KLARSTEIN 10032787 Norderney Convection Heater User Manual

KLARSTEIN 10032787 Norderney Convection Heater

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damages. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

TECHNICAL DATA

SAFETY INSTRUCTIONS

• Check that the voltage indicates on the data plate corresponds with that of the local network before connecting the appliance to the mains power supply.
• If the supply cord is damaged, it must be replaced by a qualifi ed engineer in order to avoid a hazard.
• The heater must not be positioned directly under the power socket.
• Keep furniture, curtains and other fl ammable material at least 1 meter away from the appliance.
• Keep out of reach of children and do not allow them to operate this appliance.
• This appliance is intended for household use only and should not be used for industrial purposes.
• Do not operate this appliance after a malfunction or after being damaged in any way.
• Repairs to electrical appliances should only be performed by a qualifi ed electrician.
• Improper repairs may place user at serious risk.
• Do not run the mains cable under carpets, rugs, etc.
• Do not allow the mains cable to hang over sharp edges or come in contact with hot surfaces.
• In order to avoid overheating, do not cover the heater.
• Do not use this heater with a programmer, timer, separate remote control system or any other device that switches the heater on automatically, since a fi re risk exists if the heater is covered or positioned incorrectly.
• Never immerse the product in water or any other liquid for any reasons.
• Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
• Do not use the appliance outdoors.
• Do not use if you have wet hands.
• Never use the appliance on or near hot surfaces.
• Do not operate with a damaged cord.
• Before cleaning the appliance, make sure it is unplugged from the power and that it is completely cooled.
• Do not clean the appliance with abrasive chemicals.
• Never use accessories that are not recommended or supplied by the manufacturer. It could cause danger to the user or damage to the appliance.
• This device may be only used by children 8 years old or older and persons with limited physical, sensory and mental capabilities and / or lack of experience and knowledge, provided that they have been instructed in use of the device by a responsible person who understands the associated risks.
• Children should be supervised to ensure that they do not play with the appliance.

CAUTION
Risk of burns! Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

PRODUCT DATA SHEET

only
Nominal heat output| Pnom| 1.0| kW|  | manual heat charge control, with integrated thermostat| N/A
Minimum heat output (indicative)| Pmin| 1.0| kW|  | manual heat charge control with room and/or outdoor temperature feedback| N/A
Maximum continuous heat output| Pmax,c| 1.0| kW|  | electronic heat charge control with room and/ or outdoor temperature feedback| N/A
Auxiliary electricity consumption|  | fan assisted heat output| N/A
At nominal heat output (fan motor)| elmax| N/A| kW|  | Type of heat output/room temperature control (select one)
At minimum heat output (fan motor)| elmin| N/A| kW|  | single stage heat output and no room temperature control| no
In standby mode| elSB| 0.00124| W|  | Two or more manual stages, no room temperature control| no
 |  | with mechanic thermostat room temperature control| no
 | with electronic room temperature control| no
 | electronic room temperature control plus day timer| no
 | electronic room temperature control plus week timer| yes
 | Other control options (multiple selections possible)
 | room temperature control, with presence detection| no
 | room temperature control, with open window detection| no
 | with distance control option| no
 | with adaptive start control| no
 | with working time limitation| no
 | with black bulb sensor| no
Contact details| Chal-Tec GmbH, Wallstraße 16, 10179, Berlin, Germany|
Model identifier(s):| 10032789, 10032790
---|---
Item| Symbol| Value| Unit|  | Item| Unit
Heat output|  | Type of heat input, for electric storage local space heaters only
Nominal heat output| Pnom| 2.0| kW|  | manual heat charge control, with integrated thermostat| N/A
Minimum heat output (indicative)| Pmin| 2.0| kW|  | manual heat charge control with room and/or outdoor temperature feedback| N/A
Maximum continuous heat output| Pmax,c| 2.0| kW|  | electronic heat charge control with room and/ or outdoor temperature feedback| N/A
Auxiliary electricity consumption|  | fan assisted heat output| N/A
At nominal heat output (fan motor)| elmax| N/A| kW|  | Type of heat output/room temperature control (select one)
At minimum heat output (fan motor)| elmin| N/A| kW|  | single stage heat output and no room temperature control| no
In standby mode| elSB| 0.00124| W|  | Two or more manual stages, no room temperature control| no
 |  | with mechanic thermostat room temperature control| no
 | with electronic room temperature control| no
 | electronic room temperature control plus day timer| no
 | electronic room temperature control plus week timer| yes
 | Other control options (multiple selections possible)
 | room temperature control, with presence detection| no
 | room temperature control, with open window detection| no
 | with distance control option| no
 | with adaptive start control| no
 | with working time limitation| no
 | with black bulb sensor| no
Contact details| Chal-Tec GmbH, Wallstraße 16, 10179, Berlin, Germany|

