Alliance Laundry Systems 205328 Wireless Network Control User Manual

Alliance Laundry Systems 205328 Wireless Network Control

Overview

The Alliance Laundry System LLC 205328 is a Wireless Network Control to be factory installed into compliant Alliance Laundry Systems LLC washer and dryer models.
The 205328 Control is equipped with a 2.4 GHz IEEE 802.11b/g/n Wi-Fi module based on the Texas Instruments CC3230SF. The RF transmitter can be placed in a variety of modulated, unmodulated and frequency hopping modes for test purposes.

COMPLIANCE STATEMENTS

PRODUCT COMPLIANCE
Users of this product are cautioned not to make modifications or changes that are not approved by Alliance Laundry Systems,
LLC. Doing so may void the compliance of this product with applicable laws and regulatory requirements and may result in the
loss of the user’s authority to operate the equipment.

UNITED STATES
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the radio or television receiving antenna.
• Increase the separation between the computer equipment or receiver.
• Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
• Consult the dealer or experienced radio television technician for help.

CAUTION: To comply with the limits of the Class B device, pursuant to Part 15 of the FCC Rules, this device is to comply with Class B limits. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables is likely to result in interference and reception of the device. Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The radio installed in this equipment and is intended to operate with minimum distance 20cm between the radiator and your body.
Limited Channels Fixed – USA: IEEE 802.11b or 802.11g or 802.11n(HT20) operation of this product in the U.S. is firmware-limited to Channel 1 through 11.

CANADA (Canadian French)
CAN ICES-3(B)/NMB-3(B)
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s) standards. Operation is
subject to the following two conditions:

• This device may not cause interference.
• This device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure Statement

This equipment complies with Innovation, Science and Economic Development Canada’s radiation exposure limits set forth for in RSS-102. The radio installed in this equipment is installed and is intended to operate with minimum distance 20cm between the radiator and your body.
California Proposition 65 (The Safe Drinking Water and Toxic Enforcement Act, 1986) Canadian Prohibition of Certain Toxic Substances Act SOR/2012-285

EUROPE (Req’d Language)
Products bearing the CE mark comply with the following EU directives:

• EMC Directive 2014/30/EU
• Low Voltage Directive 2014/35/EU
• RoHS Directive 2011/65/EU and its amendment directives; Commission Delegated Directive 2015/863 to restrict four phthalates
• REACH Regulation 1907/2006 and its amendment regulations
• POP Regulation 850/2004 and its amendment regulations

If the product has telecommunications functionality, it also complies with the requirements of the following EU directive:

• Radio Equipment Directive 2014/53/EU

Compliance with these Directives implies conformity to harmonized European standards that are noted in the EU Declaration of Conformity which is available upon request.
Alliance Laundry Systems products comply with the requirement of Article 12 as it can be operated in at least one Member State as examined and the product is compliant with Article 11 as it has no restrictions on putting into service in all EU member states.
This device contains a 2.4GHz transceiver, intended for indoor use only in all EU member states, EFTA states, and Switzerland. Attention has been given to allowed operational frequencies. For detailed information concerning installations in France, the user should contact the national spectrum authority in France http://www.arcep.fr/
Be aware that outdoor installations require special attention and will only be handled by trained and qualified installation personnel. No one from the general-public is permitted to install wireless products outdoors when external antennas, power and grounding must be installed for use.

AUSTRALIA/NEW ZEALAND
The radio in this equipment complies with and is certified to the Australian and New Zealand ACMA AS/NZS 4268 regulatory requirements.

CHINA SRRC (Simplified Chinese)
The radio device has received certification of conformance in accordance with the People’s Republic of China State Radio Regulation Committee (SRRC) certification scheme. Integration of
this radio into a final product does not require additional radio certification provided installation instructions are followed. No changes are authorized to the radio or the antenna of the approved device.

JAPAN MIC (Japanese)
This product is equipped with a certified wireless device pursuant to Article 2-1-19 of the Certification Ordinance. No changes are authorized to the radio or the antenna of the approved device.
The radio device has received certification of conformance in accordance with the Radio Waves Act. Integration of this radio into a final product does not require additional radio certification provided installation instructions are followed. No changes are authorized to the radio or the antenna of the approved device.

According to “Administrative Regulations of Low Power Radio Waves Radiated Devices:
Article 12 The low-power radio-frequency devices must not be altered by changing the frequency, enhancing emission power, adding external antenna, and modification of original design characteristic as well as function.
Article 14 The operation of the low-power radio-frequency devices is subject to the conditions that no harmful interference is caused. The user must stop operating the device immediately should harmful interference is caused and shall not resume until the condition causing the harmful interference has been corrected. Moreover, the interference must be accepted that may be caused by the operation of authorized communications, or ISM equipment.
(1) Precautions (marked in the product manual and on outer packaging)
THAILAND NTC (Thai)
The radio is compliant and certified pursuant to the requirements of National Broadcasting and Telecommunication Commission.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>