COSTWAY HW67236 Wall Mounted Full Screen Mirror User Manual
- June 5, 2024
- COSTWAY
Table of Contents
COSTWAY HW67236 Wall Mounted Full Screen Mirror User Manual
Jewelry Cabinet with Mirror
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
The first method: fix on the wall
BACK VIEW
Measure the distance between the hang holes on the back of the armoire. Use a pencil and a ruler to mark your measurements on the wall.
Use an electric drill to drill two screw holes. Insert D anchors and E screws into the holes.
Carefully hang the jewelry cabinet on the exposed screws.
The second method: Mounted over the door
Slide open the light box, remove the cover, and install 3 batteries in the compartment above the light box. Flip the power switch, then turn the inside LEDs on/off.
Guide of Manual
- Please read and follow this instruction and safety warning carefully. Use the product in accordance with the intended purpose.
- Please save the instruction for the future reference. When transferring the product to the third party, please hand on the instruction and safety warning as well.
- The contents in this instruction, including the texts and pictures, are as detailed as possible.
- For the purpose of summarizing, not all possible variations and installation methods are included in the instruction. During the assembly process, if you need further information, or has special difficulties, which are not included in the instruction, please contact us.
Notes
- The product is mainly used as a mirror and storage cabinet. The user must strictly assemble and use the product in accordance with the provisions of the manual. The seller does not assume any responsibility or liability with respect to any damage caused by incorrect assembly or improper use.
- Please check if the cabinet body is intact and if accessories are complete before mounting. Do not place the edge of the unwrapped cabinet on the floor to avoid any fray or damage.
- When mounting the wall cabinet, please make sure that the holes away from electrical wires or water pipes, in order to prevent unexpected damage or losses.
- Follow the assembly steps shown in the diagram to position and adjust the parts, then gradually tighten all screws(note: do not tighten excessively).
- The cabinet must be mounted on the wall or over the door with supplied or self-purchased accessories.
BATTERY INSTRUCTIONS: REQUIRES 3-AAA BATTERIES (NOT INCLUDED)
- Locate the battery pack panel on the top left corner inside of the jewelry cabinet.
- Slide the battery tab down to open.
- Place 3-AAA batteries as shown in Figure C.
- Slide to close the battery panel then turn on LED Light with the On/Off Switch.
- Please replace batteries as a simultaneous set.
Fig A. Locate Battery Pack
Fig B. Slide to open panel
Fig C. Place batteries as shown
US office: Fontana
UK office: Ipswich
DE office: FDS GmbH, Neuer Holtigbaum 36, 22143 Hamburg, Deutschland
FR office: Saint Vigor d’Ymonville
PL office: Gdansk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>