PRODUCT DESCRIPTION

1. Decoration glass
2. LCD screen
3. Operation board
4. Standing feet

DISPLAY

CONTROL PANEL

INSTALLATION

Free-standing installation

1. Put the product upside down on a soft cotton cloth or carpet.
2. Mount the stand in the corresponding location of the lower part of the product as shown above, and then fi x the randomly supplied screw at the bottom of the product with a screwdriver and tighten the screw.

Wall mount

1. Take out 4 brackets, 6 expansion screws and 6 screws out from the box, and fi x 2 brackets onto the wall according to the distances between holes of the bracket, as depicted in the picture below.
2. Fix 2 brackets onto the bottom of product, as depicted in the picture below.
3. Hold the side of the product, look at the position of the wall hole of the rear cover, and slide the wall to the top of the slot, that is, the installation of the wall is completed, as depicted in the picture below.

USE AND OPERATION

Switching the appliance on/off
Press the Standby key to exit the standby mode, the LCD display (2) shows current ambient temperature and set time (default 00:00). Press the standby key again to activate the standby mode.
Note: When pull out the plug, deletes the timer setting only and other function settings remain unchanged.
Choosing operation mode
This heater provides two diff erent operation modes:

• Free heating mode
•  Programmed weekly heating mode

Press the “PROG” key and use the up and down key to select the desired mode. Icon of the selected mode starts to fl ash on the LCD display (2). Confirm the selection with the “OK” key.

Free heating mode
Free heating mode provides three additional heating functions:

Note: When the ambient temperature is equal to the set temperature use the up and down keys to toggle between the Economy and Frost-free functions.

Programmed weekly heating mode

1. To enter the weekly heating mode press PROG and move the cursor over the clock icon at the bottom left-hand side of the LCD screen and press OK.
2. Now the cursor is flashing over the days of the week (left side of the menu).
3. Use the UP and DOWN arrows to choose your day to program 1 to 7.
4. Press the PROG key to confirm the day.
5. Use the OK arrows to select the heating function between Comfort, Economy and Frost-free. You will see the cursor on the right side of the menu scroll between the modes.
6. That is the fi rst 30-minute period selected and it moves on to the next 30-minute period.
7. Press the UP and DOWN arrow to choose the time.
8. Program each day of the week separately following the steps above.

Child lock function

1. To set the heater to a standby mode and apply the child lock function, simply hold the OK key and wait for 5 seconds. You will see the padlock image lock on the LCD screen.
2. To unlock, press the OK key for 5 seconds.

Setting time
To set the time press the TIME key, when the hour digits “12” starts to blink, use up and down keys to set the hour and confirm by pressing TIME key. Now minute digits “00” to blink, use up and down keys to set the minute and confirm the minute by pressing TIME key again.
Open window function

1. The heater is fitted with state-of-the-art energy-saving technology such as the open window function.
2. To activate this function, press and hold the TEMP button for 5 seconds. The window icon appears on the LCD screen.
3. When the open window icon appears, the heater will stop heating and window icon flashes, as long as the room temperature drops by 4 °C in 20 minutes. If want to heating and the open window function does not flash, please press and hold the TEMP button for 5 seconds.
4. To deactivate the function, press and hold the TEMP key for 5 seconds again,then the window icon will disappear.

CLEANING AND CARE

Note: Turn off the unit and unplug it from the power outlet. Wait until the unit has completely cooled down before cleaning it.

• Use a vacuum cleaner to clean the ventilation slots and grilles.
• Remove dust on the outside surfaces with a damp (not wet) cloth.
• Do not use strong cleaning agents or abrasives.
• Do not spray the device with liquids or immerse it in water or other liquids.
• Never open the heater housing.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Berlin Brands Group UK Ltd PO Box 1145, Oxford, OX1 9UW, United Kingdom

References

• Klarstein | Your home. Your kitchen. Your style.
• Take-e-way GmbH | take-e-back | Elektroschrott Rücknahmesystem Onlinehandel

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>