breo iDREAM3 Head Massager User Manual
- June 5, 2024
- Breo
Table of Contents
breo iDREAM3 Head Massager
Massager
Basic components
Function Deployment
Main unit and Remote
- LCD Display
- ON/Off Key
- Operating Buttons
- Air Discharge Button
- DC Power Interface
- Earphone Jack
- Power Switch Key
- Encoding Joint Operation Key
- Size Adjusting Knob
- Tightness Adjusting Knob
LCD Display:
From top to bottom: time/air pressure/hot compress/music
Operating Buttons:
Clockwise: Up key/Mode+/Down key/Mode-, DK key in the center
Power Switch Key:
It’s a must to push the Power Switch Key to be OFF after using.
Attention:
If there was problem of receiving signal between the main unit and remote. you
can perform encoding joint operation:
- Turn off the main unit and remote. press and hold 18) encoding operation key of the main unit, then turn on the main unit until the LED blue indicator that on front of the main unit flashing.
- Release (BJ encoding operation key of the main unit, synchronously press and hold O key of the remote and key @ for 2-3 seconds, the LCD display of the remote flashes, in the meantime, the blue LED indicator of the main unit turns off, which means it successes for the code verification. (The operation needs to be finished within 6 seconds)
- Turn off the main unit. When turn on the product again, the remote works.
Please make sure that one main unit is corresponding to one remote. The operation of encoding joint with multiply remote controller to one main unit is prohibited.
Preparation Before Use
- Please check the machine and accessories whether complete.
- Please check and make sure there is enough power.
- Please check and make sure there is no damage of the adaptor.
Operation
Charging The Unit
- Open 15) DC Power Interface, and insert the adaptor.
- During charging, the power indicator on the front of the main unit indicate red and keep flashing, when it fully charged, it indicates blue.
Attention:
- Keep the massager in off state while charging the main unit. Charging time is roughly 3-4 hours.
- The main unit doesn’t work while charging.
- If voltage of the battery is lower than 3.2± 0.1 V, the product will automatically power off. If LED indicator of the main unit flashes, and all functions shut down, please recharge the main unit.
Power on
- Remove the cover of the battery pack on back of the remote controller, place 3 pieces of AAA batteries with correct pole, and then replace the battery pack cover; (Picture1)
- The main unit of the product is powered by a high-performance environmental-friendly lithium battery.
How to wear
- Adjust the top and two sides to a proper state, and then to wear on the main unit.
- Meanwhile adjust the top to a proper distance to head.
-
Power On/Off
-
Power-on
- Push the power protection key on the main unit to Level “ON”
- Press and hold @ Button
- Preset air pressure+ hot compress for 15 minutes’ massage.
(Default air pressure: Circulation; Default hot compress: High temperature; Music: Bird music)
-
Power-off – Short press @ Button – Push [7] Power Switch Key on the main unit to Level “OFF” (picture 2)
If switchover of time, air pressure, music and hot compress mode is needed, please have it done by pressing the related functional keys manually.
Manual Mode
Short press A/V Button, choose function mode
- Short press O Button
- Short press + / – Button to choose
Time
- Short press A / V Button to select “Time “, short press O Button
- Short press + / – Button for time switchover among 15minutes/10 minutes/5 minutes
Air pressure
- Short press A / V Button to select “Air pressure”, short press O Button
- Short press + / – Button to selct five modes of air pressure (The default is circulation)
- Off/On, short press O Button
Heat
- Short press A / V Button to select “Hot press”, short press O Button
- Short press + / – Button: Low temperature/High temperature
- Off/On, short press O Button
Music
- Short press A / V Button to select “Music”, short press O Button
- Short press + Button to select Next
- Short press – Button to select previous
Precautions
- Do not use the product during driving.
- Prior to use, please remove any jewelry or object that may affect massage from the massage position.
- Do not use the product in bathroom or other damp environments.
- Keep the product away from water and fire sources and corrosive environments.
- Please observe safety regulations when using the product in specific environments.
- Do not use the product if the massage position has undergone operation.
- Do not use the product if the massage position has skin injury, redness and inflammation, congestion or other discomfort symptoms.
- Persons with heart disease or history of heart disease, or with acute disease, skin disease, malignant tumor or physical abnom,ality should not use the product.
- Persons with bleeding tendency or other blood diseases, or with osteoporosis, soft-tissue disorders or apoplexia should not use the product.
- Persons with slow action, psychosomatic disorders or disturbance of intelligence should not use the product; please follow the docto(s advice if any of these persons intends to use the product.
- Stop using the product in case of any discomfort during use.
- Women who are pregnant or in menstrual period should not use the massager.
- Children under six years of age are forbidden to use the product; children between 6-12 years of age must use the product under the guidance and care of their parents or other persons with supervision capability.
- Use alcohol cotton to clean the external appearance; avoid using water for cleaning.
- Do not use any sharp objects to scratch or stab the product.
- The product is an electronic wellness product for home use rather than a medical device. It is not intended for diagnosis, therapy or other commercial purposes.
- Use the charger supplied by our company to charge the product, and pay attention to electrical safety.
- Cut off power supply immediately in case of any abnormality during use. Do not attempt to disassemble or repair the product.
- The product has a heating surface; those who are insensitive to heat must take care.
Operation steps for battery removal
- Cut off the external power supply, and remove the product housing;
- Disconnect the power supply to the battery;
- Remove the battery;
- Place the waste battery at a fixed recycling station;
- Please observe local environmental protection laws and waste disposal guidelines and protect the environment.
Notes
Remove the battery out of the appliance before scrapping the appliance; The
appliance must be disconnected from power supply before removing the battery;
The battery should be disposed of safely.
Troubleshooting
If there is any problem when you use the device, please follow the
instructions below to check. Do not disassemble or repair the device yourself.
Technical parameters
Storage
- If 1he storage period exceeds 6 months, please check and recharge it.
- Do not store close to floor, wall or roof.
- Keep in good ventilation condition and away from direct sunshine and corrosive gases.
Shenzhen Breo Technology Co., LTD
19/F, Hisense Southern Building, No.1777 Chuangye Road, Yuehai Street, Nanshan
District, Shenzhen 518054, China
support@breocare.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>