FENIX HT32 Outdoor Hunting Flashlight User Manual
- June 13, 2024
- FENIX
Table of Contents
FENIX HT32 Outdoor Hunting Flashlight
Product diagram
Graphical Diagram
WARNING
- Do place this flashlight out of the reach of children!
- Do NOT shine the flashlight directly into the eyes of anyone!
- Do NOT place light head near flammable objects, high temperatures can cause objects to overheat and become flammable/ignite!
- Do NOT use the flashlight in inappropriate ways such as holding the unit in your mouth, doing so could cause serious personal injury or death if the flashlight or internal battery fails!
- This flashlight will accumulate a significant amount of heat while operating, resulting in a high temperature of the flashlight shell. Pay close attention to avoid burns.
- Remove the battery from the flashlight to prevent accidental activation when the flashlight is placed in a closed-in and flammable environment such as pockets and backpacks!
- The LED of this flashlight is not replaceable; so the whole flashlight will need to be replaced when the LED reaches the end of its lifespan.
FENIX HT32 FLASHLIGHT
- 2500 lumens maximum output, 640 meters maximum beam distance.
- Uses one Luminus ST70 white light LED with a lifespan of 50,000 hours.
- Uses one Luminus SFT20 RA high-performance red light LED, which delivers a max output of 400 lumens and a max beam distance of 120 meters.
- Uses one Luminus SFT20 CG high-performance green light LED, which delivers a max output of 1400 lumens and a max beam distance of 210 meters.
- While the patented TIR Lens diameter has been reduced by 30%, its beam distance has been increased by an amazing 100%.
- Powered by one Fenix ARB-L21 series battery.
- Instant strobe.
- Dual tail switches for fast, single-handed operation.
- Made of durable A6061-T6 aluminum.
- Premium type HAIII hard-anodized anti-abrasive finish.
- Size: 6.30″×2.05″×1.00*/160 × 52 × 25.4 mm.
- Weight: 6.53 oz/185 g (excluding battery).
OPERATING INSTRUCTIONS
On/off
Tap the tactical switch to momentarily turn on the light, release it and the
light will go out. Fully press the tactical switch to constantly turn on the
light, fully press again to turn off the flashlight.
Output Selection
White Light mode: With the white light switched on, single click the
functional switch to cycle through Low-Med-High-Turbo.
TECHNICAL PARAMETERS
Note: The above specifications are the test results produced by Fenix
through its laboratory testing using the Fenix ARB-L21-5000U battery under the
temperature of 2143°C and humidity of 50% – 80%. The true performance of this
product may vary according to different working environments and the actual
battery used.
The Turbo output is measured in total of runtime including output at reduced
levels due to the built-in temperature protection mechanism.
Red/Green light mode: With the red/green light switched on, single click the
functional switch to cycle through Low High.
Mode switching
With the light switched on, press and hold the functional switch to cycle
through White Light mode Red Light mode Green Light mode.
Strobe
With the light switched off, press the functional switch to enter Strobe,
release it and the light will go out.
Intelligent Memory Circuit
The light memorizes the last selected output, excluding strobe. When turned on
again, the previously used output will be recalled
BATTERY SPECIFICATIONS
Type| Dimensions| Nvoomltaingael| Usability|
---|---|---|---|---
Fenix ARB- L 21-5000V2.0| 21700| 3.6V| Recommended| ✓✓
Fenix ARB- L21-5000U| 21700| 3.6V| Recommended|
Fenix ARB- L21-4000P| 21700| 36V| Recommended| ✓✓
Other types of Li-ion battery| 21700| 3.6V| Caution·|
21700 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Only using quality batteries with circuit protection will reduce the potential for combustion or explosion; cell damage or short circuiting are considered user induced damage and are not covered by any Fenix warranty or liability.
BATTERY REPLACEMENT
Unscrew the tail cap and insert the battery with the anode side (+) towards
the light head, then screw the tail cap back on.
INTELLIGENT OVERHEAT PROTECTION
The light will accumulate a lot of heat when used at high output levels for
extended periods. When the light reaches a temperature of 65°C/149°F or above,
the light will automatically step down a few lumens to reduce the temperature.
When the temperature drops below 65°C/149°F, it will then gradually return to
the standard output level.
LOW-VOLTAGE WARNING
When the voltage level drops below the preset level, the flashlight is
programmed to downshift to a lower brightness level until Low output is
reached. When this brightness level is reached (Low output), the light blinks
3 times every 5 minutes to remind users to recharge or replace the battery.
Note: This feature only works with a Fenix ARB-L21 series rechargeable
battery.
USAGE AND MAINTENANCE
-
Disassembling the sealed head can cause damage to the light and will void the warranty.
-
Fenix recommends using an excellent quality battery.
-
lf the light will not be used for an extended period, remove the battery. or the light could be damaged by electrolyte leakage or battery explosion.
-
Remove the battery to prevent accidental activation during storage or transportation.
-
Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
-
Periodic cleaning of the battery contacts improves the lamp’s performance as dirty contacts may cause the lamp to flicker, shine intermittently or even fail to illuminate for the following reasons:
-
A: Poor battery level.
Solution: Replace or recharge the battery (Ensure the battery is inserted according to the manufacturer’s specifications). -
B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
-
If the above methods don’t work, please contact your authorized distributor.
INCLUDED
Fenix HT32 flashlight, ARB L21-5000U battery, USB Type-C charging cable,
Lanyard, Holster, Spare O-ring,User manual, Warranty card
FACEBOOK 
WECHAT
“Follow” us for more information about Fenix.
FENIXLIGHT LIMITED
Tel: +86-755-29631163/83/93 Fax: +86-755-29631181
E-mail: info@fenixlight.com
Web: www.fenixlight.com
Address: 2F/3F, West of Building A, Xinghong Technology Park, 111 Shuiku Road,
Fenghuanggang Community, Xixiang Street, Bao’an District, Shenzhen City,
Guangdong
Province, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>