAFETY INSTRUCTIONS
- Check the voltage on the rating plate before use. Only connect the appliance to sockets which correspond to the voltage of the appliance.
- Keep the appliance and cable away from sources of heat, sharp objects or anything that may cause damage.
- Do not place the cord under carpets. Do not cover the cord with small clothes, shirts or other similar elements. Place the cord away from traffic areas in order to avoid any risk of tripping over.
- Do not operate the appliance if the cable or plug is damaged.
- If the supply cord or plug is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Indoor use only.
- Do not cover the machine during using.
- Place the appliance on a stable flat horizontal surface. Make sure the appliance is in an upright position during use.
- Ensure the appliance is switched OFF before connecting to the mains power supply.
- Always ensure that hands are dry before operating or adjusting any switch on the product or touching the plug and mains supply connections.
- Do not leave this appliance unattended when it’s in use. Turn off and disconnect the appliance when you leave the room for an extended period.
- Switch off the appliance and unplug from the mains socket when not in use, before filling, cleaning or other maintain.
- To disconnect the appliance, switch it “OFF”, and then remove the plug from outlet. Do not pull the cord to disconnect the plug.
- This device may be only used by children 8 years old or older and persons with limited physical, sensory and mental capabilities and / or lack of experience and knowledge, provided that they have been instructed in use of the device by a responsible person who understands the associated risks.
- Use the appliance only as described in this manual.
- Do not insert your fingers in the openings of the guard.
- Do not leave hair, tissue, tablecloths, clothes or curtains near all openings of the fan, they could be sucked into the fan and be taken within the internal moving parts that could cause injury or damage.
- Do not use the appliance in wet or damp locations such as bathrooms.
- Do not operate the appliance when it’s not mounted on its wheels or if it’s lying on the side.
- Make sure the cord is completely extended before use.
- When in operation, evaporative coolers moisturize the ambient air. Over humidification of residential rooms should be avoided. Recommendation: 40-50 % relative humidity. Excessive humidity of the air can damage the home and cause health problems.
- The appliance may only be set up on water- and moisture-proof flooring materials (spilling some drops of water is unavoidable when the content of the tank is changed).
- With each and every change of tank content, completely remove residual water from the equipment. To prevent nucleation, remove residual water from the equipment and water tank every time after three days of use.
PRODUCT DESCRIPTION
Front view
1. castor
2. air vent
3. front panel
4. top cover
5. control panel
Side view
1. remote control
2. socket
3. power cord
4. filter net
5. water tank
GETTING STARTED AND USE
- Pull the unit outwards from the carton and place it on the floor.
- Check if the spare parts are complete, same as the spare parts list.
- lace the unit on the floor. take out the wheels to assemble.
- Follow up the direction, then add water.
Notes
- Make sure the power cord is disconnected,and then pull out the water tank.
- Water level must be between the MIN and MAX line.
- After some time operation dust and dirt may occour in water tank. It is recommended to change water and clean water tank frequently.
- Water shortage alarm, when the water level is lower than “MIN” level. Then the “Bi-Bi” alarm sound can be heard and the corresponding indicator light flickers. After adding water to the normal water level, the light is off. Then restart the cool function.
Control panel
Remote control
Symbol | Function | Description |
---|---|---|
ON OFF | In the standby, press this button, then the digital display screen |
show temperature, and the wind wheel motor at low speed wind start. If shut
down in the cool function, the water pump should be turn off approximately 15
minutes before the fan is turn off. This will allow the cooling pads to dry
out and extend their life
| SPEED| Press this button to select desired fan speed, (8 speeds). In turn.
The corresponding speed indicator light will be displayed. The motor delays 5
seconds for the first start.
| TIME| TIME: It can be set between 1 to 12 hours, with hourly incremental
intervals, When the digital display 12 hours, press this button again to
cancel and display‘0’ after flicking 5 seconds automatically display the
temperature:
| SWING right/left| Press once this button can auto left and right swing.
Press again this button to cancel.
| SWING high/down| Press once this button can auto up and down swing. Press
again this button to cancel.
| COOL| press this button to control the switch of cool function (first on,
second off).
| MODE| Press this key to switch between the functions of manual speed ,
natural and sleep.
TROUBLESHOOTING
Problems | Possible reasons | Solutions |
---|---|---|
The appliance does not work. | The plug is not securely inserted into the | |
socket or not connected well. | Insert the plug pin into the wall socket and |
make sure it is connected well.
The ON/OFF button is not pressed.| Press the ON/OFF button after being
plugged.
The cooling effect is not good.| Not enough water the water tank.| Add water
to ensure there is enough water for puming.
The water pump is blocked.| Clean the water tank and remove the impurities.
The air vent is blocked by dust.| Clean the dust or foreign objects from the
air vent.
CLEANING AND CARE
WARNING
Danger of electric shock
Always remove the plug from the socket-outlet and allow the fan blower to stop acting before cleaning it. Do not immerse the unit in water.
- After stopping cool, please keep it run for at least 1 hour to blow the honeycomb dry and avoid the mustiness..
- Clean the external surfaces of the unit with a soft damp (not dripping wet) cloth.
- Do not use any cleaning chemicals such as detergents and abrasives.
- Do not allow the interior (special for the PCB) to get wet as this could create a hazard.
- After extended periods of use, be sure to replace the water in the tank with fresh clean water at least weekly. Also remember to clean the filter by unscrewing the filter and removing the filter cradle. It should be cleaned in a mild soapy solution and then left to dry before replacing the filter.
DISPOSAL CONSIDERATIONS
If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.
This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.
MANUFACTURER & IMPORTER (UK)
Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>