JBL JL-LED1200C 1200W LED Fog Machine User Manual
- June 5, 2024
- JBL
Table of Contents
LED FOG MACHINE
User Manual
ZQ10016
Fashion, dazzling, high-quality
Attention:
Please obey all notices about the operation. Safety and repair to avoid getting an electric shock and keep the excellent effect.
- Keep clean
- Use indoor.
- The power must same as located.
- Power off before adding fogger liquid
- Put in the horizontal direction and don’t incline and place upside down
- Power off or pull out plug after use
- No waterproof, if there is some humidity, water, or fog liquid in it, please switch off the power and contact the distributor as soon as possible.
- There are no spare parts with machines. If you need to repair it, please contact the distributor or professional repair workers.
Avoid fire:
- Only adults operate. Equip it over the touch of children and pay more attention during operation.
- Don’t spray it on people directly and far-away fire.
- The temperature of smoke is very high so keep the space between machines and other material things more than 100cm. (surface temperature of the machine is 40-80 ℃ , don’t touch)
- Put the machine in a drafty place and don’t cover the cool holes to keep the best cool effect. Keep the space between the smoke machine and around things more than 0cm and between the smoke machine and tinder more than 20cm. And without easily burnt things within 300cm ( far away from the carpet, board & inflammable)
Avoid explode:
-
Don’t add tinder liquid such as oil, gas, perfume and etc. in the fog machine.
Pay more attention to all notices signs and operation instructions on all machines.
Please use the high-quality fog liquid recommended by distributors. Bad quality fog liquid may get blast or spray oil. -
Often check whether there has enough fog liquid.
-
Get out all fog liquid before transport or post.
-
Don’t eat fog liquid otherwise see the doctor immediately. Use clean water to wash skin and eyes once fog liquid touches them.
Remove package and check:
- Open the carton to check whether all necessary spare parts include according to the specification list. Please contact the distributor if there is something missed.
- Check the appearance of the machine and power line to see whether they have some obvious damage. Please contact the distributor once you find something and stop using the fog machine.
Installation:
- Take away all packing material, especially the spray mouth.
- Set in the horizontal direction and open the cover of the liquid can.
- Add high-quality fog liquid to the machine and screw the cover of the liquid can. Bad quality fog liquid will damage the fog machine
- Plug the plug of the remote console in the socket of the back of the machine.
Operation:
- Connect the power line to the power socket with the earth line. Turn the switch to “ On “ and the machine heat. The green LED of the line console will light once the machine finishes heat.
- Press the red key, and the machine will spray fog (Press it as long as you need).
- The red LED of the remote console light or not means the machine can spray fog or heat itself.
- Can set the machine at a high place (with a hanger) or on the ground. Do not spray fog to people directly and the lean angle should be less than 15
- Often check whether there has enough fog liquid in the machine. The operation will make big damage to the machine if there has no fog liquid.
- If the fog is small, the plum has noise or there has no fog, please power off and check the fog liquid, fuse, the connector of the remote console, and power plug. If the problem could not be solved after checking these parts, please stop checking and send it back to the distributor for repair.
Repair:
Please clean the fog machine timely to avoid the damage to spare parts and
decrease the repair charge.
- Don’t make the fog machine be dirty. Screw the cover of the liquid can after adding fog liquid.
- After about 40 hours of continual use, please use 80% distilled water and 20% vinegar to clean the dirty in the refractory pipe.
- Disassemble the spray mouth and use vinegar to clean it to keep expedite before the heat.
- Reequip the spray mouth after cooling and add fog liquid for the next use.
Technical parameter:
-
Voltage: □AC 220-240V 50-60Hz
-
Power: 1200W
-
Heat-up: 6min
-
tank capacity : 1L
-
AC 90-120V 50-60Hz
Light source: R.G.B
The power of the bulb : 6x3W
dimensions: 35×20 x17cm -
control mode: □wired remote control □Wireless control
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.