SMG-002A Remote Control Instructions
- June 5, 2024
- SMG
Table of Contents
SMG-002A Specification
- IC chip: Learning code 1527
- Working current: 8~10mA
- Frequency: 433.92mhz
- Working power: 10MW
- Working distance: 10-100meters(spacious)
- Static current: 0
- Battery voltage: 3.0V
- Modulation: ASK 9) ±200KHz
- Temperature Range: – 40 to + 85
Open your motor to get the receiver and find the programming button.
- Press and release the programming button
- Pressing and holding the button of our remote control for about 30second.
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause
undesired operation. Warning: Changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. Suppose this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on. In that case, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>